Consider you have to design a convertor to produce an output voltage of 36 V from a 3.3-V input DC source. The output current is 0.1 A. The design of above convertor should be for the output ripple voltage of 2 percent. The effect of ESR should be considered having relation to the capacitor value by as, r = 10-5/ Design the convertor subject to above mentioned design requirements and justify why a boost convertor will not be a good choice here.

Consider you have to design a convertor to produce an output voltage of 36 V from a 3.3-V input DC source. The output current is 0.1 A. The design of above convertor should be for the output ripple voltage of 2 percent. The effect of ESR should be considered having relation to the capacitor value by as, r = 10-5/ Design the convertor subject to above mentioned design requirements and justify why a boost convertor will not be a good choice here.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

i need the answer quickly
Name thr converter
For the dc-dc converter (operating in CCM) depicted in the figure below, make all the required assumptionsand find the input-output voltage ratio (Vo/Vin = ?).
i need the answer quickly
1- Mention any two advantages of Integrated Circuit . 2- For the circuit given below : Vin is a sine wave Vinpp=6 V and Vref=-2.4 V , Assume Vsat=±12V Name the circuit and draw the input and output waveforms . Vin Vref 3- Explain why open-loop op-amp configurations are not used in linear applications? Draw the block diagram of opamp and define the function of each block
Parts D and E only please, thank you!
An Op-amp has a slew rate of 5 V/microsec. The largest sine wave output voltage possible at a frequency of 1 MHz is ?
plot the theoretical and practical control characteristics of the Buck converter, and comments on your the obtained curve.
Find the output voltage assuming the given converter to be a) buck converter b) boost converter
For Steady-State Operation o f Boost DC-DC Converter What is the duty ratio (D) How can it effects on the converter output (Vo)
(b) Draw the circuit of an isolated step-down DC/DC converter and explain how it works. In your answer, explain how electrical isolation is kept while the output is regulated to the desired output voltage.
(Boost de-dc converter with continuous inductor current. Evaluation of inductor and capacitor values) EX3: The boost converter shown bellow has the following specifications: Vin = de input voltage = 12 V, de output voltage = 30 V, output voltage peak-to-peak ripple = 1% Inductor current peak-to-peak ripple 10%, f;= switching frequency = 25 kHz and R = load resistance = 50 N Assuming that the converter is ideal, calculate: a) The duty cycle. b) The average input current. c) The minimum required inductance that ensures continuous inductor current. d) The required inductance so that peak-to-peak current ripple = 10%. e) The minimum and maximum values of the input current. f) The value of the output capacitor so that the output voltage ripple = 1%. g) Verify the theoretical results with the respective simulation ones. Boost inductor Output filter capacitor D VL 1R Vin S R Vo