what is the functional difference between an accumulator and an ABS fluid accumulator

Q: The first diagram is wrong, line AB should be longer since its length is equal to 580mm than line…

A: Given: The length of AB=580 mm Length of P2B=360 mm. So the length of AB should be greater than the…

Q: A Carnot power cycle has a high temperature of 1500 K and a low temperature of 500 K. The pressure…

A:

Q: Given : STEADY STATE COMPRESSOR INLET PRESSURE: IN LET VOLUMETRIC AIR 15 lb f/in² FLOW RATE GOES…

A:

Q: 1. Determine the speed of block 'D' if end ‘A’ of the rope is pulled down with a speed of 3m/s.

A:

Q: The 15-kg uniform slender rod is suspended at rest when the force of F = 145 N is applied to its…

A: Given data:- length of the rod (L)=3 m mass of the rod (m) =15 kg force applied (F) =145 N Angle…

Q: Determine the distance ȳ to the centroid of the area.

A:

Q: (2) (3 STEAM P₁ = 40 BAR (AV)₁ = 70m ³ min (2 P₂ = P4 20 Bar T₁ = 500°C T2 400°C T3 = 500°C P3= 20…

A:

Q: Write a report on the Coriolis Effect that includes:

A: The Coriolis force, which is fictitious or inertial in physics, acts on moving objects within a…

Q: Q2. A compound shaft supports five pulleys that transmit different amount of torques as shown in…

A: Given: The torque at A, TA = 153 kNm The torque at B, TB = 1767 kN.m The torque at C, TC = 1394 kN.m…

Q: Determine the load in the pins A and C as well as the tensions on cables BD and EF for F = 1000 N.

A:

Q: A steady-state system for producing power consist of a pump, heat exchanger and a turbine. Water at…

A:

Q: A Fo the two trusses shown. D G B O H P I P E C A o Do Go P C F B OE OH

A: Conditions for zero force members are: If at joint only three members meet,out of which two are…

Q: 9. A pressure of 1.013×10 N/m² is applied to a volume of 15.0 m' of water. If the bulk modulus of…

A:

Q: BERNOULLI'S FORMULA P₁ + ½pV;² +pg²1 = P₂ + ½pV₂2² +pg%2 IS APPLICABLE TO: Bernoulli's formula ₁ +…

A: We have details written about bermullis equation

Q: Determine the speed of block 'A' if end B of the rope is pulled down with a speed of 1.5 m/s B A

A:

Q: A steady-state system for producing power consist of a pump, heat exchanger and a turbine. Water at…

A:

Q: A room 14 ft x 16 ft x 10 ft contains atmospheric air at 72°F. The partial pressure of the water…

A:

Q: Consider a conduction in a plane composite wall as shown. The outer hotter air temperature at 60 C…

A:

Q: What is the total current from the voltage source in Figure 6-64 for each switch position? Figure…

A: Given question is related to electrical circuits.

Q: The line of action of the 3250-lb force runs through the points A and B as shown in the figure…

A: Detailed explanation and solution of the above problem uploaded in below picture.

Q: *6-76. Determine the moment of inertia for the area about the x axis.

A:

Q: what is the speed ratio of v/U for part b?

A:

Q: k₁= 150 W/m-°C KB-30 kc=50 KD=70 Ag = Ap T=370°C 2.5 cm A B D C 7.5 cm 5.0 cm 4.=0.1 m² T=66°C

A: To find: The heat transfer by conduction through the composite wall using thermal conductivity and…

Q: PLZ I want full answer with all solution steps A heat exchanger is to be designed to heat 32/68…

A: To find: Note: “Since you have posted a question with multiple sub-parts, we will solve the first…

Q: An iron horseshoe of mass 1.47 kg is taken from a furnace at 660 ◦C and dropped into 1.83 kg of…

A: Given:  m1=miron=1.47 kgT1=660°Cm2=mwater=1.83 kgT2=8.5°Cc2=cw=4186 J/kg.Kc1=ciron=448 J/kg.K

Q: B. A substance has a total volume of 1.25 m³ and is under gravity at 9.65 m/s². m (kg) v (m³/kg) w…

A:

Q: Consider the channel shown in (Figure 1). Suppose that a = 350 mm, b = 250 mm, c = 50 mm.

A:

Q: IBL, Flat Plate. Apply the integral boundary layer analysis to a flat plate turbulent flow as…

A: To find: The expression of δx, total drag coefficient and the drag coefficient at IBL, Smooth and…

Q: A system is to be controlled by a proportional controller via unity feedback as shown in Figure 3.2.…

A: Solution: Given Data:   To Find:

Q: A basic Rankine steam power plant uses an adiabatic turbine that operates with inlet steam at 6.80…

A:

Q: Air (??=29 kg/kmol)at 115.00 kPa and 285.00 K is compressed steadily to 600.0 kPa. The mass flow…

A: Introduction A steady-flow device is one that will have a consistent flow of material pass through…

Q: A 3"-diameter jet has a velocity of 110 fps. It strikes a blade moving in the same direction at 70…

A: Given : d = 3 in = 3/12 ft = 0.25 ft V1 = 110 ft/s u = 70 ft/s deflection angle is  150⁰ , so θ =…

Q: D. Assume standard atmospheric pressure. Gage Pressure (psig) 1 2 (kPag) 220.00 -5.20 (atm) Absolu…

A: Given

Q: 3. Find the young's modulus of a bars a rod of diameter 25 mm and of length 250 mm which is…

A:

Q: Find the mass and center of mass of the solid E with the given density function p. m 11 (x, y, z) =…

A: In this the triple integration approach is being used to calculate the mass and centre of mass.

Q: 4. Locate (calculate) the X-X and Y-Y centroidal axes for the area shown. Make sure to draw the…

A:

Q: the 309-lb block is released from rest when the spring is undeformed, etermine the velocity of the…

A: Given,

Q: Consider the beam and loading shown. Knowing that d=1.37 in. and E= 29 x 106 psi, determine the…

A: Draw the free-body diagram of the beam.

Q: How many countries submitted new or updated "nationally determined contributions" (NDCs) or pledges…

A:

Q: b. Determine the support reactions at A and B of the beam loaded as shown. 6kN/m ITI 3m D 3m 4.5…

A: Given:Uniformly distributed loads acting on the beam:w1=6 kN/mw2=4.5 kN/mLength of the beam, L=9.6 m

Q: Two gases enter a combining tube and leave as a single mixture. . For the first gas, A₁=72in²…

A:

Q: An equation of state (EOS) is a thermodynamic expression that relates pressure (P),  temperature…

A: Given question is related to thermodynamics

Q: Write a report on the Coriolis Effect that includes:

A: The Coriolis force, which is fictitious or inertial in physics, acts on moving objects within a…

Q: A hoop with mass M and radius Rrolls on a horizontal floor at constant angular velocity (w = do/dt)…

A: Givenmass of Hoop =mradius of hoop =R

Q: The two 11-kg slender rods are pin connected and released from rest at the position 8 = 60°. Neglect…

A:

Q: 2. The ladder shown is supported by a horizontal floor and a vertical wall. It is 16 ft long, weighs…

A:

Q: The Stirling cycle, shown in the figure, is useful to describe external combustion engines as well…

A: Given question is related to thermodynamics and heat engines.

Q: Determine the reaction at A and select the correct bending-moment diagram for the beam and loading…

A: In this question to calculate the reaction at A we will simply apply force equilibrium and due to…

Q: The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces…

A: Given Data- A cantilever beam with loaded condition given we have to find Moment and resultant

Q: Q1) A heat exchanger is to be designed to heat 32/68 mixture of ethylene glycol and water from 24 ᵒC…

A: D=19mmthickness t=2.108 mmL=8 feet=2.44 m To find:

Hydronics