Answered: What is the value of line current in…

Engineering

Electrical Engineering

What is the value of line current in delta connected three phase system, when it is taking 0.577 A input phase current?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: What would be the same results of this quesiton if the circuit was single phase 1000v?

A: If True power is single phase i.e.,P1ϕ=10kWV1ϕ=1000VI1ϕ=12.33 A

Q: With neat diagrams explain how a three phase delta connection to be made with three windings and…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: 2. A three phase delta connected balanced resistive load is connected to a three phase delta…

A: For delta connected load line current =3×phase current power consumed=3*I2*R. Energy= power *time

Q: In single-phase a.c. supply, how many wires are used O a. one wires O b. Two wires O c. Four wires O…

A: In this question , we will see how many wires used in single phase ac system...

Q: How are freeze etching and electron cryotomography similar? How do they differ? What is the…

A: Given: The explanation are shown below:

Q: Two power system areas operating at a nominal frequency of 60 Hz are connected with a tie line, and…

A: Step-1->

Q: In matlab, To obtain voltage and current waveforms from transmission line which tool can be used O…

Q: What are Principle , features and applications of wattmeter.

A: As per Bartleby guidelines we are allowed to solve only one question, since these parts are…

Q: A Sketch the circuit diagram of a star connected three phase load and mention the line and phase…

Q: Q1 Drive the equation of unknown impedance for Hay Bridge

A: From the figure, consider that, Z1=R1-jωC1 Zx=Rx+jωLx Z2=R2 Z3=R3 Where Zx is an unknown impedance.…

Q: A three phase load is connected in delta to a three phase 440 V, 50 Hz mains. An inductor of 100 mH…

A: Solution: A three phase load is connected in delta, voltage V=440 v, f=50 Hz, Inductor L= 100mH…

Q: For a given rating, three phase machine is smaller in size compared to that of single phase. Select…

A: To identify the machine size

Q: -What are the reasons for using three phase system to generat and distribute electrical power.

A: In three-phase distribution, phase current is distributed in the phase of 120 degree due to which…

Q: ) Choose how to measure the R phase voltage in three phase star connected system? a. Between…

A: Phase voltage is measured between one phase and neutral

Q: Two power system areas operating at a nominal frequency of 60 Hz are connected with a tie line, and…

Q: Problem 3 Circuit Element 3 C =20 [µF] rad w =2000 + What is the magnitude of the impedance of this…

A: Here, we have given a circuit, where we can see that the circuit consists of a capacitor only. So,…

Q: What is the difference between load and delta?

A: Delta is a type of connection in which we connect the load or source on delta .

Q: What is a three phase balanced star connected load? Its phase power measurement and total supply…

Q: High-voltage transmission with lower power losses is possible with A. alternating current B. cross…

A: Given: High voltage transmission

Q: A generator having emf 7sint Volts is connected in series with 8 Ohm resistor and an inductor of 2…

Q: Single Phase and Three Phase Principles

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Design a three-phase system such that the phase current in the generator, lines and charging phase…

A: Given data: Phase voltage VP=1000 V(rms) Phase current Ip=10 A(rms) Power factor = 0.97 lagging…

Q: State two advantages of a three phase Ac supply over a single phase Ac supply

A: Single phase supply: The power is supplied through two wires called Phase and neutral and the…

Q: What is low power factor wattmeter and what is its use?

A: The instrument which measures the very low factor is known as the low power factor wattmeter (LPFW).…

Q: 5. Obtain the symmetrical components of a set of unbalanced currents I,-1.3225º, I,-0.86z180º and…

Q: . When a circuit is interrupted, the _______ returning to the source is also interrupted. A. rating…

A: It is asked to choose the correct answer from the given options.

Q: The three-phase power line given in the figure is fed from both ends. The rated voltage is 380 V.…

A: The above question is based on the DC distribution system.Conductivity = 56 mho/mm = 56 mho/mHence,…

Q: A 6- pole 3-phase I.M. is connected to 50 Hz supply. If its running at 970 r.p. m. find the slip

A: An AC motor is an electrical machine which takes AC electrical input energy and produces mechanical…

Q: If 3-phase transfomer configuration in figure in has the givens as listed below: E-line on high…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: How to avoid errors in the Measurement of 3- Phase Power Using Two-Wattmeter Method.

A: Measurement devices are used to measure electrical quantities. The true value and the measured value…

Q: For a voltage regulator circuit, the no load and full load voltages are 2500 V and 2122 V…

Q: How to measure the B phase voltage in three phase star connected system? a. Between B phase and R…

A: Phase voltage is the voltage between any line wire and neutral wire, so here the phase voltage of B…

Q: 1. With an elegant diagram, discuss the three-phase power measurement using the three-watt meter…

A: This is a very simple question based on measurement subject .In this we will understand how the…

Q: Can you help me provide recommendations to improve harmonics and flicker- in three phase power…

A: The harmonics in a system can be explained as the integral multiple of the fundamental frequency.…

Q: What is the significance of a three-phase power system, and how does it differ from a single-phase…

A: A three-phase power system is a crucial component of modern electrical distribution and transmission…

Q: The three phases of a generator can be connected in either delia (D) or wye (Y) connection. List two…

A: Advantages of three-phase system over a single-phase system: Greater power output: A three-phase…

Q: Question: Describe the functionality of the following buttons and LEDs on the front panel while…

A: An analog input or digital interface is used to remotely regulate the functioning of a programmable…

Q: In three phase power each voltage current and power is delivered by how many degrees..

A: Phase Phase is the difference between the starting position of the two sinusoidal waveform, so it…

Q: From the circuit below, determine secondary winding voltage Vsec if the primary winding voltage Vpri…

Q: Simple summary about the measurement of power in a 3 Phase AC circuit using a two-wattmeter.…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Concept explainers

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.

Question

What is the value of line current in delta connected
three phase system, when it is taking 0.577 A input
phase current?
a. 1.732 A
O b. 4.00 A
О с. ЗА
O d. 1 A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a three phase -four wire star connected system, the three outer wires are called as lines and the common wire in centre is called as to search hp
Two three-phase alternators operate in parallel. The rating of one machine is 50 MW and that of the other is 100 MW. Both alternators are fitted with governors having a droop of 4 per cent. How will the machines share a common load of 100 MW ?
2. The following information is given in connection with the two phase three wire circuit of the figure. EBA = 240 volts Load "NA" is an impedance of (10 +j6) Load "BN" is an impedance of (7-j12) Q Load "BA" takes a current of 14 A at a leading p.f. of 0.95 Calculate a). Current INA and IBN. b). Neutral current IN. c). Line circuits IA and IB. d). The total power. IB IN LOAD BN LOAD NA 0000 IA B IBN N INA IBA LOAD BA
For a star connected three phase AC circuit is associated with
1. Explain the advantages and disadvantages of Single Phase and Three Phase Power Supply. Justify why Three phase supply is preferred over Single Phase Supply
From the circuit below, determine secondary winding voltage Vsec if the primary winding voltage Vpri = 120Vrms? %3D Np:Ns 6:1 D. Vp 120 Vac 60 Hz Vout R = 200 Q O 20Vrms O 720Vrms O 120Vrms O Ovrms wi m
How does a three-phase power system differ from a single-phase power system, and what are their respective applications?
Question No.33 A single phase half bridge VSI has load R = 1.8 Q and DC source voltage 130 – 0 – 130 V. Find the power delivered to the load due to fundamental current.
The reference for phase measurement is the a. positive imaginary axis b. positive real axis c. negative imaginary axis O d. negative real axis
Explain the concept of three- phase power and its advantages over single phase power. please don't use Al answer
- Define Wye and Delta Connection in AC Motor - Define Three Phase AC Motor