find the voltage on primary side in pu.

Q: 3) G(s) = 30* s(s-0.1) (s+0.25) (s+0.5) (s+2)3

A:

Q: b) The net doping density. 3. A semiconductor has an intrinsic resistivity of 3x104 ohm-cm. Donor…

A:

Q: The power transmitted to the external load resistance of 10 ohms by the battery is maximum only if…

A: We need to select correct option for given statement .

Q: Find Va- 12 V (3) ΖΩ Μ ΖΩ 2· Va Va ΖΩ

A:

Q: Do the following meters exist? If they do, how do they function, how are they connected, do they…

A: In this question, 4 different types of meters are given along with their function. We need to find…

Q: 41. Calculate the clearing time of a 3 cycle duty power circuit breaker for a 138 kVolts, 60 Hz…

A: In this question,  We need to choose the correct option.  Determine the clearing time of a 3 cycle…

Q: The synchronous machine was operating stably at point-a as shown in the figure. Due to come…

A: Given- Inertia constant H=5 MJ/MVA, Supply frequency f=60 Hz, To Find- The oscillating frequency of…

Q: Vs 700 pF L m 0.10 mH 100 nF 560 pF

A:

Q: 3) Solve for the current i(t) in this RC circuit using Laplace transform. The switch is closed at…

A: We need to find out the current for given circuit by using of Laplace transform .

Q: Problem 1: A supply voltage has a mean value of 150V. Determine its maximum value and its RMS value.

A: Mean value = 150 V

Q: H.W 4: Calculate the error constants and determine ess for a unit step, ramp and parabolic functions…

A:

Q: Sketch a phasor representation of the three-phase system in equilibrium that contains both phase…

A: Given, The line voltages, Van=100∠45°

Q: A very lossy, long, 50 transmission line is open circuited at the load end. Find the input impedance…

A:

Q: A rectangular air-filled waveguide has cross-section of 4 cm x 10 cm. Find the minimum frequency…

A: Cross-section of rectangular air filled waveguide = 4 cm×10 cm a = 10 cm = 10×10-2 b = 4 cm

Q: The permanent magnetic magnetic field due to a hard magnet such as ferromagnetic iron is due to the…

A: The permanent magnetic magnetic field due to a hard magnet such as ferromagnetic iron is due to the…

Q: 3) Given multiplexor circuit shown. a) Fill in the K-map for the function (F) implemented. CD C AB…

A: Given multiplexer,

Q: Simplify circuit for simpler result. You can do the following problem in one of two ways, the long…

A:

Q: An aircraft is flying at a cruising speed of 0.07 mph at an altitude of 5.0 km where the atmospheric…

A:

Q: 6. Determine the inductor currents i₁ and i and the capacitor voltages v₁ and v₂ in the circuit…

A:

Q: E R₁ t = 0 + VI R₂ Figure 1: An RC circuit. C HH Consider the circuit shown in Figure 1, where E =…

A:

Q: In the circuit shown in Fig. 10, the switch has been closed for a long period of time. The switch…

A: Given a circuit with resistors, inductor  and switch Asked to find the current for t>0, also…

Q: Quality factor of the resonator is defined as the ratio between the wavelength of the emitted laser…

A:

Q: Plane z = 10 m carries surface charge density 20 nC/m². What is the electric filed at the origin?…

A: Given: Plane z = 10 m Carries surface charge density, ρs=20 nCm2

Q: 54) A certain crystal is operating at a frequency (fr). What will happen into its operating…

A: Characteristics of Crystal  Crystal thikness inversely proportional to frequency  Crystal…

Q: 1. Why continuous signal is to be converted in discrete domain? 2. What is the function of FOH…

A: The process by which continuous signal is converted in to discrete signal is called sampling. The…

Q: 1- Assume that a signal x(t) whose spectrum is shown in Fig.2. is sampled and the sampled signal is…

A: Given, The given spectrum,

Q: please answer in hand written i dont understand where i can put the exponent..

A:

Q: Plane x = 10 carries a current of 100mA/malong ā while line x = 1, y = -2 carries a filamentary…

A: It is given that: plane x=10 carries a current of 100 mAm along ayline x=1,y=-2 carries a…

Q: b) The capacity factor for a plant capacity of 2850 c) The reserved load. d) The reserved factor. e)…

A: The Capacity factor for a given plant capacity is defined as the ration between the average annual…

Q: 2. In the circuit below, assume R1=R2 = 1k0 and Rg = Rf = 10kQ Vcc= -VEE = 20V Vo a. Find the…

A:

Q: A parabolic dish antenna has a conical beam 20° wide, Find the directivity of the antenna.

A:

Q: The resistance of a conducting material depends upon O The area of cross section and the length of…

A: We need to determine the parameters on which the resistance of conducting material depends.

Q: R₁₁ R2 www 지 91

A:

Q: The armature of a d.c. The machine has a resistance of 0.25 ohm and is connected to a 300V supply.…

A: Given data, Voltage V=300 V Armature resistance Ra=0.25 Ω For generator:- Armature current Ia=100 A…

Q: 5. A 400 volts shunt generator has a full-load current of 200 A. Its armature resistance is 0.06…

A:

Q: The intrinsic carrier density at 300 K is 1.5 x 107 cm³, in silicon. For n-type silicon doped to…

A: Given Data:-n-type silicon dopedno=2.25*1015 atoms/cm3Intrensic Carrier density =ni=1.5*1010 /cm3

Q: Read the resistances and tolerance of the resistors shown below: Ans. Ans. Ans. Ans. Ans. Ans.…

A: Colour coading is a technique to calculate resistance value by observing the color bands. Two types…

Q: : Calculate the amount of information if binary digits occur with equal likelihood in binary PCM.

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Calculate maximums and minimums for Vs and Vo given the following circuit if Vin-110VRMS@60HZ,…

A: Given: A circuit of full wave rectifier along with a capacitor in parallel of load resistance.…

Q: A digital signal is to be designed to permit 100 Mbps for a bandwidth of 10 MHz. Determine: (1)…

A: A digital signal is to be designed to permit: Bit rate=100 Mbps  bandwidth =10 MHz. Calculation of:…

Q: Compute the expected digital output (in hexadecimal) for the ADC with 12-bit resolution, Vref = 1.8V…

A: It is given that: Vin=1.2 VVref=1.8 VN=12

Q: A series circuit of 2 pure elements has an applied voltage of 200 sin(100t + 30 deg.) volts. What is…

A:

Q: A circuit is shown to the right. a. Is this an example of positive feedback or negative feedback? b.…

A: Given: An Op-amp circuit. To find: a) Is this an example of positive feedback or negative feedback?…

Q: المطلبي (والجمع المسم والصور ) الديكارتي ( في الجمع والطرح ) Find the current in R of Figure 20-1…

A: According to superposition theorem, the response in any branch can be calculated by activating only…

Q: For the 555 timer square wave generator shown in the figure below if the duty cycle = 60% and…

A:

Q: 3. Explain the differences between self and separately- excited dc generators in terms of (a)…

A: Given: Explain the differences between self and separately-excited dc generators in terms of…

Q: 5. A 400 volts shunt generator has a full-l

A:

Q: Armature resistance of a 230V shunt motor is 0.6 0 and no load current is 5A. When the rotor is…

A: back emf of motor = terminal voltage - voltage drop in armature resistance. back EMF directly…

Q: Suppose an AC generator with V(t) = (150V)sin(100t) is connected to a series LCR circuit with R = 40…

A:

Q: Find Va 12 V | Μ ΖΩ ΖΩ 2· Va Va ΖΩ

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.