Whale and Kanmuro are two islands located in the Chimera archipelago. These two are separated by a distance of 20 miles. A power link is to be established between them. The power link delivers a maximum power of 600 MW at full capacity with an operating voltage of 500 kV. Solve for the resistivity of the cable, assuming a conductor diameter of 1.5 cm. Express your answer in μΩ·m.

Whale and Kanmuro are two islands located in the Chimera archipelago. These two are separated by a distance of 20 miles. A power link is to be established between them. The power link delivers a maximum power of 600 MW at full capacity with an operating voltage of 500 kV. Solve for the resistivity of the cable, assuming a conductor diameter of 1.5 cm. Express your answer in μΩ·m.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.12MCQ

See similar textbooks

Similar questions

A 33 kV single core cable has a conductor diameter of 1 cm and a sheath of inside diameter 4 cm. Find the maximum and minimum stress in the insulation.
A 30 kV single core cable has a conductor dimeter of 2 cm and a sheath of inside diameter 6 cm. Find the maximum (peak value) and minimum stress (peak value) in the insulation.
Each conductor of a 3-0 overhead line is suspended from a cross arm of a steel tower by a string of 4 suspension insulators. The voltage across the third 33 kV. The shunt capacitance between each insulator and the earth is 1/8th of the capacitance of the insulator itself. Find the voltage across string and string efficiency. D-128 Lod Fa
A double-circuit its capacitance to neutral per mile. line is shown below. The conductor radius is 0.0452 ft. Determine 16' 16' a b 22' c' b' a'
12. There are 6 conductors in a double circuit line. Each conductor has a radius of 12 mm. The 6conductors are arranged horizontally. The center to center distance between the conductor is 2m. The sequence of conductors are from left to right as follows: a,b.c,a', b', c'. Calculate the inductance per km per phase of system. the a' 2 m 2 m 2 m 2 m 2 m
A single core cable is to be used for 66 kV to earth. Its conductor diameter is 2 cm and its three insulating materials have permittivity 5, 4 and 3 respectively. The corresponding safe maximum stresses are 38 kV/cm, 26 kV/cm and 20 kV/cm, respectively. Find the minimum diameter of the sheath.
The maximum and minimum stresses in the dielectric of a single core cable are 40 KV/cm (rms) and 10 KV/cm (rms) respectively. If the conductor diameter is 2 cm, the insulation thickness is?
A three phase, 11 KV, underground cable system, consider a single core of conductor radius 0.5 cm diameter and lead sheath of 1.25 cm. The core and lead sheath have been separated by two intersheaths with radius 0.75 cm and 1 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same.
The maximum and minimum stresses in the dielectric of a single-core cable are 40 kV/cm (r.m.s.) and 10 kV/cm (r.m.s.) respec- tively. If the conductor diameter is 2 cm, the insulation thickness is
Determine the GMR of each of the unconventional stranded conductors shown in Figure 4.30. All strands have the same radius r.
Assume that a single-conductor belted cable has a conductor diameterof 0.681 in., inside diameter of sheath of 1.7025 in., and a length of8000 ft. The cable is to be operated at 12.47 kV. The dielectricconstant is 4.5, and the power factor of the dielectric at a ratedfrequency and temperature is 0.05. Calculate the following:(a) Capacitance of cable.(b) Charging current.(c) Dielectric loss of cable.(d) Equivalent resistance of insulation.
A three phase, 33 KV, underground cable system, consider a single core of conductor radius 0.8 cm diameter and lead sheath of 2.3 cm. The core and lead sheath have been separated by two intersheaths with radius 1.3 cm and 1.8 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same. Please i need it know please