What is buchholz gas?

Q: slerim / Çeşitli / MÜHENDİSLİK FAKÜLTESİ / Elektrik Elektronik Mühendisliği (İngilizce) /…

A: In this question we need to find the power absorbed by the load

Q: The total admittance of the following circuit at resonance is L Select one: m с R

A: Circuit diagram is given as,

Q: a relay is controlled with ______ voltages to connect devices that use high current/voltages

A: Need to identify how the relay controls the high voltage or current devices connected with it.

Q: What is the noise voltage generated over 55 Ω input resistor at 23°C with 3.2 MHz bandwidth?

A: We need to find out noise voltage for given resistance and bandwidth.

Q: P₁(-10; -5; -7) ve P₂(7; 8; 2) için P₁ P₂ aşağıda verilmiştir. Buna göre K, L, M =? The vector P₁ P₂…

A: In this question it is asked to find the distance between two vectors

Q: Objective: The objective of this problem is to learn how to adjust the excitation of an AC generator…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: How do I state and prove the divergence theorem?

A: The divergence theorem, also known as Gauss's theorem or Ostrogradsky's theorem, relates the flow of…

Q: 3. In the astable timer in the following figure in order to get duty cycle = %30 and F = 200Hz from…

A:

Q: 7. 7.3.6 In the critically damped circuit given as follows, the initial conditions on the storage…

A: The circuit diagram, The initial voltage of the cpacitor, Vc0-=5 V The initial current in the…

Q: order hold Assume that an input signal is applied to a sample/hold circuit. Draw the outputs of zero…

A:

Q: a) Calculate the resistance of the following circuit, list all equations used and write an…

A: 1. A H-bridge with, Only resistive elements Ohm meter 2. A series RC circuit with, AC voltage…

Q: Question 3. The purchasing circuit components of a three-phase ∆/∆ connected 50 Hz, 300 KVA,…

A: Dear student, Since you have posted a question with multiple sub parts, we will provide the solution…

Q: Do we need an add-on auxiliary contact on motor starter 2 to make this circuit work? a Yes…

A: Given is a ladder circuit of motor control. Motors are M1 and M2 CR is control relay TR is a timing…

Q: Draw the root-locus graph for the closed loop system given below. Using this graph, maxi-

A:

Q: I1 20A ++ Q 8 S1 t=0 R3 20 R2 10 ohms R1 60 ohms C1 40μF

A:

Q: The circuit you should use to find the open circuit voltage, oc, is shown here. Note that the…

A: In this question,  We need to determine the open circuit voltage.  We are solving this problem using…

Q: Metal wireways are sheet metal troughs with _____ for housing and protecting electric conductors and…

A: Metal wireways are sheet metal troughs with _____ for housing and protecting electric conductors and…

Q: For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50Hz and Vm=311V. Calculate the average…

A: To calculate the average current for an uncontrolled half-wave rectifier, we can use the following…

Q: For a single phase full wave controlled bridge rectifier with a resistive load if the input voltage…

A: Supply RMS voltage; VRMS=150 V Supply frequency; f=50 Hz Resistance value; R=25 Ω Firing angle;…

Q: Calcule la potencia disipada por la resistencia de 8.002 en el circuito ilustrado en la figura de…

A: The circuit diagram,

Q: Given two continuous time signals x(t) = et and y(t) = z(t) = x(t) * y(t) is -2t which exist for t>…

A:

Q: Problem eight. Given the following characteristic equation. Determine the range of K for a stable…

A: We need to find out range of k for stable system.

Q: Question A2 15 V ( 8 Ω WITH 200 pF 95 mH Fig A2 2 k

A: Circuit diagram is given as,

Q: The following circuit shown in the figure has a voltage source and a dependent current source. What…

A: The given circuit-

Q: Example 16.12. The load current in the transmitting antenna of an unmodulated AM transmitter is 8A.…

A: The load current in the transmitting antenna of an unmodulated AM transmitter is 8A. Percentage…

Q: The circuit you should use to find the short circuit current, fac, is shown here. Note that the load…

A: The circuit you should use to find the short circuit current, isc , is given in the diagram. Note…

Q: A 2.1 A2.1.1 Re draw the circuit shown in Figure 2.1 below using the Laplace domain series…

A:

Q: 10 22 15 µF 30 V 3 mH 6Ω Figure #3 a. Given that the circuit shown in Figure #3 is at resonance,…

A:

Q: An inductive load is controlled by an impulse commutation chopper in Fig.1 and peak load current…

A: “Since you have posted question with multiple sub parts,we will provide the solution only to the…

Q: A)Transform the following state space model into Diagonal Canonical Form (DCF) (that is, compute…

A: In a state-space model of a system, the state-space matrices are A=-311-3, B=12, C=23.

Q: Design a logic circuit with three inputs and one output and in which the value of the output is…

A:

Q: 10.10 A particular small-geometry BJT has fr of 12 GHz and Cu = 0.05 pF when operated at Ic=0.5 mA.…

A:

Q: 7. In the resistive inverter below V+=2.5V, R=200k, VTN=0.6V, K₂=100μA/V² and W/L=3/1:

A: :Solution: :Given Data: V+=2.5VR=200KΩVTN=0.6vK'n=100µAV2WL=31→:DETERMINE:→find low voltage VL→Find…

Q: 2) Figure shows three loads connected in parallel across a 1000-V (rms), 60-Hz single-phase source.…

A:

Q: V= 7,5xy+9,2 xyz olarak verilen skaler V'nin orijinden P(7,7; 3,9; 5,3) noktasına doğru olan yönde P…

A: In this question we need to find the increase rate of scalar V at point P

Q: N-point DFT, N-1 x(n) as an N-point sequence and X(k) as its Σ |x(n)|2 n=0 = 1 N-1 N Σ |X(k)|² 7c=0…

A: Given: For an N-point sequence, x(n) having, X(k)=DFT{x(n)}, Parseval's relation is,…

Q: What is a key difference between negative and positive feedback mechanisms?

A: Key differences between and negative and positive feedback mechanisms?

Q: Find the current in the RLC circuit, assuming that E(t) = 0 for t > 0 R = 4 ohms; L = .05 henrys; C…

A: In this question we need to find the current in the RLC circuit .

Q: Determine the Fourier series expressions for the periodic voltage functions for the full wave…

A: Given, We need to determine the Fourier series of above waveforms. The Fourier series for xt is…

Q: Minimize the following boolean function- F(A, B, C, D) = Em(0, 1, 2, 5, 7, 8, 9, 10, 13, 15)

A: It is given that: FA,B,C,D=∑m0,1,2,5,7,8,9,10,13,15

Q: 9. Given A = 5î - 2j-2k and B = 41+J-K, compute Proj B.

A:

Q: /Consider the four- input NOR logic gate in figure below, The transistor parameters are VTNL =-IV,…

A:

Q: 7.3. Simplify the following expression and express the result in POS form (a) X (A, B, C) =…

A:

Q: 9. If the beam width of an antenna in two orthogonal planes are 30° and 60°. Then the directivity of…

A:

Q: 14. Convert the following from rectangular to polar form: a. 4+j3 b. 2+j2 c. 4+j12 d. 1000+ j50

A: Convert the following from rectangular to polar form: a. 4+j3 b. 2+j 2 c. 4+j12 d. 1000+ j50

Q: Let q1 = 3x10 -8C and q2 = -5x10 -8C, distributed as indicated in the figure. Calculate the electric…

A: In this question we need to find the electric field at the points: (0; 0), (4; 0) and (-3; 0).

Q: Given the function f(a,b,c,d)=Em(0,1,2,6,7,8,9,14,15), find the minimum SOP form using a K-Map. Note…

A: In this question we need to simplify the given Boolean expression into minimum SOP form and draw…

Q: For the circuit below, given Vcc = 15 V, answer the following: (a) Choose component values such that…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: 8.49 PSPICE MULTISIM 72 V 50 Ω www 100 nF b t=0 5 ΚΩ www + Va 75 ΚΩ 2.5 H The circuit shown in Fig.…

A: In this question we need to find the voltage Vo(t) for t>0 .  At t= 0 switch at  position b and…

Q: the following circuit, find the valus of C that results in a resonance fequency of 1 rad/se Zin 1 F…

A:

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.