three wye connected load impedances Za=30 + j40 ohms, Zb=20-j15 ohms, Zc=20-j15 are connected to an abc-sequence, balanced three phase wye connected source with a line voltage of 400 V. A conductor of impedance j2 ohms is used to connect together neutral points of the source and the load. The line impedance per phase is j4 ohms. Calculate the load phase currents and voltage, and the voltage drop in the neutral wire

three wye connected load impedances Za=30 + j40 ohms, Zb=20-j15 ohms, Zc=20-j15 are connected to an abc-sequence, balanced three phase wye connected source with a line voltage of 400 V. A conductor of impedance j2 ohms is used to connect together neutral points of the source and the load. The line impedance per phase is j4 ohms. Calculate the load phase currents and voltage, and the voltage drop in the neutral wire

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.42P: A balanced -connected impedance load with (12+j9) per phase is supplied by a balanced three-phase...

See similar textbooks

Similar questions

Two delta connected loads are connected in parallel and powered by a balanced Y-connectedsource. The smaller of two loads draws 10 kVA at a lagging power factor of 0.75 and the largerdraws 25 kVA at a leading power factor of 0.8. The line voltage is 400 V. Calculate a) The powerfactor at which the source is operating. b) The total power drawn by the two loads. c) The phasecurrent of each load.
Draw a 3-phase wye-connected generator with transmission lines connected to a 3-phase delta-connected load. Assume the lines connecting them have an inductance of j5 per phase. The generated voltages are 120 Vrms with phase 'a' having a phase angle of 0°. The loads are 10 Ohm resistors per phase. When drawing, make sure to label all 3 phases with voltage phasors, line inductances, and load resistances.
A delta connected load with Zab=3 + j2 Ohm, Zbc=3 + j4 Ohm and Zca=2 + j3 Ohm are connected the end of a three-phase line as shown in the figure. The line impedance is 1+j2 Ohm per phase. The line is supplied from a three-phase source with line-to-line voltage of Vab=200.0/0° V rms. Taking the phase current vector lab as the reference vector, determine; (a) Line current Ia. (b) Total complex power supplied from the source. (c) Magnitude of the line-to-line voltage at the load terminal. ao- bo- Co- 1+j2 b a
A balanced three-phase Delta connected voltage source supplies Delta connected three-phase symmetrical load through a three-phase line at 50 Hz as shown in the figure below. Please, answer the following using ZL=0.4+j 0.8 N and Zab = Zbc = Zca=10.3+j 14.1 N. A I a Zz Z. ca I 400 20° v +1 400Z-120° v Ic SOURCE LINÉ LOAD Part F: Calculate the reactive power of the three-phase Delta load in terms of VAr. 4002-240° v
VA-120 V4120 Z₁ volt In lc c ZA Three-phase source Feeder lines Balanced load In the above circuit diagram, we have source impedance Zg = 0.05+j0.15 ohm, Z₁ = 0.1+j0.2 ohm and per phase impedance in the balanced Delta connected load, Z₁ = 12+j9 ohm. RMS value of source voltage is 200 volt. Phase sequence is as shown in the diagram. RMS value of current Ic= ampere Phase angle of le= degree RMS value of line voltage VCA = B JAB Inc ICA
Draw Wye- Delta three phase transformers connection ( no-load and full-load) in Lt-spice
In a balanced Y-Y circuit shown in Figure 5, the magnitude of the phase voltage at the source is Vp = 2520 V (rms) and Van = 252020° V (rms). The load impedance is Zy = 135 + j55 Q per phase and the wire impedance is Zw=85 + j65 per phase. All the voltages and currents are in rms in this problem. (a) Find the phasors for line currents IA, IB, Ic in rms. (b) Find the load voltage VAN = IAZY. Also find VBN, and VCN. (c) Find the line voltages VAB, VBC, VCA at the load. (d) Find the complex power SL of the load. ZW ZY Van a A IA ZW ZY Vbn b В IB N ZW ZY Vcn IC Figure 5
The following three-phase circuit is symmetrical, with line voltage 220 V, 60 Hz, direct phase sequence, isolated neutral and the value of the impedances of the loads in the three phases are: Zan = 10 ohms Zbn = -10j ohm Zcn = -10j Ohm Find:a) Phase voltages on the load;b) Line and phase currents;c) The power supplied to the load. Consider the phase voltage in the reference(Va voltage angle equal to 0)
A balanced three-phase Y-connected source with positive sequance has an internal voltage of 120 V/phase. The source feeds a balanced three-phase Y-connected load having an impedance of 39 + j28 N /phase. The impedance of the transmission line connecting the source to the load is 1+ j20/phase. The a- phase of the source is the reference voltage. a) Draw the equivalent per-phase-circuit for the phase "a". b) Calculate the three line currents in the transmission lines. c) Calculate the three phase voltages at load. d) Calculate the three line-to-line voltages at the terminals of the load. e) Calculate the total average power in watts delivered to the load. f) Calculate the total complex power in VA delivered by the source.
In a three phase balanced Y-Y system, the source phase currents have a magnitude of 9 A. The magnitude of each load current is Select one: O a. 27 A O b. None of these O c. 22 A O d. 13 A
A Y-connected balanced three-phase source is connected to a three-phase balanced load through a four-wire three-phase cable. The generator has an impedance of 0.1+j0.3 Q/phase. Each phase of the cable has an impedance of 2+2j 2 The phase "B" load voltage is 102-140° kV. The impedance of each phase of the Y-connected load is 3-j5 Q/phase. For a negative sequence: 1- tto pointe) Calculate "terminal" phase voltage of phases "a" and "c" of generator. 2- E points] Calculate Vab and Vca across the load. 5 points Calculate three phase power supplied by the source. 4- 10 point] Calculate three phase power losses.
The three-phase source line-to-neutral voltages are given by Ean=100,Ebh=10+240, and Ecn=10240volts. Is the source balanced? (a) Yes (b) No