Vhat would be the barrier potential of a silicon diode when the junction emperature is at 10°C? Assuming a barrier potential of 0.7V at an ambient emperature of 25°C. D 0.73 V D0.62 V D 0.75 V D 0.78 V

Q: A transformer with a 240-V ac primary voltage and a 6:1 turns ratio has an output voltage of O 1,440…

A:

Q: When we denote the direction of the line currents in a balance load, balance source system, t is…

A: Load is part of the electrical system which consumes the electrical power generated. The current is…

Q: QUESTION: Derive the transfer function, TH(s), and find the high corner frequency from the transfer…

A:

Q: 30 20 MADE IN JAPAN 10 50 5 o| 500 200 100 10 21 0 100 20 4 150 30 6 200 40 50 2 250 10 2 .5 1 +10…

A:

Q: 49). A distribution transformer is rated at 100 kVA. If the load p.f. is 0.707 lagging, the active…

A: Given a distribution transformer has, Rated kVA rating, S = 100 kVA Load power factor, cosϕ=0.707

Q: In a phasor domain circuit, 220L30° V is applied across two series components, one of which is a 20…

A:

Q: A station transmits with 50 Watts transmitter power and 6 dB antenna. A) What is the effective…

A: The solution is given below

Q: Find the phase difference between these two. Also mention which one is leading. (i) I = 2 cos…

A: In this question,   We need to determine the phase difference between current and voltage?

Q: Compose the mesh equations. 10 Q j10 Q ... j10 Q ll ll ) 10 V [1] sine j5 V sine [12] -j10 0 @mesh…

A: The solution is given below

Q: 23.) If the range selector knob is set to 250 ACV, what would be the voltage reading of the yellow…

A:

Q: 12 v (+ Transform the circuit such that the 3 k2 resistor is le unchanged and the final circuit…

A: In this question we will find current i using source transformation and power dissipation in 3 kilo…

Q: (c) Find the frequency response (magnitude and phase response) of a system at an angular frequency…

A:

Q: R, I, V2 60V V, Figure 8-2. CALCULATED POWER POWER SUPPLIED VALUES DISSIPATED (1, x En) V, = V %D R1…

A:

Q: a) I) Sketch (with full labelling) an example of each of a random, energy, power signals. i) Sketch…

A: Random Signals: The lack of predictability characterizes a random or stochastic signal. In contrast…

Q: A 50 ohms load resistance is connected across a half wave rectifier. The input supply voltage is…

A:

Q: To place a text on the plot using a mouse, the command used is a) gtext O b) text O c) title() O d)…

A: If we want to place a text at a position of our interest in a graph we need to use the gtext command…

Q: 3. Design an FIR filter by using the Z-plane which nullifies these five frequencies: T 2n 3n 0,7 4 4…

A: Given,The five frequencies of FLR filter are,0, π4, 2π4, 3π4, π

Q: PREFINALS TASK 2 Give the truth table of the ff. Boolean expressions: 1.) F=(A'CB+ AB)' 2.) F = (DA'…

A: The solution is given below

Q: What is the effective isotropic radiate power (EIRP) in W? (Use two decimal places for the final…

A: The solution is given below

Q: balance Y-connected load of ( 3 + j8 ) ohms per phase is supplied by a balanced three-phase, 60 Hz,…

A:

Q: (c) The DFT matrix given in Figure Q2 (c) uses twiddle factors (Wk) to compute the 4-point DFT…

A:

Q: The equation of an angle modulated voltage is e = 20 sin (30000 t + 2 sin 100 t). Calculate the…

A: In this question angle modulated voltage is given....We have to find out carrier and modulating…

Q: In the circuit shown below, a three-phase star-connected unbalanced load is connected to a balanced…

A: In this question,   We need to determine the value of impedance Zc if voltage difference across the…

Q: Differentiate FM with phase modulation.

A:

Q: Determine the DC Voltage for a bridge rectifier with a 115 Vrms, 60 Hertz primary transformer. The…

A: In this question,   We need to determine the DC Voltage for a bridge rectifier?  Load is RC filter…

Q: 1. If A, 2B, 3C are in arithmetic sequence where the distinct numbers A, B, C are in geometric…

A:

Q: The voltages of a balanced source are VAB = 120 cis 0° volts, VBC = 120 cis (– 120°) volts, and VCA…

A: Balance source: Balance source means that all three-phase magnitude is equal and the angle is…

Q: Complete the table given by using mesh analysis. Note: If there are no coefficients for a particular…

A: In this question,   We need to determine the value of impedance Z as show the question using the…

Q: 6.) The figure below shows a series-parallel circuit. Find the magnitude of the total circuit…

A:

Q: The analog signal ra (t) = e(240nl+) +e is sampled at F, = 300 Hz. What is the xpression for the…

A:

Q: What's the connection between a diode and an LED and semiconductors? The symbol should be placed on…

A: Here in this solution the concept of a diode and an LED and semiconductors is explained

Q: Find the average current of a sinusoidal current wave during  half-cycle given instantaneous maximum…

A: The solution is given below

Q: 1. The following circuit shows a discrete common source MOSFET amplilier The MOSFTE is n-channel…

A:

Q: 9.) Assume the frequency to be 60 Hz. Calculate the inductance or capacitance in series for the…

A:

Q: Use 3 decimal places and box the final answer. A 4-ohm resistor is in series with a 7.96-mH…

A: In this question series RL circuit is given... We have to find impedance , input current and volgage…

Q: c) The waveform shown in Figure 1c is passed into an Ideal Low Pass Filter (ILPF) which has a…

A:

Q: Find the generalized S-parameters of the following cireuit line where Z1 = 50 2 and Z2 = 75 2 (both…

A:

Q: Space wave propagation occurs in radio wave communication within a frequency range of O 3 MHz 300…

A: Space waves are a class of radio waves which basically has a frequency range of approximately 30MHz…

Q: Draw the equivalent circuit if you are going to perform Short Circuit Test(SCT)(at terminals a-b,…

A:

Q: Determine the number of quantizing levels required in a PCM system that has a signal-to-noise ratio…

A:

Q: c) The waveform shown in Figure 1c is passed into an Ideal Low Pass Filter (ILPF)  which has a…

A: The frequency response of an ideal low-pass filter is a rectangular function, and it is a brick-wall…

Q: decimal places and box thefinal answer. The instantaneous voltage and current for an ac circuit are…

A: We need to find out impedance and power for given current and voltage

Q: What is the value of the voltage dropped across forward-biased silicon diodes that are connected in…

A: Diode is an electronic device in which current flows in one direction only ( in forward biased) In…

Q: 3. An automobile tire is inflated to 30 psig pressure at 50 deg. Fahrenheit, after being driven the…

A: Given: P1=20 psigT1=50°FT1=50°F-32×59+273.15T1=283.15 KT2=90°FT2=90°F-32×59+273.15T2=305.372K

Q: 120V , Figure 8-3. CALCULATED VALUES POWER DISSIPATED POWER SUPPLIED (4, x E) V, = V PRI = W %3D %3D…

A:

Q: According to the anode the SUS thyristor is turn on for a Othe change of cathode - gate voltage %3D…

A: In this question we will write about SUS thyristor trun on process....

Q: A single core cable has a conductor diameter of 1 cm and insulation thickness of 0.4 cm. If the…

A: Insulation resistance: A material that separates the two conductors or conductors with other systems…

Q: A d.c. series motor draws 25 A from a 260 V line while running at 900 rpm. It has an armature…

A: In this question we need to find a value of the diverter resistance Rd .

Q: Question 6 What is an ohm? O A measure of charge O A measure of EMF O A measure of electron flow O A…

A: In this question we need to choose a correct option

Q: In an antenna array, the array factor depends on Tick all that apply. O Radiation pattern. O…

A:

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.