water supply scheme transports 20 MLD (Million Litres per Day) water through a 500 mm diameter pipeline for a distance of 2.5 km. A chlorine dose of 3.50 mg/litre is applied at the starting point of the pipeline to attain a certain level of disinfection at the downstream end. It is decided to increase the flow rate from 10 MLD to 13 MLD in the pipeline. Assume exponent for concentration, n= 0.96. With this increased flow, in order to attain the same level of disinfection, the chlorine dose (in mg/litre) to be applied at the starting point should be

water supply scheme transports 20 MLD (Million Litres per Day) water through a 500 mm diameter pipeline for a distance of 2.5 km. A chlorine dose of 3.50 mg/litre is applied at the starting point of the pipeline to attain a certain level of disinfection at the downstream end. It is decided to increase the flow rate from 10 MLD to 13 MLD in the pipeline. Assume exponent for concentration, n= 0.96. With this increased flow, in order to attain the same level of disinfection, the chlorine dose (in mg/litre) to be applied at the starting point should be

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q2/ Calculate the gas flow rate in sef/day for a natural gas is following in porous media at temperature (60° C) with specific gravity of (0.72). The pressures of downstream and upstream are (128.89 atm) and (142.86 atm) respectively. The radius is equal (11.54 meter). The absolute permeability is (60 md) with a total length (762 meter).
We have a 20 meter long pipe for sewage transfer. If the mass percentage of solids in the effluent is 0.5%, calculate the minimum slope of the pipe so that the solid does not settle in the pipe.
Water Gs=1 1. In a test to determine the discharge coefficient of a 70 by 35 mm Venturi meter, the total weight of water passing through the meter in 5 minutes was 3.5 kN. A mercury differential gage connected to the inlet and throat of the meter showed an average mercury difference during that time of 300 mm.. Determine the actual discharge if the same meter is used later on and a 250 mm difference is then observed. Mercury, Hg Gs = assume, 4 significant figures 2. The diameter of a 3 meter pipe decreases from 450 mm to 150 mm. If the velocity is to decrease uniformly in a linear manner, draw the diameter profile at each 500 mm length interval along the pipe. Discharge is 150 liters per second. Reservoir B 3. A pump draws water at 300 liters per second from reservoir A and lifts it to reservoir B as shown. The head loss from A to 1 is 20 times the velocity head in the 200 mm diameter and the head loss from 2 to B is 20 times the velocity head in the 150-mm diameter pipe. Assume your…
Q3: the 2000 gallon tank initially contains 600 gallons of water with 5 lbs of salt dissolved in it. Water enters the tank at a rate of 9 gal/hr and the water entering the tank has a salt concentration of 0.2 (1+cos(t)) lbs/gal. If a well-mixed solution leaves the tank at a rate of 6 gal/hr, how much salt is in the tank when it overflows?
At a small water treatment plant which has 4 filters, the rates of filtration and backwashing are 200 m³/d/m² and 1000 m³/d/m² respectively. Backwashing is done for 15 min per day. The maturation, which occurs initially as the filter is put back into service after cleaning, takes 35 min. It is proposed to recover the water being wasted during backwashing and maturation. The percentage increase in the filtered water produced (up to two decimal places) would be
Environmental engineering
Glycerin flows at 35 m through a 150 mm diameter new wrought iron pipe at a velocity of 3 m/s. It has an absolute viscosity of 1.50 Pa-s and a specific gravity of glycerin = 1.26. 2. What is the type of flow?
Problem 4. A vessel contains 200 Liters of brine with 30 grams of dissolved salt. Brine containing 1 gram of salt per liter enters the vessel at 4 liters per minute. The solution is kept thoroughly mixed and drains from the vessel at the same rate. Calculate the amount of salt in the tank after 5 minutes.
Wasterwater Engineering Civil engineering
Question - There is a small spill of a toxic material on a paved surface of a chemical plant. This spill has width 0.8 ft and a length of 2.5 ft. The wind is a 10 miles per hour in the direction parallel to the length of the spill. Estimate the rate of evaporation in grams per hour. There is no toxin in the air at time 0 and at infinite distance from the spill. Assume air to behave as an ideal gas. Assume the toxic material can be considered an ideal solution with psat = 22 mmHg. MWtoxin = 164.4 g/mol, Ptoxin =1.69 g/cm³, Pair = .001225 g/cm³, Hair= 0.0187 CP, MWair = 28.9 g/mol, Dtoxin,air = 0.0888 cm²/s.
None