What is the frequency of the input signal if the measured capacitive reactance is equal to 28 Q. Given that R1 = 1738 Q and C1 = 1 micro Farad. The voltage is kept constant at 5V. Note: Express your answer in Hz and in 2 decimal places. No need to include the unit. V R1 www C1 Xc Vout -O

Q: Question 5. For the given as circuit with dependent sources, find Thevenin equivalent arouit to be…

A: Asked to find Thevenin's equivalent across ab

Q: b) Find the Node voltage at point "a". Give the answer as a function of time Va(t) = ? Note: Be…

A: Circuit is given as,

Q: The admittance for an inductor Lis: Select one: O O a. (SL) Q-¹ b. 1/(SL) H

A: Value of inductance is L.

Q: Assume worst case SNR of a 10 bit ADC is 57 dB. If the resolution is increased by 2 bits, the…

A: Assume worst case SNR of a 10 bit ADC is 57 dB. If the resolution is increased by 2 bits,

Q: Please create a diagram illustrating a functional circuit on a separate sheet of paper, and provide…

A:

Q: 2- Given the following two-degrees of freedom translational mechanical system, use the "by…

A: The transfer function of the given mechanical translational system needs to be calculated by using…

Q: The current through a particular circuit element is given by i (t) = 10 sin (200πt) A in which the…

A: To sketch: The graph of current i(t) versus time.

Q: Example 3: find the value of 1₁ 50 10 A www 0; 16 A 4Q ww

A: The circuit is,

Q: ? By using Current Divider Rule (CDR) find i1 & i2 + 11 12

A: The circuit is given that:

Q: Question2: Given the sequence h(k) 2, 1, 0 for k = 0, 1, 2 for k = 3,4 elsewhere, where k is the…

A: here we have to draw the sequence of  hk,h-k,h-k+2,h-k-3.

Q: For V1=30, R1=430, and R2=660 of the figure shown below, Determine the currents I₁, I2, and ID2. + E…

A:

Q: An oscilloscope shows peak-to-peak amplitude of 8 cm for a measured sinusoidal voltage waveform with…

A: In the given questions we need to calculate the average value of the given signal.

Q: The series RC circuit has a complex power S = 10 126.56° VA working at a network frequency of 50 Hz.…

A: S=10∠26.56° VAf = 50 HzR = 2 ohm Pactive= 10cos26.56° P = 8.94 Watt Xreactive=…

Q: 250V + 25 Ω 8A + Vo W Find Vo using source Transformation 100 Ω 2002

A:

Q: 3. In a super heterodyne receiver, the IF is 455kHz. If it is tuned 1200kHz, the image frequency…

A: Step-1-> Acccording to given question we have, IF= 455 kHz Tuned frequency(fs) = 1200 kHz. Image…

Q: Hz A function is given by f(t) = sin²t+ cos2t. Which of the following is true ? (A) f has frequency…

A: here we have to find the frequency components present in the signal

Q: For the Transistor circuit given below (VBE = 0.7V) a. Obtain the necessary equations for the…

A: For the given voltage divider biased CE amplifier the necessary equation for calculating the DC…

Q: What is condition-based maintenance? Explain the following two methods of condition monitoring in…

A: Step-1-> Condition-based maintenance (CBM) is a maintenance strategy that focuses on monitoring…

Q: 2. An electric train runs between two substations A and B 10 km apart maintained at voltages 600V…

A: We need to find out the distance for given track for given voltage.

Q: How many poles are in the right half-plane, in the left half-plane, and on the jw-axis for the…

A:

Q: Examples and resolution of electrical protection coordination problems

A: We have to give examples and resolution of electrical protection coordination problems.

Q: Which resistor would dissipate the largest power? E Lu 25 ohms O 75 ohms 100 ohms 10 Ω Ο 10 ohms 25Ω…

A: We need to select correct option for given circuit , we need to tell about resistor which dissipates…

Q: Use the equation below to answer the following question(s): x(1)=5+e+e' The signal x(1) given above…

A: Need to analyze the given signal is a odd signal or even signal, state whether the discrete signals…

Q: 5-) Calculate the theoretical impedance of the circuit below that will be applied to an AC of 500Hz?…

A: Frequency f = 500 Hz. Given circuit diagram is,

Q: Q.6 A power plant has a maximum demand of 120 MW, load factor of 85% and the capacity factor of 60%,…

A: here we have to find the plant capacity and utilization factor.

Q: A series motor runs at 700 rev/min when the voltage is 300 V and the current is 20 A. The armature…

A: Initial speed of motor N1=700 rpm. Initial terminal voltage V1=300 V. Armature current Ia=20 A.…

Q: Calculate the Laplace Transform of x(t)=3 u(t) + e -²t u(t) + e 4t u(-t). Draw the Region of…

A:

Q: [Q5B] The signal m(t) (whose spectrum is shown in the figure below) is sampled at a rate of 15k…

A: Given: Spectrum of a signal m(t), which is sampled at a rate of 15000 samples per second and A = 2…

Q: Assume an idea converter showing below, what is the quality factor (Q) if the battery voltage…

A: The input voltage to the converter, Vbatt=48 V The output voltage to the converter, V∘=24 V The…

Q: Write expression as sum of Minterms for Any One Neutral function F over 04 variables A, B, C,…

A: Here We Have to Write Sum of Minterms for the GIven Questions 1. Any One Neutral function F over 04…

Q: For a power station the yearly load duration curve is a straight line from 50,000 to 4000 kw. To…

A: Capacity of Generator 1 & 2 = 20,000 kW Capacity of Generator 3 = 7000 kW Pmax = 50000 kW Pmin =…

Q: 3. Given a circuit with an applied voltage v(t)= 340 sin (wt -60°) V and a resulting current i(t) =…

A: NOTE : As per our company guidelines we are supposed to solve only one question at a time. Kindly…

Q: A 3-phase,50Hz, 4-pole, Y-connected alternator has 6 slots per pole per phase. The armature has…

A:

Q: Determine the admittance parameters of the T network shown in Fig. 7.5. h₂₂ 492 292 V₁ 202 Figure…

A:

Q: Find the transfer function Ve(s)/V(s) using any 3 circuit analysis. 1 mmor r(t) 32 2H 0.5F r(t)

A: Circuit diagram

Q: .)/Sketch the following signals: a) u(t−5)−u(t−7) b) u(t+3)−u(t−1) Please include an in-depth…

A: Unit step Function is defined as, ut=1  ;    t>00  ;    t<0 Graph of unit step Function…

Q: A digital transmission system has a bit rate of 45 megabits/second. How many PCM voice calls can be…

A: In a digital transmission system, The bit rate is 45 Mbps. Word length is of 8 bits.

Q: The critical frequency at a particular time is 12.5 MHz. What is the optimum working frequency for a…

A: Given: Critical frequency, fc=12.5 MHz Angle of incidence, ϕ=65°

Q: Draw the analogue electrical system of the mechanical network using Force-Voltage Analogy.

A: For the given mechanical translational system the equivalent electrical network needs to be obtained…

Q: Implement the following Boolean function using a (1) multiplexer, (2) then using a decoder and…

A: Need to implement the given boolean function using the multiplexer and decoder along with OR gate.

Q: Obtain the transfer function H(@) = I/I, of the circuits shown in Fig. 1. 10 H www www 20 22 (a) 0.1…

A:

Q: c) For a transmission line w/characteristic impedance Z0 = 50 W. At some point of the line, a…

A: To solve the given problems, we'll use transmission line theory and the equations that govern wave…

Q: which means the following points: 1- the interrupting capacity of the protection devices must be…

A: Solution: Determine : =>here we explain  as per give above three point are related to power…

Q: a. If the refractive indices of medium 1 and 2 are n₁ = 1.54 and n₂ = 1.50, respectively, find the…

A: The critical angle can be calculated using Snell's law and the formula for the critical angle:…

Q: Determine the Thevenin equivalent circuit for the circuit shown. Draw the Thevenin's equivalent…

A: Asked to find Thevenin's equivalent circuit We need to calculate Thevenin's voltage and Thevenin's…

Q: ३६ 6 O a. R O b. 16 OC. SR O d. O In the above circuit, what is the current through the resistance…

A: here we have to find the current through the resistor R.   given circuit is  consider a node 'a' as…

Q: 1. I need to give the analysis of this circuit(how i obtain the output voltage from the inputs in…

A: The above question is based on the design of circuits based on operational amplifiers as a summing…

Q: A synchronous generator is connected to an infinite bus with excitation voltage Ef = 1.3 pu. The…

A: Excitation Voltage Ef = 1.3 puTermial Voltage     Vt = 1.0 puSync. Reactance   Xs = 1.1 puReal Power…

Q: Question No.32 The position error coefficient of a system G (s) = (+2)(s+7) ' with unity feedback is

A: Control system, Gs=1s+2s+7. Unity feedback, Hs=1.

Q: What is the difference between the traditional Wind energy system to the modern wind energy…

A: The traditional wind energy system, also known as a windmill, and modern wind energy conversion…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.