What effect would each of the following have on the calculated molar mass of an unknown, as determined using the Procedure described in this experiment? The balance was not zeroed before the three weighings of the test tube, sample, and water were made. This caused each mass measurement to be 0.102 g greater than it should have been.

Q: neonatal dispensing unit at your hospital trust. Whilst in the aseptic dispensary today, you are…

A: Given 0.9 % w/v means , 100 mL solution contains 0.9 g NaCl  Mass of NaCl = 0.90 g Molar mass of…

Q: How would you turn a qualitative experiment into a quantitative experiment?

A: Interpretation -  We have to explain how we can turn a qualitative experiment into a quantitative…

Q: Assuming complete reaction, what volume of 0.200 mol dm HCl(aq) is required to neutralize 25.0 cm of…

A:

Q: In preparation of cola, 2.50 mL of the original sample was taken and diluted to 100 mL resulting to…

A:

Q: Objective KTIOV A chemistry student weighs out 0.0434 g of sulfurous acid (H,SO,), a diprotic acid,…

A: Molarity is defined as number of moles per litre of solution.

Q: Part B Observe and record the appearances of the metal strips and the solutions in the test tubes.…

A: Appearance of metal and metal solution

Q: he Law of Conservation states that matter cannot be created nor destroyed during a reaction. How…

A: Hi, the first question is incomplete as the experiment is not given. Hence we are solving the second…

Q: There is a simple method available online on how to detect lead in lipstick. Find the method,…

A:

Q: What are the potential errors that could occur when using the Kjeldahl method to determine the…

A: Kjeldahl method principle : Strong acid helps in the digestion of food and liberates nitrogen which…

Q: Standardization of a sodium hydroxide solution against potassium hydrogen phthalate (KHP) yielded…

A: The chemical reaction between KHP and NaOH  is given by -                                     KHP…

Q: Aspirin yield You record the following data during the Qualitative and Quantitative Characterization…

A: Acetyl salicylic acid is also called as Aspirin Aspirin is used as an analgesic and antipyretic drug…

Q: About Sampling, tick only the incorrect alternative(s). Choose one or more: A) Identifying the…

A: Analysis are of two types: qualitative analysis and quantitative analysis. Qualitative analysis…

Q: When a candle is lit and allowed to burn for 15 minutes, some wax drips and collects at the base of…

A: (a) When a candle burns the physical change can be easily seen because the solid wax is converted…

Q: 18. If 5.0 grams of lead and 1.0 grams of sulfur are reacted according to the equation above, what…

A: We’ll answer the first part since the exact one wasn’t specified. Please submit a new question…

Q: Calculate the sodium hydroxide (MW = 39.997 g/mole) concentration in units of moles per kilogram of…

A: The solution is as follows:

Q: Differentiate between quantitative and qualitative chemical analysis with an example?

A: A question based on chemical analysis, which is to be accomplished.

Q: 17. Aiphonse Bertillon (1853-1914) devised the first sei- entific system of using a series of body…

A: 17) Alphonse Bertillon (1853-1914) devised the first scientific system of anthropometric using a…

Q: In each test, iron(II) sulfate and iron(III) nitrate were combined with the same substance or…

A: In each test, iron(II) sulfate and iron(III) nitrate were combined with the same substance or…

Q: A chemist needs to create a series of standard Cu2+(aq) solutions for an absorbance experiment. For…

A: In titrations, a standard solution is used; this is called a stock solution. It is diluted by adding…

Q: What are the types of errors (and their characteristics) in a chemical analysis?

A: There are different types of error which are recorded during chemical analysis  and they affect the…

Q: Is there a chemical reaction between copper and silver nitrate? Which elements react, and what is…

A: The chemical formula is a short term notation which is used to represent the no. of atoms present in…

Q: 1. Given that a theoretical yield for isolating Calcium Carbonate in this experiment would be 100%.…

A: A numerical problem based on percent yield, which is to be accomplished.

Q: Consider these compounds: A. BaSO3 В. Cr(ОH)з С. РЬСrO4 D. A93PO4 Complete the following statements…

A: Sulfite are soluble . All hydroxide,phosphate chromates Are insoluble in water.

Q: hydrochloric

A: According to the question, hydrochloric acid solution is standardized with contaminated sodium…

Q: 1. An Element from Group 1A and Group 7A (Periods 2-6) shared a Chemical Bond which formed a solid…

A: 1. The element present in Group 1A are metallic in nature while that of present in group 7A are non…

Q: what are the possible errors that could be encountered during the analysis?

A:

Q: A chemical reaction occurs in a closed system to observe and test the Law of Conservation of Mass.…

A:

Q: Calculate the number of moles of bicarbonate and acetic acid (vinegar) in each test tube in the…

A: Sodium bicarbonate is an amphoteric compound. Aqueous solutions are mildly alkaline due to the…

Q: Supposed that some magnesium oxide smoke escaped during the investigation. Would the MgO ration have…

A: 2 Mg + O2  gives  2 MgO So, 2 mol of Mg on oxidation would yield 2 mol of MgO.

Q: 3. Considering the techniques and instrumentation used to perform these experiments, identify 2…

A: A Calorimeter is a device that can be used to measure heat flow. it must be well insulated in order…

Q: 18. Which of the following is the most suitable vessel in which to perfom the experiment? (A)…

A:

Q: Purpose: This is the object or rationale for doing the experiment. It is what you are trying to…

A: To determine for each of the phrase below, whether they are a part of the purpose or part of the…

Q: You dilute the river water 10 times for the analysis of SDS concentration. The instrument measures…

A:

Q: C. The lead(II) oxide was weighed before and after the additions. d. - 19 18 17 16 before 9 15 ii.…

A: c. Mass of lead(II) oxide is added to dilute nitrile acid is (18.2 g - 14.4 g) = 3.8 g.   d. i)…

Q: an equation showing how the mass of the substance on the right column can be converted to the mass…

A: Mole of a substance = mass of a substance / molar mass of substance Mass of substance = mole of a…

Q: 6. When will you use each of these methods in chemical analysis?

A:

Q: A student adds 10.2 mL of 7.06 M of nitric acid to 0.5502 g copper turnings. What volume of 3.44 M…

A:

Q: Ten replicate analyses of the concentration of mercury in a sample of commercial gas condensate gave…

A: Answer

Q: Which of the following statements is incorrect? a. Safety shower would immediately be used if your…

A: Laboratory safety is very important in order to maintain a safe environment for the researchers as…

Q: When mixing sodium chlorate solution (volume 1.0L, density 1.1614 g/ml, mass fraction 22%)  with…

A:

Q: For Questions 20-24 consider the following scenario: A 0.8390 g of an unknown sample containing…

A: Given information: Mass of unknown sample = 0.8390 g Mass of filter paper and precipitate = 3.2174 g…

Q: 4.Determine the type of assay employed for this substance: ZINC OXIDE 5.The solvent used in making…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: c. The lead(II) oxide was weighed before and after the additions. d. 19 18 17 16 before 9 15 ii.…

A: Given: The balance before shows 17.8 g and the balance after shows 13.6 g. To find: Mass of lead…

Q: As part of the Compounds of Copper experiment, copper(II) carbonate is acidified with hydrochloric…

A: Answer - The correct option is (c) The recovery of copper will not be affected Solution - According…

Q: A student used a standard silver nitrate solution (0.1050 M) and standard potassium thiocyanate…

A: Calculate the total number of moles of silver nitrate present in the solution.

Q: Consider an iron bar on a balance weights 75.0g.   As the iron bar rusts, which of the following…

A: Interpretation: As the 75.0 g of iron bar rusts, then which of the given statement is true is to be…