Two generators have real power generation of P₁ and P₂ in MW and have following fuel cost characteDristics L₁ = 0.05 (P₁)² + 20 (P₁) + 30 Rs hr Rs L₂ = 0.06 (P₂)² + 20 (P₂) + 40 hr Each generator has capacity of 210 MW and they required to feed 400 MW constant load. If the load is shared in same proportion between the generators rather than economic sharing then what is increase in operation cost for generator 1.

Two generators have real power generation of P₁ and P₂ in MW and have following fuel cost characteDristics L₁ = 0.05 (P₁)² + 20 (P₁) + 30 Rs hr Rs L₂ = 0.06 (P₂)² + 20 (P₂) + 40 hr Each generator has capacity of 210 MW and they required to feed 400 MW constant load. If the load is shared in same proportion between the generators rather than economic sharing then what is increase in operation cost for generator 1.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What are the conditions in paralleling of these DC Generators:a. Shuntb. Seriesc. Compound
two synchronous generators are connected in parallel, feeding a load together. the frequency of the first generator in the no-load State is 52 Hz and the slope of the characteristic is 1 MW/Hz. the total power of the load fed by these two generators is 2.5 MW and the power coefficient is 0.6 inductive. by drawing the characteristic curve of the system;a) what is the frequency of the system when the load in question is fed, and how do the two generators share the load between themselvesb) if a load of 0.5 MW is added to the system, find the operating frequency of the new system and the powers given by each generatorc) if a second load of 0.5 MW is connected to the system, the idle operating frequency of the second generator is increased by 0.5 Hz, what happens to the operating frequency of the system and the power values given by the generators
A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing 5 conductors arranged in a full-pitched winding for 3-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emf induced in each phase winding and the terminal voltage.
e = 0 Q1: What does happen if we change two currents? a. Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ki. pw --
A generator at no-load operates 61 Hz, slope 1MW/Hz. Load 1= 1.0 MW and load 2=0.8MW are connected. Find the frequency before and after adding the load 2. (Using House Diagram)A. 60 Hz & 59 Hz C. 60 Hz & 59.2 HzB. 60 Hz & 59.1 Hz D. 60 Hz & 59.3 Hz
Two generators are supplying a load. Both the generators have a no-load frequency of61.5 Hz and the slope sp of 1 MW/HZ. If they are supplying a real load of 2.0 MW at 0.8 pflagging, what would be the system frequency and power sharing between two generators?What measures can be taken to make the frequency 60 HZ. If an additional 1.0 MW load isconnected to the existing one what would the system frequency be.
A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance and shunt field resistance of 1 ohm and 200 ohms respectively. Then line current is a. 2A b. 1A c. 9A d. 10A
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216slots, each containing 5 conductors arranged in a full-pitched winding for 3-phasestar connection. All the conductors of each phase are in series and the flux perpole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emfinduced in each phase winding and the terminal voltage.
Two 30 AC generators are such that one has twice the linear dimensions of the other. The field windings of each are excited to give identical sinusoidal air gap flux density waveform. Both have the same number of stator slots and identical winding patterns. The conductors per slot in big generator in K times that of the smaller one. The value of K to get equal no-load voltage at same frequency is (a)8 (b) 8 1 (d) 7 (c) 4
A generator supplying a load is shown in the figure. A second load is to be connected in parallel with the first one. The generator has a no-load frequency of 61.0 Hz and a slope S, of 1 MW/Hz. Load I consumed a real power of 1000 kW at 0.8 PF lagging while load 2 consumes a real power of 800 kW at 0.707 PF lagging. a) Before the switch is closed, what is the operating frequency of the system? b) After load 2 is connected, what is the operating frequency of the system? c) After load 2 is connected, what action could an operator take to restore the system frequency to 60 Hz? Load 1 Turbine generator Load 2
2. A synchronous generator is connected to an inductive load, please draw phasor diagram to show the relationship between the internal generated voltage of the generator and the terminal voltage across the load. If the same generator is connected to a capacitive load, please draw phasor diagram to show the relationship between the internal generated voltage of the generator and the terminal voltage cross the load again. Explain the difference of the terminal voltage responses at these two types of loads.