What is RG rating of coaxial cable? Give detailed answer please

Q: There are 175 slots in a 3-phase, 16-pole, 50 Hz., star connected alternator. There are 4 conductors…

A: We have an star connected alternator we have, slots = 175 Poles (p) = 16 frequency (f) = 50 Hz 4…

Q: 6. What is the total capacitance of a circuit containing a .01 farad, a .015 farad, and a .001 farad…

A:

Q: Solve for the Vrms (magnitude only) across the capacitive reactance if R2 = 1082 ohms and Xc = 2328…

A:

Q: 1) Find to in terms of input voltages 2) Find out put impedance of the circuit if of the the op amp…

A:

Q: Vo below. the given cir ID1 Ge 31.3 V 17.6 V 39.3 V 32 V 31.7 V Si ID2 6.8 kohms 4 V Vo

A:

Q: Problem 3: Obtain the currents i, and is for the circuit shown in Figure 3 using mesh analysis. 5V(+…

A: Given circuit,

Q: A 100 kVA transformer has an iron loss of 3 kW and a full load copper loss of 4 kW. So at what kVA…

A: Solution: Given data; KVA =100 KVA, Iron loss Wi=3 KW ,  full load copper loss Wc= 4 KW , power…

Q: is h(t) = sin(t)e-tu(t) is stable system?

A: In the given questions we need to find whether the given signal is stable or unstable.

Q: Solve the voltage across silicon diode of the given circuit below. ID1 0.3 V 32 V 28 V 0.7 V 32 V Ge…

A: In this question,  We need to choose the correct options Assume the forward bias voltage drop across…

Q: 4: Using superposition, find the current through the (202) resistor for the circuit below. 202 El 12…

A:

Q: Q- A transmission line has characteristic impedance is 50 and length I = A/8. If load Z₁ = (R+j30),…

A:

Q: 0 0.3 0.5 1.0 8 28 46 94.5

A:

Q: Capacitors of 10 μF, 20 μF and 30 μF are connected in series to supply 200 V d.c. Find the voltage…

A:

Q: Murray loop test is performed on a faulty cable 300 m long. At balance, the resistance connected to…

A: A murray loop test is performed on a faulty cable with  cable having 300 m long length.   Now at…

Q: An n-p-n transistor at room temperature has its emitter disconnected. A voltage of 5 V is applied…

A: We have an N-P-N transistor at room temperature its emitter gets disconnected  V = 5 V When the…

Q: Determine whether or not each of the signals is periodic. If a signal is periodic, determine the…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: Show that reflection and displacement of a signal are not commutative. R[D[X(n)]] D[R[X(n)]]

A:

Q: Q1)a)Given x(t) and h(t) as below find and draw y(t) X(t)=u(t-1) h(t)=-8(t) + 8(t-1)

A: Since you have posted the multiple questions so we are supposed to answer the part a only

Q: Show that reflection and displacement of a signal are not commutative. R[D[X(n)]] D[R[X(n)]]

A: For any queries please let me know through comments. I will try to reply ASAP! Please upvote if…

Q: Q2/ The impulse response of the circuit is given as h(t) = e-2tu(t). This circuit is excited by an…

A:

Q: Vs Vs= 8 V Is R1 ww -www R2 R1-20 R2-2 R3-5 What will be the current flowing through R2 www R3

A: The given circuit is, Here, Vs=8 V,R1=2 Ω,R2=2 Ω,R3=5 Ω.

Q: Find and draw the Norton equivalent circuit with respect to the terminals a and b for the circuit…

A: The norton's current can be obtained by short circuiting the terminal a and b. The current through…

Q: Calculate the current (Vab)

A:

Q: Example In the following cases, the x-axis carries a scale of t in milliseconds. (a) у 4 (b) (c)…

A: Time period: Time period is known as the time taken for one complete oscillation to occur. It is…

Q: 2) Determine (V%) for the Iwo circuits below using superposition. 20 V www 6Ω www 2Α ΣΩ ΤΑ να 3 Ω…

A:

Q: In an electric circuit, suppose that the electromotive force in volts at t seconds can be modeled by…

A: Given- Voltage, V = cos 2pt =cos 2πt       [ Here, p =π] To find- Time value for - V=0 V= 0.5 V=…

Q: Plot the following signals: 1. (a) y(t) = f 8(x)dx (b) 92 (t) = f(x-t)dx (c) ys(t)= (t(u(t)-…

A:

Q: Express the Boolean function F = A + B ′ C + A D as a sum of minterms.

A: It is given that: F=A+B′C+AD

Q: 500 KW loading power factor 0.6 is lagging. The combined power factor 0.9 is to be used by the…

A:

Q: What justifies the need for plenumrated cabling above the ceiling tile?

A:

Q: given >=0.3j, z=0·2j, z = 0.15. Find: All Voltages and current for single - Line to ground A11 fault…

A:

Q: Find the value of R if the power supplied by the 50-V source is 100 W. 50 V + 5 Ω 202 2 A www R

A: The given circuit is, Power supplied by 50 V source is 100 W.

Q: A 10.0-Ω resistor, 10.0-mH inductor, and 100-μF capacitor are connected in series to a 50.0-V (rms)…

A: The resonance frequency is the frequency at which the impedance of inductor is same as the impedance…

Q: Find the upper and lower limits for the system shown below. (Show me your work in details)

A: The heater input voltage and the corresponding temperature waveforms of the system are shown below,

Q: a 3-bit up-counter JK Flip flops Design using 1) Truth table to express the function of the counter…

A: The 3-bit up counter can be designed by using the three jk flipflop. The logic expression can be…

Q: Q5- Sketch the complete Bode plot for the transfer function margins and the crossover frequencies on…

A:

Q: A distribution transformer costs Rs 2,0 and has a useful life of 20 years. If the salvage value is…

A: GIVEN: costs = 2,00,000              time period = 20years              salvage value= Rs 10,000…

Q: Match the description with the (non-ideal) filter type. Here, P refers to a passband transition…

A: Given- Four conditions are given related to different filters- P=1000 S=800 P=1000 S= 1250 P= 1000,…

Q: 3. A BJT transistor's α = B/(B + 1) is 0.992. Find the collector-current (Ic) for a base-current…

A: Given, A BJT transistor with, Current gain, α=ββ+1=0.992 Base current, IB=20 μA

Q: 1. Compute the total inductance between A and B. A B 2 H 6 H 3 H

A: Given circuit:

Q: The insulation resistance of a single-core cable is 432 Mohm per km. If the core diameter is 2.87 cm…

A:

Q: Q10/Chose the correct answer for the output Q3 of the following circuit ( Assume that A=…

A: Given circuit,

Q: Solve the output voltage Vo of the given circuit below. ID1 32 V Ge Si ID2 Vo

A: Diode is unidirectional device. When P side of diode is at higher potential than N side the diode is…

Q: I want this soln as soon as possible  Kindly draw k-map for function F1(A,B,C,D) =…

A: The reduced boolean expression can be obtained by using the k-map. The result is k-map is a sum of…

Q: Find the equivalent resistance RabRab for the circuit shown in (Figure 2). be 1.2 ΚΩ 4 kΩΣ 30 kΩΣ…

A:

Q: Can an induced electric field create a current in the loop?

A: Current:- It is a passive electric element. In any circuit sum of incoming current should be equal…

Q: B- For the closed-loop control system of the open-loop transfer function Find the minimum value of K…

A:

Q: Simplify the following Boolean function F, together with the don't care conditions d and then…

A: Given that: The Boolean functions are F(A,B,C,D)= ∑(4,12, 7, 2,10,14)d(A,B,C,D)= ∑(0, 6, 8) Find the…

Q: If the resistances 10, 20, 30, 40 are parallel, then the equivalent resistance (2) is

A:

Q: For a periodic signal v(t) = 30 sin100t + 10 cos300t + 6 sin(500t + π/4), the fundamental frequency…

A: Given- V(t)=30sin100t+10cos300t+6sin(500t+π/4)To Find-The fundamental frequency in rad/s.

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.