what is the difference between AM &DSB modulation?

Q: Find the Inverse Laplace Transform of the following functions

A:

Q: Can you receive an analog input from a digital pin?

A: The digital pin in particular accepts any kind of input, but gives the true output only for digital…

Q: 15) An alarm sounds when certain conditions occur in a nuclear reactor. The output X, of a logic…

A: 15) Given, An alarm sounds when certain conditions occur in a nuclear reactor. The output 'X' that…

Q: When may it be useful to synchronize barriers

A: In parallel computing, a barrier is a type of synchronization method. Synchronization barriers are…

Q: 1_ To obtain equal currents between the resistors, what do we do? 2_When a certain resistance is…

A: To find: a) How to obtain equal currents between resistors? b) what happens to the circuit when a…

Q: Find the transfer function of the following 2nd order system

A:

Q: If in a communication system BPSK, QPSK, QASK-8 are used for transmission and reception of digital…

A:

Q: A 0.48520λ0 dipole antenna is made to work at 4 GHz. The antenna is then connected to a 12 V voltage…

A:

Q: § 2.4 Series Diode Configurations with DC Inputs 7. Determine the level of V, for each network of…

A:

Q: 8 7 6 5 4 3 2 1 0 a. For the common-emitter characteristics in the figures shown below, find the dc…

A: Note on Bipolar Junction Transistor When BE and CB junction is reverse biased= Cut off Region When…

Q: draw curve (Vin & Vout ) in resistor transistor logic

A: Resistor transistor logic RTL This logic circuit includes a resistor and transistor as integrated…

Q: Q/A single-phase transformer with a capacity of 100 kVA and a voltage of 2000/400 and the equivalent…

A: The transformer is a static device that helps to step up or down the voltage or current level by…

Q: Q4 A- Illustrator the rotor of the following Motors? 1- Control Differential (CD) Synchro motor. 2-…

A: Q4) A)

Q: Suppose a liquid level ranging from 5.5 to 8.6 m is linearly converted to pneumatic pressure ranging…

A:

Q: Find the Inverse Laplace Transform of the following functions 1 Ans. f(t)=1-e¹ S + S 1 S³ + 4s 1)…

A:

Q: Consider the following transfer function C(s) R(s) O a. From the information given which one of the…

A:

Q: Question 2) A series DC motor of 250 V. 10 HP has field resistance equal to 0.1 ohms and armature…

A:

Q: A 220V do motor developing 25 hp (18.65 kW) runs at a speed of 1000 r/min.. Calculate the torque in…

A:

Q: Basic Laws of Circuits Equivalent Resistance: Resistors in combination. Example 5.2: Given the…

A:

Q: ) Consider the following electrical system with the applied voltage Vi as the input and Vo as the…

A: Note: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits.…

Q: Three 24 V batteries are connected in parallel and deliver current to a load resistance of 0.8 Ω.…

A:

Q: (b) The circut has been reconnected with the same silicon diodes as shown in Figure 2b Calculate…

A: The given circuit is:

Q: Find the transfer function 8(s) T(s) T (t) 0 (t) Cro for the system shown in Figure Q6. D 11:01:10

A:

Q: For the series circuit, find the parallel circuit that will have the same total impedance. Z₁ 2052…

A: it is asked to find the parallel circuit of given series circuit

Q: Design the state feedback controller so that G(s) is %OS-10% of the system and the settling time…

A: Given data Overshoot percentage, %Mp=10% Settling time, Ts=1 sec Open loop tarnsfer function (OLTF),…

Q: A single phase, 30 km long overhead transmission line consists of two parallel long conductors each…

A:

Q: An AM signal having sinusoidal message, takes the form a) Find the modulation index of the AM signal…

A: Since you have posted a question with multiple subparts, we will provide the solution to the first…

Q: Solution A 15 mH is connected in series with another coil. The total inductance in series addition…

A: Given: Two inductor coils are connected in series. The inductance of the first coil, L1=15 mH Total…

Q: C i) What is the difference between a proximity sensor and a limit switch? ii) State 3 types of…

A:

Q: b) Design a PLL circuit (Find R₁ and C₂) shown below for fo = 14kHz and f = 60Hz and assume C₁ =…

A: Phase Locked Loop The phase difference between two signals, and the capacity to detect it, are…

Q: A 3-phase 60 Hz distribution line supplies rated power to a Y-type load. The rating of the load is 5…

A: The above question is based on 3 phase systems. Power P of a 3-phase system is given by P = 3 VL IL…

Q: - (a) An emitter follower as shown below should provide an input impedance of 2 k with a gain of…

A:

Q: CCI VDD=15 V RG=5 MQ ww RD = 10 k Cc2 Vo R₁ = 5kQ

A:

Q: Q.4: What is the sampling theorem this issue carefully with an condition? .example What is happening…

A: According to the Sampling Theorem, any signal can be regenerated or reproduced without any loss of…

Q: + V₁ I₁ 192 292 292 www Find z-parameters 192 41₁

A:

Q: 13. Determine V, and ID for the network of Fig. 2.142. +10 Vo Si 2 k 2kQ2 • 2 ΚΩ

A: it is asked to find the voltage Vo and ID in the given circuit

Q: 3. Luminaires of 2000 Im output will be installed in a room. The desired illumination is 200 fc. The…

A: Solution of question (3): Luminaries that will be installed in a room is F=2000 lumens. Desired…

Q: Two identical generators 5MVA, 6.6KV equally sharing a load of 8 MW at 6.6kV, 0.8 lagging p.f. The…

A: two genrators load = P =8 MW load shared by each generator is P1 =P2 =82=4 MW line voltage, VL =6.6…

Q: MI (+) • GG HAM 10 HWAM امد 671 ANAW 11 MAAN

A:

Q: Design a fixed-bias configuration by finding the right values of Rc and RB if Vcc= 12 V, ß = 80, and…

A:

Q: The switch in the circuit below closes at t = 0 after being open for a long time. Find the transient…

A:

Q: At 60 Hz , the impedance of coils A and B are each 10 ohms . At 25Hz , the impedance of A is 5.38…

A: It is given that: At f=60 HzZA=10 ΩZB=10 ΩAt f=25 HzZA=5.38 ΩZB=8.67 Ω

Q: Is 0.2 Α 1) 45 Ω Va Figure 2.3 100 Ω Vab ww 400 Ω V₂ 21 V

A:

Q: 9. Determine V₁, and Vo, for the networks of Fig. 2.138. +12 Vo Si 4.7 k www (a) Si Voy -10 Vo Si Si…

A:

Q: Use of computers in digital control systems is particularly valuable for a number of reasons,…

A: Use of computers in digital control systems is particularly valuable for a number of reasons,…

Q: Find Vo using nodal analysis. 6V(+ 2 ΚΩ + 4 ΚΩ 4 ΚΩ ww Vo • 8 ΚΩ 8 ΚΩ 2 mA

A:

Q: A 230V, 10A single phase energy meter makes 180 revolutions per kW hour. If a load is supplied…

A: Given- 230 V, 10 A single phase energy meter, 180 revolutions per kW hour, Power factor pf = unity…

Q: Determine the overall efficiency of an OTEC plant if surface warm water temperature is 27°C and deep…

A: Note:  Tcold= Deep cool Temperature THOT=Warm Temperature   ηmax=(1-TCOLDTHot)×100…

Q: 1. Four identical 200 cd lamps are suspended 8 m above the ground at the corners of a square of 3 m…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: The capacitance of the capacitor formed by two parallel plates, each 100 cm in area separated by a…

A: Given data, Capacitance is given C=200 μF. Cross sectional area A=100 cm2=100×10-4=0.01 m2.…

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.