When a 200 ohm resistor, a 300 microfarad capacitor (uF) that's initially uncharged, and a 6-volt battery are wired in a series formation, what is the starting current, measured in milliamps (mA)

In a simple RC circuit design, a resistor (1 MQ) and a capacitor (2 µF) are connected in series with a switch and a power supply of 20V as shown below. 3 of 7 AVT (a) (b) Figure 1: A simple RC circuit Determine the time constant (to), amount of time required for the charge on a charging capacitor to rise to 63% of its final value, of the RC-circuit and verify that (to) is consistent with your result. What is the maximum voltage and current that can be achieved at the steady state condition of the capacitor. Write down the specific time-dependent expressions for the relative charge (Q/Q.) development in the capacitor, the relative current flow (I/I,) and the relative potential difference (V/V) measured across the resistor (R) during the charging and discharging processes respectively. Sketch 3 separate graphs for the time development of the charge (Q) on the capacitor, current (I) and potential difference (V) across the resistor during the harging and discharging process in the series…

The internal resistance of a high voltage power supply is 4 MO and the output is set so that the potential difference across the output when on open circuit is 1800 V? A load resistor RL = 500 kn is connected across the supply. What is the current flowing in the load resistor?

A battery with an emf of 24 V and unknown internal resistance r is connected to a 6.0 W load resistor RL such that a current of 3.0 A flows through the load resistor. The output voltage of the battery (terminal voltage) is: