What are the different properties of hardened concrete?
Q: 3. Determine the slope and vertical displacement of point A on the beam shown in the accompanying…
A:
Q: 6-15. Determine the force in each member of the and state if the members are in tension or…
A: Given : P1 = P2 = 5 kN Determine the force in each member of truss ?
Q: Rigid bar ABCD is supported by a pin connection at A and by two axial bars (1) and (2). Bar (1) is a…
A:
Q: Please answer it again in neat and good handwriting. the current handwriting is not at all clear.
A:
Q: A tank is 1.8m deep and square length of 4.5m at the top and square length of 3m at the bottom. The…
A: Given- Depth h=1.8 m, Length of square top b=4.5 m, Length of square bottom a=3 m, Density- ρ=936…
Q: the dry mass is 47.7 kg. The specific gravity of the soil solids is 2.70. Determine the wet and…
A:
Q: 1. A 100-kg steel rod with a length of 100 m and a cross-sectional area of 250 mm2 is suspended…
A: Using formula
Q: Item 2 The gas storage tank is fabricated by bolting together two half cylindrical thin shells and…
A: Given : The tank designed to withstand pressure of 3 MPa Allowable normal stress of tank material =…
Q: What is the effective depth of the given beam. (1 decimal) 2.What value of ?1 should you use in the…
A: Hi! Thank you for the question, As per the honor code and time constraints, we are allowed to answer…
Q: In removing a weak dam over a large reservoir what strategic analysis would you adopt in order to…
A: Solution: Dam: A dam is an earthen or concrete structure that is constructed across a river stream…
Q: A highway designed for 80 km/h speed has a horizontal curve section with radius 250 m. If the design…
A:
Q: The change in length of diagonal AB is un
A:
Q: Stadia Tacheometric Survey Problem 3. In the figure, the difference in elevation between observed…
A:
Q: How much bleaching powder is needed to chlorinate 5000l of water whose chlorine demand is 2 mg/l,…
A: Given data: Water to chlorinate = 5000I Chlorine demand = 2 mg/l Bleaching powder has 25 % available…
Q: A highway designed for 80 km/h speed has a horizontal curve sect If the design lateral friction is…
A:
Q: Determine the minimum applied force P required to move wedge A to the right. The spring is…
A: Given : Spring is compressed a distance of 170mm Coefficient of static friction = 0.35 To Find :…
Q: Calculate the area by Co-ordinates of ABCDE in HA. To (0.1 square m) B P [D] [E] Show all checks.…
A: To Determine :- Area of the Traverse ABCDE in Ha. by coordinate method.
Q: F₂ F₁
A: As there are multiple questions posted, according to the guidelines, only the first three are being…
Q: Stadia Tacheometric Survey Problem 3. In the figure, the difference in elevation between observed…
A:
Q: Problem 2 A square footing having a dimension of 3.5m is supported by a soil with the following…
A:
Q: P6.118 D = 12 in L = 1000 ft D = 12 in D=8 in L = 1500 ft L = 800 ft D = 15 in L = 1200 ft
A:
Q: A 6-mm steel wire is 5 meters long and stretches 8 m under a given load. If the modulus of…
A:
Q: the foundation can carry. Use Meyerhof's effective area method.
A: Use meyerhof's effective area method To find Maximum allowable load
Q: A storage tank of air, 30 inches in diameter, is to withstand an internal pressure of 180 psi with a…
A: Given:- d=30 inches internal pressure=180 psi design factor=3.5 C1020 annealed relative strength=92%…
Q: Need help for this. Thank you. Research for the present problems in the Philippines with regards to…
A: The Philippine economy's most important industry is transportation, which connects the country's…
Q: Q-A pelton wheel works under a head of 400m. Friction loss through the pipe flow is limited to 10%.…
A: Given- Head H=400 m, Friction loss =10%, Coefficient of velocity Cv=0.98, g=10 m/s2, It is needed to…
Q: D 75° 145°30' 135⁰ 90° C
A:
Q: The direct and indirect costs estimated by a contractor for bidding a project is Rs. 160000 and Rs.…
A:
Q: 7. Determine the component of F action in the direction of AD if F=(-237.3i+712j+276.9k)N and uab…
A: Given- A force vector F=(-237.3i+ 712j+ 276.9k) and vector uad=0.605i+0.777j-0.173k Required- To…
Q: A Pelton wheel with single jet rotates at 600 rpm. The velocity of the jet from the nozzle is 100…
A: Given data- Pelton wheel with single jet- Speed N=600 RPM, The velocity of jet Vj=100 m/s, Ratio of…
Q: The constant a for a steel material having an ultimate strength of 106.5
A: Column is an axially loaded vertical member which is used to take compressive load.
Q: A singly reinforced beam of dimension 200 x 350 is reinforced with 3-25mm at the bottom. the…
A: Singly reinforced beams are those with longitudinal reinforcement only in their tension zone.…
Q: 1.0 •1 0.5 1.0 10.0 The virgin compression curve with axes adopted as per convention in this regard…
A: Given data- Initial void ratio- ei=0.5, Final void ratio- ef=1, Initial stress- σ1=1, Final Stress-…
Q: Compute the slope and deflection at the free end of the cantilever bean shown. Use Double…
A: Given data Find slope and deflection at free end using double integration method. Assume EI =…
Q: A discharge of 1 cumec is flowing in a rectangular channel one metre wide at a depth of 20 cm. The…
A:
Q: A 60 ft. beam supports two applied distributed loads, a distributed load w1-248 pounds her linear…
A: A 60 ft. beam supports two applied distributed loads, a distributed load w1-248 pounds her linear…
Q: Analyze each of the following structures. Calculate reaction components, and construct shear and…
A:
Q: A plate 0.025 mm distant from a fixed plate, moves at 60 cm/s and requires a force of 2N/m² to…
A:
Q: A fully penetrating well in a 28.0-in thick artesian aquifer pumps at a rate of 0.00380 m3 ・ s−1 for…
A: Reference : Hydrology, Draw down well Given : The Thickness of well with pump rate of aquifer. Draw…
Q: 3. The transparent "biospheres" beneath the Bay of Noli, in Savona, Italy, are part of the…
A: Fluid mechanics : Fluid mechanics is the study of fluid dynamics at rest and in motion (liquids,…
Q: Solved Examples Q.6. Show that the natural period of a light weight with central point load is yo/g…
A: solution of above problem is below:
Q: At what depth in a stand pipe containing water will cause a pressure of 30 lb/in 2 ? a. Write the…
A:
Q: Find the Stress if Tensile force 2.3 N applied on rod having cross sectional area of 1 mm2
A:
Q: gligibl Solved Examples Q.6. Show that the natural period of a light weight with central point load…
A: solution of above problem is below:
Q: Calculate the forces in members BC, CD, and CG of the loaded truss composed of equilateral…
A: Given : Find forces in member BC, CD and CG ?
Q: 2. An archaeologist took some measurements on the unique mountain he had found. He sets two points X…
A:
Q: a graphical solution technique. Your drawing should Upload a pdf file of your final worked solution
A:
Q: An artesian aquifer 5 m thick with a piezometric surface 65 m above the bottom confining layer is…
A:
Q: What is the dry unit weight of a clay soil when the void ratio of a sample thereof is 0.50, the…
A: Given:- The void ratio of a sample = 0.50 The degree of saturation = 70% The specific gravity of the…
Q: Why is it necessary to measure the air content of concrete at the job site rather than at the batch…
A: Concrete is mostly filled with air to boost endurance whenever subjected to freeze/thaw processes…
What are the different properties of hardened concrete?
Step by step
Solved in 2 steps
- Chapter 13 Question: What is the elasticity of concrete for a normal weight mix (unit weight equal to 150 pcf) with a compressive strength of 5,000 psi? O 3.644 ksi O 4.074 ksi 4,287 ksi O 3.976 ksi O 3,834 ksiWhat are the properties of Self-Consolidating Concrete?Briefly discuss each properties of concrete. a. Compressive strength b. Flexural strength c. Tensile strength