Q2: A three-phase Transmission line with 1,956 cm diameter conductor, the corona takes place if the line voltage exceeds 210 kV (disruptive voltage). Find the spacing between the conductors. 8 =1, mo=11

Q2: A three-phase Transmission line with 1,956 cm diameter conductor, the corona takes place if the line voltage exceeds 210 kV (disruptive voltage). Find the spacing between the conductors. 8 =1, mo=11

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.9MCQ

See similar textbooks

Related questions

Q: 4. Can you obtain the z-transform of u[n] at z = 0? If you can, what is its value? If you cannot,…

A: Given, x(n) = u(n)

Q: What amount of power is consumed by resistor #2 (R2)? 8. What value of electric current is flowing…

A: Please refer the attached images for the complete answer..

Q: Given a combinational logic circuit whose input is a four-bit number and whose output is the 2's…

A: Combinational logic circuit-It is defined as a circuit which is formed by the combination of logic…

Q: Utilice el análisis de mallas en el circuito de la figura 8-80 para encontrar la corriente I1. R3 =…

A: To calculate the current I1 by using mesh analysis. First consider current source and convert it to…

Q: ou help me to explain why having an equipotential map is significant in the analysis of electricity

A: Equipotential map : In a particular space or region if there are numbers of point charges present…

Q: Solve for the voltage across resistor #5 (R5)? 2. Determine the voltage across resistor #3 (R3).…

A: In this question , we will find voltage across R3 and R5 and current through R2...

Q: A certain inverting amplifier has a closed- loop gain of 25. The op-amp has an open-loop gain of…

A: It is given that: Af=25Ao=100,000Ao'=200,000

Q: 1) Write VHDL code of the following circuitY=(a xor b) or (not (c and b) ).

A: Write VHDL code for logic y = (a xor b) or (not(c and b)

Q: Solve for each of the following ac quantities: Z in · g mo · g m · Av. V out . Voo = 20 V R = 4.7 kl…

Q: oscillation andR WL Find the ß funchion, freguency f oscillation and Re fer the circut shown below 2…

Q: • A load of 450 kVA operates at a power factor of 0.65 lagging. • An additional synchronous motor is…

Q: a. Find the current in each branch. (Hint: Assume a direction for the current, if the current is…

A: This question belongs to circuit theory . It is based on the concept of kirchhoff's voltage law and…

Q: Given the op-amp configuration in Figure below, determine the value of Rf required to produce a…

Q: 1) Write VHDL code of the following circuitY=(a xor b) or (not (c and b) ).

Q: A. Simplify the Circuit 1. B. Implement the simplified circuit of number 1.

Q: How many poles are required on an alternator which runs at 300 rpm to develop

Q: f(t) A A T -T -A Determine the Fourier series of the function in Fig. 16.12(a). Take A = 1 and T =…

A: Fourier series :

Q: a. A toaster has a resistance of 140 Q and is plugged into a 1200-V outlet. What is the current in…

A: We need to find current and resistance for given circuit

Q: Referring to the figure below, with Rs = 0.82 kohms. 20 V Cw, - 7 pF C = 6 pF Cw,- 11 pF C= 20 pF C…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: A 15 hp, 4 pole 60 Hz, wye connected, 208 volts induction motor draw 12 kW from the line have losses…

Q: Calculate the values of V1, V2, A1, A2, and A3. Show complete solution.

Q: A balanced ∆-connected load, with Z∆ = 30 30° Ω, is connected to a three-phase, three- wire, 250-V…

A: It is given that: Z∆=30∠30° ΩZC=0.4+j0.3 ΩVph=250 V

Q: For the emitter-follower network, determine fLE and the low cutoff frequency

A: The frequency response of the emitter follower circuit can be obtained by considering the RC…

Q: A condenser is connected for 0.25 sec across a 220V supply, the current being kept steady at 0.22A.…

A: In this question, We need to determine the value of capacitance C? If condenser is connected for…

Q: Design a combinational logic circuit whose input is a four-bit number and whose output is the 2's…

Q: 6. R, =2 R, = 100 N R2 = 100 0 %3D R3 =100 0 R5 = 20 2 R4 = 50 %3D R5 = 10 2

A: We need to find out equivalent resistance of given circuit

Q: Given a unity feedback system that has the forward transfer function R(s) K(s + 3) s(s + 2)(s + 4)(s…

A: Given: For a unity feedback Hs=1 closed loop system, the forward transfer function is…

Q: The input current in a matched transmission line is 75 mA while the load current is 3 mA. The line…

Q: zefer to the given circuit. R2 = 52 R1 = 6 0 R3 = 4 2 R4 = 40 R5 = 8 N DURACELL V, = 10 V

A: We need to find power dissipated by given resistor

Q: IN ANY Z = CONSTANT PLANE. DERIVE THE PROBLEM # 5 IN CYLINDRICAL COORDINATES WITH THE DIFFERENTIAL…

A: The cartesian coordinate system consists of three coordinate representation of a given point inside…

Q: 3. Given the circuit below, determine: (a) Rc_(b) RE (c) RB (d) VCE (e) VB 12 V 2 mA O 7.6 V P= 80…

A: In this given circuit, Find the all unknown parameters. Assume BJT working in the active region.…

Q: Use mesh-current analysis to find the branch currents indicated in the network shown below. I1 40°v…

Q: Given x(f) below, using Fourier transform find and plot X(w) x€) = rece{) t H cos(at) T where T T <t…

A: We need to find out Fourier transform of given signal

Q: a) What is the minimum required transformer rating in kVA? b) By what percentage could the required…

A: The motor is connected as Data are given as:

Q: Q1)information signal is PCM using 8 levels quantization if the signal is given as cos(4t) with…

A: According to the question, an information signal is PCM using 8 level quantization if the signal is…

Q: 3. Sketch the AM modulated signal (assume sinusoidal signal modulating a sinusoidal carrier) in both…

A: Signal modulation- It is a process in which any of the parameter of the signal is modulated. The…

Q: AMohetone on ng uestion A transformer has 197 turms on the primary coll and 530 tums on the…

A: We need to find out current on secondary side of transformer .

Q: 3. A causal discrete-time LTI system is described by y[n] - y[n - 1] + y[n – 2] =x[n] where x[n] and…

Q: For the function f(a,b,c,d)=Em(1,3,4,5,6,7,10,12,13)+Ed(2,9,15), find all minimum sum-of-products…

Q: Find I in the network using NORTON'S THEOREM.

Q: phase sequence, determine: a) Va'b' b) Va"b" a 0.5 + j1.5 N 0.8 + j2N b' b" 0.5 + j1.5 N 0.8 + j2 N…

Q: Q1. In a 3-phase 4 wire, 400/230 system, a lamp of 100 watts is connected to one phase and neutral…

A: Given: 3-phase4 wire400/230V100 watt lamp-1 is connected in one phase to neutral150 watt lamp-2 is…

Q: lon ation and For require the circuit shown below?

Q: A 4 H inductor has a voltage waveform v(t) as shown in Figure Q3. Determine and plot the current…

Q: Q4. The current through a 1- µF capacitor is shown in Figure Q4. Sketch voltage v(t) scaled with…

A: The voltage across the capacitor can be calculated by using the voltage formula.

Q: What is the differences between real circuits and the simulated ones, please elaborate.

A: Simulation is define as the mathematical model or representation of a device which gives a very…

Q: A certain amplifier has an open-loop midrange gain of 150,000 and an open- loop 3 dB bandwidth of…

A: In this question certain amplifier given with open loop gain and bandwidth...We have to find out…

Q: For the function f(a,b,c,d)=Em(1,5,7,9,11,12,14,15), find all minimum sum-of-products solution,…

Q: repeat the example above for RE = lok s and B = 70 DC Q- Point = (475 MA , 4-5V) %3D

Q: An AM receiver is tuned to broadcast station at 600 kHz. Calculate the image rejection in dB…

A: Given fs =600kHz Q=35

Question

i need the answer quickly

Q2: A three-phase Transmission line with 1,956 cm
diameter conductor, the corona takes place if the line
voltage exceeds 210 kV (disruptive voltage). Find the
spacing between the
conductors. 8 =1, mo=11

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate the inductance of the single-phase double circuit line shown in the figure, the diameter of each conductor is .2 cm d=2 cm 100 cm 100 cm-
In the figure, a traveling voltage wave of 500 kV proceeds towards point A. Calculate the voltages and currents in the branches after the first reflection and transmission at point A.
The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 42 feet. The per kilo feet inductive reactance will be: O A. 0.1537 B. 0.8117 O C. 0.1475 O D. 0.1148 O E. None of choices are correct
A. For the following figure, the diameter of each conductor is 2.5 cm. Find the inductance and capacitance per km per phase. 40 cm 40 cm 40 cm a a' b b' 10 m 10 m Phase A Phase B Phase C
In non-sinusoidal wave sources, the dissipated power in the load is depends on the value of . . Variable Current Average Current Constant Current All-of-them
Each conductor of a 3-0 overhead line is suspended from a cross arm of a steel tower by a string of 4 suspension insulators. The voltage across the third 33 kV. The shunt capacitance between each insulator and the earth is 1/8th of the capacitance of the insulator itself. Find the voltage across string and string efficiency. D-128 Lod Fa
The inductance effect is predominant in underground cables than overhead lines. Select one: True False
following Series for divergent Test the Condergent or (3n)!
5.5 kW, 1450 rpm. L-type equivalent circuit and parameters for a continuous sinusoidal phase of a star connected 3-phase ASM with line voltage 220 V and frequency 50 Hz are given as follows, ignoring core (iron) losses: R1=0.21 Ohm, R2=-0.18 Ohm, X1=X2-0.66 Ohm and Xm = 9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 8.0815 2.6455 4.3763 7.1534 1.2558 6.3414 5.2280 3.7473
The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 25 feet. The per kilo feet inductive reactance will be: O A. 1.0025 B. None of choices are correct C. 0.1418 O D. 0.0556 O E. 0.707
Develop the mathematical relationships for the design of the inductance and capacitance of a three-phase double circuit line. A three-phase double circuit line consists of two identical three-phase parallel circuits as shown in the figure below. The circuits are operated with a1-a2, b1-b2, and c1-c2 in parallel.
The ripple factor for pure dc is Answer: