Water is draining from the bottom of a cone- shaped funnel at the rate of 0.8 ft³/sec. The height of the funnel is 6 ft and the radius at t top of the funnel is 5 ft, as shown in the imag below. At what rate is the height of the water the funnel changing when the height of the w is 4 ft? Submit an exact answer in terms of . Provide your answer below: dh dt ft/sec 5

Water is draining from the bottom of a cone- shaped funnel at the rate of 0.8 ft³/sec. The height of the funnel is 6 ft and the radius at t top of the funnel is 5 ft, as shown in the imag below. At what rate is the height of the water the funnel changing when the height of the w is 4 ft? Submit an exact answer in terms of . Provide your answer below: dh dt ft/sec 5

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The water of a 14’ × 48’ metal frame pool can drain from the pool through an opening at the side of the pool. The opening is about h = 1.05 m below the water level. The capacity of the pool is V = 3740 gallons, the pool can be drained in t = 10.2 mins. P0 is the pressure of the atmosphere. ρ is the density of the water. a. Write the Bernoulli’s equation of the water at the top of the pool in terms of P0, ρ, h. Assuming the opening is the origin. b. Write the Bernoulli’s equation of the water at the opening of the pool in terms of P0, ρ, h and v, where v is the speed at which the water leaves the opening. Assuming the opening is the origin. c. Express v2 in terms of g and h. d. Calculate the numerical value of v in meters per second. e. Express the flow rate of the water in terms of V and t. f. Express the cross-sectional area of the opening, A, in terms of V, v and t. g. Calculate the numerical value of A in cm2
A pump has a brake horsepower of 39 hp with an efficiency of 81%. Neglecting frictional losses, calculate the volume flow rate (m³/min) if the discharge is raised 60 meters above. Round your answer to two decimal places.
Q2) Oil flows through a pipe as shown in fig2. The coefficient of discharge for the orifice in the pipe is C.-0,63. What is the discharge of oil in the pipe? P1-P2 P1-P2 V22-V₁² Let: -4.48. Y 100-mm-diameter, sharp-edged orifice (2) 250mm 6.958 Heavy oil
Water is being drained from a comical tank at a constant rate of 8.49 cubic feet per minute. The height of the tank is 12 feet and the radius is 9 feet. At what rate (in feet/minute) is the depth of the tank changing when the water level is 2.25 feet? [Give your answer as a decimal rounded to 2 decimal places] +9 ft → 12ft depth (h)
A turbine with a power coefficient Cp = 0.26 is able %3D to generate 3.5 MW of electrical power with blades of length R =61 m. What is the value of the wind speed? Calculate the value in meters/second and round off to two decimal places. Do not write the unit.
10- Find the height of blood in the capillary tube resulting from the addition of (10 cm') of blood in a capillary tube of length (2.7 cm) and diameter (0.05 mm), knowing that the time of blood flow in the tube (5 sec) and the viscosity of the blood (2.3x10* pas.sec) and density of blood (1.051 - gm )? cm
At a point in turbulent flow the mean kinetic energy of the turbulent velocity fluctuations is k = 0.9 m² s-2, and the known values of the turbulent velocity fluctuations are U - 0.4 m² s-2, 'u What is the value of -0.5 m² s-2. = value of ...21 U 3? Give your answer to two decimal places.
Flow takes place between three reservoirs, as shown in Figure 1. The volume flow rate out of reservoirs A and B is 0.15 m3/s and 0.25 m 3 /s respectively. If the coefficient of friction for the three pipes is 0.008, determine the relative elevations of the free surfaces. Neglect all losses other than friction. Below attached is the sketch Make use of bernoulli equations if possible show all formulas and all values that are substituded
Water is discharged from a reservoir into the atmosphere through a 80 m long pipe. There is a sharp entrance to the pipe and the diameter is 250 mm for the first 50 m. The outlet is 35 m below the surface level in the reservoir. The pipe then enlarges suddenly to 450 mm in diameter for the reminder of its length. Take f 0.004 for both pipes. Calculate the discharge.
cylindrical syringe is filled with oil and the density is 0.855 g/cm3. (a)What is the pressure of the oil that is touching the plunger? Give your answer in Pascals (Pa). use Bernoulli’s equation and the equation of continuity to solve this. b)Find the volumetric flow rate of the oil coming out of the syringe, incm3/s
Water is to be pumped from a lake to a ranger station on the side of a mountain (see figure). The length of pipe immersed in the lake is negligible compared to the length from the lake surface to the discharge point. The flow rate is to be 95.0 gal/min, and the flow channel is a standard 1-inch. Schedule 40 steel pipe (ID = 1.049 inch). A pump capable of delivering 8 hp (= W, ) is available. The friction loss F (ft-lbf/lbm) equals 0.0410 L, where L (ft) is the length of the pipe. %3D
1) Consider the wave of small wave elevation in water of infinite depth. By linearization the water fluid flow can be described by velocity potential o which satisfy linear equations. i. For the wave described by: o ekz sin(kx – wt) and 3 = acos(kx – wt) show that: a. The potential energy in a wave length is Apga?/4. b. The kinetic energy in the wave length is Apga?/4 as well.