+ Vi Zi + RL Vo For the amplifier circuit in the accompanying figure, let Z; = 10 kW and RL = 250W, and Ap = 35db. When V; = 250 mV, find the output voltage and power level. 200 V, 50 mW 2 V, 20.2 mW 2.2 V, 19.76 mW 20.45 mV, 0.2 mW

Q: Any example traced in your reading material, connections between the current and the potential…

A: Correct option is c.

Q: Take a look at the wire supplying your house, another residential house, commercial and industrial…

A: Wires selection is an important decision while designing the electrical connections for the…

Q: Describe the job of the Board of Electrical Engineering in one sentence. Note: The Board of…

A: It is asked to describe the job of the Board of Electrical Engineering in one senctsen.

Q: Question (1): With proper example and circuit diagram briefly explain the following theorems.  (i)…

A: The evaluation of electrical circuits containing different circuit components and power sources…

Q: (b) Explain the different types of diversity technique ** *'used communication system. in wireless

A: Given that  Explain diversity techniques in wireless communication system

Q: What is sub station

A: A power station is to provide electricity to a huge number of people. Different customer’s power…

Q: An electric train system (ETS) in Japan with a span of 10 miles long is connected to a two…

A:

Q: 1.verify (Kc) and (KUL)) ?

A:

Q: A high voltage transmission line transmitting 10 MW of power operates at a voltage of 105 KV…

A:

Q: What is the maximum number of 15 ampere lighting circuits required if the dwelling has an occupied…

A: Refer the table 220.12 from the NEC, the minimum load requirements for the dwelling load unit is,

Q: What is a FET

A: The modern day devices have enabled us an easy life. The devices have various electronic components…

Q: Question 5- Power Network, Frequency & Connected Load a) In the UK and many other countries, there…

A: The legal requirement to maintain the voltage and frequency with permitted tolerances is due to the…

Q: Q1:A) Determine whether or not systems below is Time - Invariant, Causal and Linear: y(n) = x(n²) 1

A: Introduction Linearity: If a system exclusively performs linear operations, such as scaling,…

Q: a) Draw the block diagram of a measurement system.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Inverting Op-Amp R₁ R₁ Vo R2 R4 998.48m V R2 R3 9.9844 R1 R4 2.1244 out of phase A(gain) A(gain)…

A:

Q: What is the difference between passive and active buzzer?

A: A passive buzzer requires an ac signal to make a sound. A passive buzzer does not generate a tone by…

Q: How much longer is an individual, without hearing protection, permitted to work at a location where…

A: How much longer is an individual, without hearing protection, permitted to work at a location where…

Q: QI\ Define standard of measurement and explain categories that standard of measurement classified to…

A: Here we will define standard of measurement and we will also explain the categories of standard of…

Q: 7. Which chapter of the National Electrical Code covers communications systems installations and…

A: In the National Electrical Code chapter 8 , covers the communications systems installations…

Q: Please explain it briefly in detail.

A:

Q: 1. Define two (2) types of Power Electronics application with diagram and gives one for each types.…

A:

Q: Write a paragraph about your hopes and ambitions. In about 100 words

A: Hope and ambitions are the most important part of any human which can include the happiness of…

Q: d) None of these. 5. Materials which easily allow the passage of electric current are known as: a)…

A: Answer 2- The power is defined as a rate of doing work.  So, option (c) is correct.   Answer 4- An…

Q: P-channel MOSFET is basically a following device. a. voltage operated O b. low-frequency operated O…

A: MOSFET is controlled by the application of GATE pulse .  GATE pulse controls the conduction state of…

Q: Look at the photo and answer the questions

A:

Q: V1 Op-amp V; = 0 Rf R1 R1 Fig. 3.11 (a) Non-inverting amplifier (b) Equivalent circuit with virtual…

A:

Q: Show the following units in scientific notation. e.g ) Five Kilometre (km) = 5 x 103 m 1) One…

A: Consider solving the problem by using the second notation (which decides the exponential power of…

Q: Can you please further explain this section.

A:

Q: 3. In the circuit below find V (x) for t > 0 if i(0) = 6A. 6 H ell 10Ω 0.5i Vx 40 2 +

A: Source Transformation- Source transformation is a method in which the supply source in any…

Q: A protective put can be used for risk management.   A. TRUE B. FALSE

A: ANSWER      TRUE          A protective put can be used for risk…

Q: Hi for case 3 is explain on which question ? either (a) positive or negative or for question (b) pls…

A:

Q: The circuits branch is defined as: Select one: a. a single path in a network, composed of one source…

A: The circuits branch is defined as,

Q: (a) aluminium, (b) copper, (c) iron, (d) magnesium, and (e) zinc?

A: Aluminum, Magnesium metals are used as the Matrix material in fiber-reinforced MMCs.

Q: In an electrical system, each of the service entrance conductors has an area of 750 kcmil. The size…

A: Given: In an electrical system, each of the service entrance conductors has an area of 750 kcmil.

Q: On a short/long bond paper, draw a schematic circuit diagram following your house wiring with…

A: electrical wires are designed to bear consistent electric current which should not lead to a fire in…

Q: 3. What must be the speed of a six-pole 25-Hz synchronous generator? 500 грm a) b) 900 гpm c) 1200…

A: NOTE: “Since you have asked multiple question, we will solve the first question for you. If you want…

Q: what is the statement of Lenz law.

A: Lenz's Law states:"The direction of an induced electromotive force (EMF) and the resulting current…

Q: Look at the photos and answer the questions

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: What is the importance of Code of ethics of Electrical Engineer in students?

A: The Code of Ethics for Electrical Engineers plays a crucial role in shaping the behavior and…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.