VR1 w 2k R2 8kQ www VR2 V2 VR3 10 R3 w 10kA R5 ww 10kQ 10 VR5 R4 10kg 10 VR4

Q: I+ Iェ-I,=0 R= 33052 生っ Lett: 6.98- luw I, -(00I; = 0 -(2) I. I, I3 Right : 15-330I2- lWT,=0 6.98V…

A: The giving circuit diagram is shown below, R1=100ΩR2=330Ω

Q: Solution :- D, Do Po a) D, = Q, Qo + Q, Qo = Qo(Q, +Qi) D, = Qo Po Do = Qi Q + Q Po Q, ( Qo + Qo)…

A:

Q: Per form the following operations. (3+ j2) (4t j5) /(2+tj3j?

A:

Q: 1 Ia = ?? A 2.ib= ?? A 3 Vx = ?? 4 power at Rx = ?? 5 power at Rb = ??

A:

Q: Power factor PF                                          PF=______________ Define the units of VA…

A: The power factor is the cosine of the angle between the voltage and the current phasor. The current…

Q: As shown in the figure, two metal plates are connected to a voltage Source the seperation astence…

A:

Q: 3.) E=20v 452 1002 th 222 Find the ff a.) RT b.) It a) Ix Vy ८८. 62 1552 d.) Xy e.) I₂ f.)PL 522…

A:

Q: Determine the values of resistance R and inductance L

A: We need to determine the values of R and L.

Q: Q1. Estimate the unknown value of inductance (L1) for the circuit shown in Figure A. A L1 = L4 1.5mH…

A: Here, Inductances L4,L5 and L6 are connected in series. which gives a resultant L'…

Q: us 202 voz inge του us vas mo n suoh зол

A: It is given that:

Q: Alternating Current System A series connection of a 30-ohm resistor and a 100-mH inductor is…

A:

Q: A series circuit consisting of a variable resistor in series with a capacitance of 80UF is connected…

A: Power observed in resistor = current2×resistance.  First calculate expression for current in terms…

Q: D I₁ + t=0 VR R - iR + UL elle L Vc + - Tic C

A:

Q: 5: For the coupled circuit shown in Figure 3, find the voltage across the capacitor of -j102…

A: Given

Q: Q/ Given the circuit in the figure below , and K=1 , find the currents Ij and I2. j@M 10 0 100 1020°…

A: Given circuit, and, K = 1

Q: Draw AC and DC equivalent circuit for the circuit given in Figure 4. (1 33KO Rs 2.2KN C. 10uf I, G…

A: For drawing dc equivalent circuit capacitor will be open circuited as capacitive reactance will be…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,664 ohms %3D R2 =…

A: In the given series circuit  R1= 1664 ohms R2= 1999 ohms Total R = R1+R2            R =3663 ohms…

Q: What is the value of the R to get the full deflection??

A: Using the virtual ground concept, the voltage at the non-inverting terminal will be equal to the the…

Q: klst2) Sketch vi0ot Jocus and also G Is) HIS) = %3D S+25+6 detevimine W at K=1-33

A:

Q: V₁ +1 R₁ www R2 ww + Xt = 0 UL - elle L iL

A:

Q: I'm reading about the electronics in touch screen. It says when i touch the panel it distorts the…

A: According to the question, we need to explain the working of the touch screen.

Q: Which figure below shows the correct vector relationship between voltage and current in a series LC…

A: The phasors,

Q: A line consist of a pure resistance and a coil in series. The power dissipated in the resistance is…

A: In this question,  We need to Find the voltage at the sending end? We know P= VI watt Where V…

Q: T1 300 OA OV 120V(RMS) R1 60HZ D1 R2 5k 10:1 1N4004

A: In the positive half cycle, diode will be in the reversed bias, it behaves as an open circuit.…

Q: E 120 Vrms 60 Hz 30° R1 1002 L1 m 150m H L 0 A D R 5002 L 250m H R3 2502 C1 HH 30μF E1 150 Vrms 60…

A: To find the current that goes through the load first convert the above circuit into the rectangular…

Q: For the circuit shown below, write the mesh equations using Ia, IB, and Ic, as specified in the…

A: From looking at the circuit, the mesh current for mesh 1 is IA=I1 and for mesh 2 is IC=-I2. Assuming…

Q: Iaa = A a ) 69000Z0° 450j ohm 600 ohm 69000Z120° b 600 ohm 450j ohmg 69000Z-1209 IbB = B 450j ohm C…

A:

Q: The answers are in rectangle form

A:

Q: Q5] find the current of the resistance 180 if the value of the source is 7.4sin(100ft-44) volt Give…

A: 5) To find the value of current flowing through 18 ohm resistor in the circuit

Q: Node Voltage Method: To find V1 V1 – 0.56 V1 V1 Z1 Z2 = 0 Z3 + Z4 + Z5 V1 – 0.56 -1.457462849j V1 V1…

A: KCL states that algebraic sum of current at a node must be equal to zero. It is also called nodal…

Q: For the Cicuit shown 'in Figure Vec=9V , ßc =1.8 K^ b=100 Zo=? $ Bc 39kh 22K s Ai = ? Res? C3 Cz Zis…

A:

Q: Determine the currents IR1 and IR2, (show as positive values – actual current direction).  Verify in…

A: Given circuit is We need to determine the currents IR1 & IR2 and verify the results using…

Q: A DC source has an open circuit voltage of 189 V and an internal resistance of 3.1 ohms. The value…

A:

Q: A RL circuit has a battery emf E=-22V and a switch closes at 0.0s. At t=1.25s, the ammeter=0.2A. If…

A: Considering the current equation in RL circuit. It=I∞1-e-RtLI∞=steady state currentI∞=ERI∞=2240…

Q: What is load regulation?

A:

Q: Shown in the figure is an RL series circuit in which R= 10 ohms and L= 0.1 Henry. This is energized…

A: In this question,  Find the time when pressure across the resistance and inductance are same.…

Q: The maximum efficiency for pure inductance load and iron-losses = cupper losses is zero. O True O…

A: Given data,  For Pure inductive load , Resistance = 0. Given, iron losses = copper losses. For pure…

Q: 9. The initial rate of current rise in an R-L circuit is 800 amps per sec when 453 volts is suddenly…

A: (9) Given  Initial rate of rise of current in the circuit is 800 amp/sec. i.e   di/dt = 800 amp/sec…

Q: 5 Please draw De ond put graph fa he givere 5. cizanid. Assume he diede is ideal. Osv -ob

A: The solution can be achieved as follows.

Q: An R-C series circuit has a supply voltage of 100 V. The resistance is 200 ohms and the capacitance…

A:

Q: In the circuit in the figure, the primary current is read as 3.603mA. Two windings were used as…

A: The transformer has a primary and a secondary side. It converts electrical power to electrical power…

Q: what is the block diagram for this circuit.

A: Given circuit is a light fence circuit that is is used to detect presence of any human or object in…

Q: 181, + j6(I1 – 12) + 4(I1 – 12) = 1020° -j1212 + 8(12 – l3) + 20490° + 4(I2 – 1) + j6(I2 –1) = 0…

A: Here, we have given an electric circuit.  We are testing an electrical device. So, we have to…

Q: FInd output voltage and output current for the given power supply

A: