what is expected VSWR for a transmission line with a reflection coefficient of 0.377
Q: A single stub tuner is used to match a lossless transmission line of Z, = 75 Q to an antenna load…
A:
Q: Explain what will happen to the characteristic impedance when the spacing between the center of two…
A: We know direct formula of two conductor transmission line.
Q: lossless transmission line has a characteristic impedance of Zo=40N, load reflection coefficient is…
A:
Q: Calculate the voltage reflection coefficients at the terminating end of a transmission line with a…
A: Voltage reflection coefficient is determined based on characteristics impedence and load impedence…
Q: A lossless transmission line has a distributed inductance of 10 pH per meter and a distributed shunt…
A: Given data : Distributed inductance L=10×10-6H/m For 4m length L=10×10-6×4 =40×10-6 Distributed…
Q: A rectangular waveguide is terminated with an unknown load. By using a slotted line, load VSWR is…
A: VSWR : VSWR stands for voltage standing wave ratio is directly proportional to reflection…
Q: A load of 120 + j150 Ω is connected to a 60 Ω lossless line. Calculate the back reflection…
A: It is given that: ZL=12+j150 ΩZo=60 Ω
Q: The loss in a cable is usually defined in decibles per kilometer (dB/km). If the signal at the…
A: Power of signal at 5.5 KM =10 log2mW+5.5km×-0.3dBkm=10 log2×10-3+-1.6dB=10…
Q: In transmission lines, the length of the line is small as compared with the distance of separation…
A: Transmission lines especially power lines are very long and they carry electric current over…
Q: A three phase 60HZ, 60kV transmission line consisting of 3 conductors are placed at the corners of a…
A:
Q: The reflection coefficient (KR) of a transmission line that has a characteristic impedance of Zo=50…
A: In a transmission line, generally waves are travelling in lines. During the traveling of a wave from…
Q: Q3. For the Figure below, find the inductance per km of a transposed double circuit three - phase…
A: Inductance per km is determined as shown below
Q: 13. Find the reflection coefficient of a lossless transmission line with a Zo=50-j2592 is connected…
A: Given data, A lossless transmission line with, Z0=50-j25 Ω Connected to open circuit.
Q: The cutoff frequency for TE11 mode if the guide is filled with a lossless material having r = 2.25…
A:
Q: 11. The impedance on the Smith chart can be repeated for each half wavelength * length of the…
A: From the Question The impedance on the Smith chart can be repeated for each half wavelength length…
Q: The voltage wave in a lossless transmission line has the maximum magnitude of 6 volt and minimum…
A: To find The reflection coefficient of the transmission line
Q: A lossless 1000 line is terminated with an inductance L=2mH. At w=25×10³rad/s, what is the…
A: In this question, We need to determine the reflection coefficient at the end of the line If…
Q: When a lossless line is terminated with an arbitrary load impedance ZĻ, then it : a) causes wave…
A: Every transmission line has a characteristic impedance (Zo). Usually, a transmission line is always…
Q: A transmission line has characteristic impedance of 75 Ω and it is connected to receiver with Zr=…
A:
Q: With a neat diagram show the reflections occurring in a transmission line. Hence explain thec…
A: The power system has to transmit power from the generation side to the load side. For this purpose,…
Q: 10/Explain in your own words and your own understanding (avoid plagiarism) why there's Capacitance…
A: Simply capacitor is nothing but two conducting materials separated by small distance, in between…
Q: If there is no standing wave on a transmission line (constant pattern), then the value of VSWR is: *
A: VSWR: ratio of maximum to minimum voltage for lossless line in terms of voltage…
Q: Q3. For the Figure below, find the inductance per km of a transposed double circuit three- phase…
A: Given, r=1.2 cm d1=7.5 mD=42+0.752=4.07 md2=42+7.5+0.752=9.17 md3=82+7.52=10.97 md4=7.5+0.75+0.75=9…
Q: What is the input impedance of a 50 Ω short-circuit transmission line of length λ ⁄ 8, in ohms?
A:
Q: State the difference between high and low frequency signals travel in typical transmission lines.
A: Travelling wave in the transmission lines are the voltage and current wave from the sending end to…
Q: For multimode step-index fiber with core index of 1.68 and radius of 35 um. The indexdifference is…
A:
Q: (d) Sketch and explain the transposition of 3- phase unsymmetrical transmission lines.
A: When 3 -phase line conductors are not equidistant from each other, the conductor spacing is said to…
Q: The effect of rain attenuation at high frequencies is minimized if vertical polarization is used.…
A: The attenuation in the communication process which is caused by rain is known as rain attenuation…
Q: 11. The impedance on the Smith chart can be repeated for each half wavelength length of the…
A: From the Question The impedance on the Smith chart can be repeated for each half wavelength length…
Q: In diversity technique, pairs of widely separated antennas are used for transmitting and receiving.
A:
Q: In a laboratory, we found that the static wavelength ratio was 2.0 as a result of an experiment…
A: Given :Zo= 50 ohm Standing wave ratio=2.0 The distance between successive voltage minima of 25 cm…
Q: A lossless 75-N coaxial cable has a velocity factor of 0.67. For a shorted line at a frequency of…
A:
Q: With a neat diagram show the reflections occurring in a transmission line. Hence explain the…
A:
Q: A transmission line having a diameter of 2 cm and ur=5 produces an internal inductance 0.060 uH/m.…
A: Given: Lint1=0.060 μH/mμr1=5μr2=8To find,Lint2
Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…
A:
Q: In medium transmission line, capacitance is considered as O a. Lumped parameter O b. Distributed…
A: Given : Generally depending on the type of the medium we classify them parameters. Distributed…
Q: Show that VSWR for a transmission line will have values between 1 and infinity.
A: Although expression of standing wave ratio ‘S’
Q: for coverage P. and outa distance of 1
A: Solution
Q: What different types and modern usage areas of transmission lines and waveguides ? Explain and…
A: Transmission Line: A two conductor structure that can support a electromagnetic wave wherein both…
Q: 5. The short circuit load is connected to a transmission line. When the transmission line length is…
A:
Q: A 219-2 lossless air transmission line is connected to a complex load composed of a 579-Nresistor in…
A:
Q: A dispersionless transmission line is one which the wave velocity is not constant as a function of…
A: In this we will write about dispersionless transmission line...
Q: For a medium transmission line, VRNL is equal to Vs. Select one: O True O False
A: sending end voltage will be same as no load receiving end only when capacitance effect is absent .…
Q: A 75 Ω lossless line is terminated in error with a 93 Ω resistor. A generator sends 100 mW down the…
A:
Q: The cut off frequency of the dominant of a rectangular waveguide having aspect ratio more than 2 is…
A:
Q: The segment length for fiber optic cable
A: In this question we will write segment length for fibre optic cable ...
Q: The distance from the load to the source moving on a lossless transmission line is 2.5 revolutions…
A: The transmission lines are used for power transmission from one place to another. The power system…
what is expected VSWR for a transmission line with a reflection coefficient of 0.377
Trending now
This is a popular solution!
Step by step
Solved in 2 steps
- 4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY B. SERIES CONDUCTANCE AND SHUNT CAPACITANCE C. SHUNT CONDUCTANCE AND SHUNT CAPACITANCE D. SHUNT CONDUCTANCE ONLYVoltage reflection coefficient can be defined as: a) ratio of amplitude of reflected voltage wave to the transmitted voltage wave b) ratio of amplitude of reflected voltage to the incident voltage wave c) ratio of load impedance to the characteristic impedance of the transmission line d) none of the mentionedA single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
- A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of groundIn about 100 words explain why reflections and refractions can occur in a transmission line, why these are not desirable, and how they can be eliminated.How does inductance impact the performance of a transmission line in terms of signal integrity and power losses?
- For a TL connected to a load, if the voltage standing wave ratio (VSWR) is equal * to 3, then the reflection coefficient is equal to 0.4 O 0.2 O 0.3 O 0.5For a lossless trabsmisison line, the characteristic impedance is 80 ohm. If the capacitance per unit length is 1.5 mh/m then what will be the inductance per unit length.ASAP PLS Calculate the capacitance of a conductor to neutral in a single-phase transmission line having two parallel conductors spaced 3 m apart. The diameter of each conductor is 1.2 cm.
- Why the Capacitance effect is neglected in Short Transmission Line.The voltage wave in a lossless transmission line has the maximum magnitudeof 6 volt and minimum magnitude of 2.4 volt. The reflection coefficient of thetransmission line is 0.2 0.43 0.714 0.5please model a transmission line pair with an equivalent circuit model. establish the transmission equations using Kirchhoff's current law and voltage law. solve the equivalent circuit model equations to get wave equation.