What is the difference between active power, reactive power and apparent power?

Q: Limiting the input AC amplitude of a  waveform  is the application of Adder Clippers DC restorer…

A: Given Limiting the input amplitude of AC waveform

Q: e: sketh tha output veltage for tH folloolng circut aka

A: Disclaimer:  Since you have asked multiple questions, we will solve the first question for you. If…

Q: Vm220 v - 50 Hz R=10KN NNp=1/5 C=50mf

A:

Q: Q5: find the output waveform for the circuit in figure (3) AI "ERSITY vine4 sin wt VR 2V Figure (3)

A: We need to find out output waveform for given circuit .

Q: • Draw the relation between frequency and e

A: We need to find out the relationship between angle and frequency .

Q: The average value of the voltage in the given Figure is equal to: Note Vm=100 V

A: Given data, Maximum voltage Vm=100 V. Waveform is given as,

Q: Voltage Peak value RMS value Average value Peak-to- peak value O v Time

A:

Q: H single phasc half wave Dectificr has puselycsistive lead of "R" and fising angle Dtrmine:-a) Draw…

A: we need to draw the circuit and calculate the average voltage and current, and RMS voltage and…

Q: 20 V 10v -20 V

A:

Q: 24. What is the impedance of a series combination of a 50-2 resistor, a 5.0-uF5.0-µF capacitor, and…

A:

Q: what is the DTFT of sin(n)/n

A:

Q: In an electrical installation, the active power is 500 kW and the power factor is 65% (lagging). How…

A:

Q: Ri Dz si Di I si Vo 201 pe

A: According to the given question, it is required to draw the equivalent waveform of the below given…

Q: Q6. Calculate the total current in the circuit below if the circuit is powered by the sine wave…

A: The circuit is given as:

Q: 2.2kQ 10 µF V Figure 1: RC high-pass circuit schematic Peak: 9.2V RMS: 3.05V Calculate the…

A: The circuit can be implemented in tinker card are as follows as given The DC offset is =0 V

Q: evaluate the following complex number 8/10° +62-20 9480°-4450°

A: Given: A complex number, To do: Evaluate above mentioned number.

Q: For the given circuit and input waveform determine the output waveform. a. b. C. V₁ 15 20 -10 d. -5…

A: As per Bartleby guidelines we are supposed to answer only one question at a time, so please post…

Q: The sum of the following two e.m.fs will be e1 = 10 sin wt and e2 = 10 cos wt O 10 O 20 sin wt O…

A: We need to find out the resultant of two sinusoidal signal

Q: An oscilloscope shows peak-to-peak amplitude of 8 cm for a measured sinusoidal voltage waveform with…

A: In the given questions we need to calculate the average value of the given signal.

Q: is the duty cycle of step down chopper which is having 216 V as a input and 202 V RMS output…

A:

Q: e input voltage to chopper circuit with a switching frequency of 100 Hz and Ton time as 2.0 ms is 10…

A: Given a chopper circuit having, Input voltage, Vs=10 V Switching frequency, f = 100 Hz On time,…

Q: Q1 (a) Based on electrical DC circuit as depicted in Figure Q1(a), (i) Determine the mesh currents…

A:

Q: %D Calculate the output impedance for the circuit shown in figure. Assume VA = 0. Circuit parameters…

A: Given data:

Q: Consider the circuit given below ) Identify the circuit with details p) Find the Q-point =) Find VG…

A:

Q: in the waveform shown * نقطتان (2) in the figure ,the voltage signal and current signal are

A: Phase diagram is given as,

Q: What does an AC power source supply? a. Reactive Power b. Active Power c. Apparent Power d. True…

A: The electric power is the rate the amount of electrical energy supplied to each element present in…

Q: coil of watt meter is connected in series.

A: Fill the blank Which coil of Wattmeter is connect to series?    as per our guidelines we are…

Q: Calculate 11, 12, and 13. The frequency is fixed at 500 Hz, and its output voltage magnitude to 5 V…

A: The circuit diagram,

Q: Which of the following represents the value of a is

A: a is known as vector operator or mathematical operator in power systems used to obtain symmetrical…

Q: For the CRO display of a pulse waveform, the time/cm is on 30 ms/cm and the volt/cm switch is on 9…

A: The solution is attached below with the correct option, I have also solved for the time period in…

Q: Q2/ Fiud the Value Cs For L:15 Hz for the , hie:e,5k followng Figure hfe=200 2ov 39K 1,5K 3002 24 K…

A:

Q: a student is doing work on circuit in which he employs a voltage af 60 sin(314t+60) by  observing…

A: Given data, Voltage, V = 60 sin(314t+600). Here, Vp = 60 V.

Q: 1. A symmetri cal Square wave af 2 kHz whose voltage varies bedween -lov is applie d +1ov and to he…

A:

Q: For the given waveform the peak voltage is (V) and frequency is (Hz). VTHO Vertical Pos Horizontal…

A: Here given that Vertical scale 1Volt/div  Horizontal scale 0.5 sec/div

Q: Average active power in a Three Phase Circuit = W

A: Find the Average active power in a three-phase circuit.

Q: Frequency of power supply is 50 Hz. The time period to complete 8 cycles in seconds is:

A: In this question, choose the correct option What is value from peak positive to peak negative?  What…

Q: A receiver is being tested to determine SINAD. A 400-Hz audio signal modulates a carrier that is…

A: Given SND =7mW ND =0.18mW

Q: a) Sketch the o/p waveform of the circuit shown in Figure (1), when vi-2sinwt. Vec ΣΚΩ vb 3ΚΩ Va 1kΩ…

A:

Q: What R is needed in series with a 0.01- capacitor for a phase angle of - 64°, with frequency of 800…

A: what R is needed in series with a 0.01 capacitor for a phase angle of -64 degree with frequency of…

Q: For a sinusoidal input of 20 Vpeak to the given circuit, what is the peak value of the output…

A: The diode can be replaced with a short circuit and the diode is taken as ideal.

Q: 2Vm Vm Vm DC level Vi D, RL Vo t -Vm Input waveform Output waveform Positive clamper

A:

Q: For the same real power, as the power factor decreases a. Reactive power does not change b. Reactive…

A: The given mathematics Real power = VI cos(Θ)  Reactive power= VI sinΘ Q= P tanΘ

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.