V1 OP1 R22 OP2 R1 R2 WW R3 W R3 W R4 W Vo + V2 R4 Suggest a suitable value for (R1 R2 R3 and R4) in order to get an input gain stage equal (150) and output gain stage equal (7) Then calculate the total gain of the circuit. All mathematical calculations are needed + OP3

Q: Design a lattice-type balanced modulator.

A: A balanced modulator generates a DSB signal, suppressing the carrier and leaving the sum and…

Q: B-For the lossless transmission lines circuit shown below, design the value of Rx for proper series…

A: Given data, Impedance Z0=100ohm

Q: A transformer is rated 7200:120 V, 25 kVA. What is the base impedance on the low- voltage (120 V)…

A: Given data, Transformers rating V1V2=7200120S=25 kVA

Q: 1. Draw the equivalent circuit of any transmission line, indicating all voltages, currents, and…

A:

Q: A 200μF capacitor is connected in series to a 250V, 60Hz source. Assuming its resistance is 2002,…

A: For the given values of resistance, capacitance and frequency we need to compute equivalent…

Q: Question 17 Find the wave length of a carrier wave with frequency of 20 MHz. 35m 45m 25m 15m

A: Given: Frequency, f=20MHzSpeed of light, c=3×108 m/s

Q: 22. For the circuit shown beside, find v₁ and v₂ ford> 0 if the circuit is in steady- state att 0.…

A: To find V1 and V2 for t > 0 in the circuit

Q: A circuit with a resistor, inductor and capacitor in series is resonant at f, HZ. If all the…

A: Given that: for a series RLC circuit is resonant at fo Hz.

Q: Calculate the bit-force generated by a 440 V DC electric motor. The armature has a resistance of…

A: Given data : Supply voltage Vdc=440V Armature resistance Ra=0.25Ω Speed of motor N=750rpm  Motor…

Q: An inductive load of 100 Ohm and 200mH connected in series to thyristor supplied by 200V dc source.…

A: In this question we will find that SCR will be fired or not by given data...

Q: Q2) Find the x(t) signal is Energy or Power signal? x(t) = 1e-²t.u(t))

A:

Q: A 3-phase, star-connected alternator has a resistance of 0-5 2/phase and a synchronous reactance of…

A:

Q: A small permanent-magnet DC motor has an armature resistance of 3.5 2, and armatur voltage of 7 V,…

A: Given: Armature voltage, V=7VArmature current, Ia=15 mANo load speed=11500 rpmor…

Q: Apply Thevenin's Theorem to find Vo in the circuit below. j5 Ω 12/0° V Z +5 ww 15 Ω -j30 Ω + )…

A: In this question,  We need to determine the voltage Vo as shown the circuit using the Thevenin…

Q: A- Assume you have a Frequency Modulator where its instantaneous frequency varies with the message…

A:

Q: Q.5) Simplify the following Boolean expression using Boolean algebra ONLY: (AB+ AB)(A + B)

A: Given, Boolean expression: AB¯+A¯B¯A+B

Q: VDD +15 V R₁ LAMP 3Ω 1 ΜΩ T MTV10N100E R₂ 2 ΜΩ Figure 12-55 14- The lamp of Fig. 12-55 is replaced…

A: Given  A circuit parameters,we need to find the lamp power when it's dark. Please find the below…

Q: inductance. Determine its impedance considering the circuit is at resonance condition.

A: At a particular frequency value the inductive reactance and capacitive reactance of the circuit…

Q: Referring to this figure, find Zo if yos = 20 µS. express answer in kiloohms 2k2 C₁ HH ť V Z I MQ 2V…

A:

Q: Consider a system characterized by the differential equation d²y(t) dy(t) +3 + 2y(t) = x(t). dt² dt…

A:

Q: A silicon diode has reverse saturation current of 2.5 u A at 300K. Find forward voltage for a…

A: It is given that: Saturation current=IS=2.5 μA=2.5×10-6 AAbsolute temperature=T=300 KForward…

Q: Manually use Newton-Raphson iterative technique with 6 iterations to find a root of vr(t) in t…

A: 6. Newton-Raphson method: In this method, we choose a value xo as an approximate root of vt=0 and…

Q: In a common-source JFET amplifier, the output voltage is 180 out of phase with the input 90 out of…

A: Answer: 180 out of phase with the input.   Explanation: a. It is a valid option. The amplifier…

Q: Question 8: Given a continuous-time signal xa(t) with X₁ (F) = 0 for |F| > B, determine the minimum…

A: For the above given continuous time domain signal we need to calculate sampling rates under the…

Q: A) A single phase a.c. system supplies a

A:

Q: Calculate the value of the vector current density in cylindrical coordinates at PB(1.5, 90°, 0.5) 2…

A:

Q: 1-which transmission media provides the highest transmission speed in a network? a) Coaxial cable b)…

A: As per Bartleby policy we can answer 4 questions at a time. As you have not mentioned anything so I…

Q: Two transformers A and B are connected in parallel to a load of (2+j1.5). Their impedances in…

A:

Q: Q1) A) What is bus? How many ways to construct bus system. (explain with example for one type)

A:

Q: 7. The substrate of MOSFET is normally connected to the Drain terminal. 8. In the actual…

A: Given  True or false question based on FET devices.  Please find the answer below.

Q: What does it mean when a switch is "congested

A: Introduction - Congestion in a network is defined as a decrease in quality of service (QOS) that…

Q: A series RLC circuit is excited by an ac voltage v(t) = Sint. If L=10H and C=0.1F, then the peak…

A:

Q: 3- An E-MOSFET has these values: ID(active) = 1 mA and VDS(active) = 10 V. What does its drain…

A: Note: All the questions are different hence we need to answer only first question please repost the…

Q: The average value of a sinusoidal current is 300A. What is it’s rms value? Group of answer choices…

A:

Q: PRACTICE PROBLEM 16.2 Find vo(t) in the circuit shown in Fig. 16.9. Note that, since the voltage…

A: Given  An electrical circuit.we need to determine the output voltage. Please find the below…

Q: Q3) An 880VA, 220V, 50Hz, load has a power factor of 0.8 lagging. What value of parallel capacitance…

A:

Q: VTH for the circuit external to RL. XC 12 ΚΩ RL 49 ΚΩ R • 15 ΚΩ

A: In this case we have to remove RL and measure open circuit voltage across it in order to calculate…

Q: Consider an LTI system for which the system function H(s) has the following pole-zero pattern. (a)…

A: For the above given questions we need to justify ROC's and properties of the system.

Q: Find the Thevenin equivalent at terminals a-b of the circuit 492 ww 1.51, 2/0° A -j3 92

A: For the given circuit diagram we need to derive the values of thevenin voltage and impedance.

Q: Question 12 An alternator has 6 poles. At what speed must it be driven to develop 120 cycles? 2400…

A: Given:Pole, P=6Cycle, f=120

Q: Ix: Find the current colt) in the col. shown given that is (t) = 5 cos 4t A 6 102 beaut 2H je A+jB…

A:

Q: timer/counter working modes?

A: ADC-Full form of ADC is analog to digital conversions. And the electronics device used for…

Q: Consider a causal LTI system described by the difference equation 1 y[n] + y[n - 2] = x[n]. (a)…

A: The Given Causal LTI system is difference equation yn+14yn-2=xn. To determine the frequency response…

Q: Using Bio-Savart law, calculate the Magnetic Field (B) at an axial point P a distance x from the…

A: Boot Savart Law is directly proportional to the current in the elemental part , length of the…

Q: Solve the question by hand do not using computer, explain each step please Example 3.8: ELECTRICE…

A:

Q: The voltage and current of a load are v(t)-5cos(5nt-15) and 1(t)=0.5cos(5at+15), respectively. Is it…

A:

Q: A price change causes the quantity demanded of a good to decrease by 30%, while the total revenue of…

A:

Q: Referring to the given circuit, what is ZTH if R₁ is changed to 220 ?

A: Resistance in parallel- 1/Req=1/R1+1/R2+1/R3+...........   Resistance in series-…

Q: Given the first order circuit below, compute the time constant T 2kn 1A ) ( (a) 7 = 3ms (b) T = 2s…

A: We need to find out the time constant

Q: Q2: A generating station has a maximum demand of 25MW, a load factor of 60%, a plant capacity factor…

A: This question belongs to power system . It is based on the concept of plant . Have a look at the…

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.