Volumes Weight Va= అదికలయకు Vina L.Quid WwE Wm= Vs= Salid

Q: Determine the value of dry unit weight if bulk unit weight is 20.45 KN/m3 and water content value is…

A: step 1-

Q: Table Q2(b)(i): Result of bulk density and water content from proctor compaction test Bulk density…

A:

Q: A mud sample containing 40lbm/bbl clay has a dial-reading value of 30 cp (at 600 rpm). Calculate the…

A: A plastic viscosity (PV) of the drilling fluid is calculated by subtracting the 300-rpm shear stress…

Q: For constant head laboratory test on fine sand, the following values are obtained. Length of…

A: we knowk=QLAhtQ=0.044in3L=10inA=π42.52h=22int=2minso,k=0.044in310inπ42.52×22in×2mink=0.002037inmin

Q: A cylinder has 500 cm3 of water. After a mass of 100 grams 1) A) of sand is poured into the cylinder…

A: NOTE : Since you have asked multiple questions, we will solve the first question for you. If you…

Q: A sample of 500 g dry sand, when poured into a 2-litre capacity cylinder which is partially filled…

A: Given data : Mass of solid (M)=500 gVolume of solid (V)=188 cm3Density of water (ρWater )=1 g/cm3

Q: From the following data, solve for the degree of compaction. If this is for Item 201, Aggregate Base…

A:

Q: Compute the coefficient of permeability of the sand filler in cm/s. Use 4 decimal places

A:

Q: A sand cone in place unit test was conducted on the field during the construction of the embanklment…

A:

Q: A sand cone in place unit test was conducted on the field during the construction of the embanklment…

A:

Q: 2.11 A sand has the following: Do = 0.2 mm, D = 0.4 mm, and void ratio e = 0.6. a. Determine the…

A:

Q: A sample of 500 g dry sand, when poured into a 2 litre capacity cylinder which is partially filled…

A:

Q: For a constant head laboratory permeability test on fine sand, the following values are given:…

A:

Q: Giventhe figure below and considering a downward flow, forthe sand the following are its properties…

A: Hello dear Please see the attached solution, thanks

Q: The results from a compaction test are as follows: 130.0 128.0 126.0 124.0 122.0 120.0 118.0 116.0…

A: given compaction test result curve, X axis is water content and Y axis is dry unit weight.Water…

Q: Question 11 A cylindrical sediment core sample with the dimensions: diameter = 10[cm] and length =…

A:

Q: The value of hydraulic conductivity of the sand is 0.010 cm/sec for porosity of 0.4. Determine the…

A: Given: n1 = 0.4 K1 = 0.010 cm/s n2 = 0.55

Q: Determine the value of void ratio if porosity is 0.402 a:0.65 b:0.69 c:1 d:0.67 e:None of the above

A:

Q: For a constant head laboratory permeability test on fine sand, the following values are given:…

A:

Q: 3. The following results were obtained from a liquid limit test on a clay using the Casagrande cup…

A: Given, Casagrande cup device test data  In situ water content = 38%

Q: 2. A sample of saturated clay was placed in a container and weighed weight was 6N. The clay in its…

A: As per our guidelines we are supposed to solve only 3 subparts if multiple subparts are asked .…

Q: Proctor Test in English unit Method A

A: For Standard proctor test :Compaction effort :E=number of BlowsPer layer×Hammer Weight×Number of…

Q: Sieve Size Sieve opening (mm) Percent Finer 3 in. 76.2 100% 2 in. 50.8 90% 1 in. 25.4 80% #4 4.75…

A: Given the sieve sizes and percentage finer soil in those sieves.

Q: what is the moist unit weight of compaction (kN/m3)

A:

Q: Explain M vs. q, for Ticino Sand (from Jamiolkowski et al. 1988) ?

A: The M vs q for the Ticino sand is the representation of the second correspondence  to increase in…

Q: QI: The Results Of A Sand Cone Test Are Shown Below: Jar + cone (before test) = 7698 gm Jar + cone…

A: Field dry density of the sand = γbulk1+w Here,             w  = water content of the sand = 6% or…

Q: 737 grams of dry sand completely fills a 500 cm³ permeameter tube. The specific gravity of the sand…

A:

Q: Show calculation on how to determine the average coefficient of permeability of the sand samplea…

A: The permeability is given by: k=qAi Where, q = Discharge A = Area i = Hydraulic gradient

Q: 7.17 The grain-size analysis data for a sand is given in the following table. Estimate the hydraulic…

A:

Q: |!;9 ELABORATE Try solving the following problem: Practice Problem: The following are the results of…

A:

Q: A sand cone in place unit test was conducted on the field during the construction of the embanklment…

A:

Q: An oil tank, 20 m in diameter, is built over a site shown below. A specimen of clay in this site (20…

A:

Q: r to the figure above. For a constant head permeability test in a sand, the following values are g…

A: L=37cm t=3min h=46cm A=125cm2 Volume=550cm3

Q: 8.2 The results of a laboratory consolidation test on a clay sample are given below. Pressure, o…

A: Given:- The results of a laboratory consolidation test on a clay sample are given below.

Q: Data taken from a Liquid Limit test on a clay using the Casagrande cup device. The natur water…

A: Casagrande cup device test is used to determine liquid limit on a clay Liquid limit of soil is…

Q: The total density of a sand in an embankment was found to be 1990 kg/m3 and the field water content…

A:

Q: Bulk Unit Weight (kN/m3) 20.0 20.7 21.7 21.4 21.1 Water Content (%) 8.0 9.5 11.5 12.5 13.5 1.…

A:

Q: The saturated clay sample was weighed in a container and the total weight was 7.4 N. 24 hours 105…

A: Conversion of weight to kg from Newton by dividing wt by 9.81 And unit weight from density by…

Q: A soil sample has a bulk unit weight of 17.5 kN/m^3 at a water content of 10.1%. Use Gs=2.58…

A:

Q: The hydraulic conductivity of a sand at a void ratio of 0.85 is 0.08 cm/sec. Estimate its hydraulic…

A:

Q: A coarse sand sample 17 cm high and has a radius of 2.27 cm. It is placed in a constant head of of…

A:

Q: A cylindrical sediment core sample with the dimensions: diameter = 10[cm] and length= 30[cm] is…

A: Figure and data is as shown in the question

Q: QUESTION 19 From a compaction test, if you are given: Water content (%) = 13.2 Bulk unit weight…

A: Use formula of dry unit weight in terms of bulk unit weight and water content.

Q: A sample o f soi l compacte d accordin g t o a standar d Proctor test ha s a unit weight of 130.9…

A: Given: The unit weight of soil is 130.9 lb/ft3. The water content is 14%. The specific gravity is…

Q: sand cone in place unit test was conducted on the field during the construction of the embanklment…

A:

Q: For a given soil, derive the following relation by drawing the three-phase diagram: Y: = Gs yw (1 -…

A:

Q: The rate of upward seepage taking place through a granular soil contained in a tank is 976.5…

A:

Q: What is the 95% maximum dry density from the laboratory (Please answer in two decimal places in…

A:

Q: A soil sample has a bulk unit weight of 20.0 kN/m^3 at a water content of 8.0%. Use Gs=2.56…

A:

Q: A modified Proctor compaction test was carried out using a cylindrical mold with a 1000 ml volume.…

A: Formulaeρ=Wet massVolumeρdry=ρ1+wρzav=Gρw1+GwExample:at…

Weight-Volume relationships

Weight is defined as the quantity of matter contained in a body. Weight can also be defined as the force acting on a body due to gravity. Mathematically, weight can be defined as-