Answered: Three resistors of 10, 12 and X ohms,…

Three resistors of 10, 12 and X ohms, respectively are connected in parallel across a constant current source of 8A. Determine “X" if this resistor draws 2.13333333... A.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Related questions

Q: 1. A l-m length of wire is found to have a resistance of 25 ohms. If the diameter of the wire is I…

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: 1등요 5요 32 24 V

A: Given:

Q: 5. A resistance of 120 ohms is supplied by a 220 V, 60 Hz source. Determine the equation of voltage…

A: Determine voltage and current for the given AC circuit ?

Q: 14. With 100-V applied across each ten 50-ohm resistances in parallel, the current though each…

A: Given

Q: What is GENERATION AND MEASUREMENT OF DC VOLTAGE? Give some introduction about it in 2 page if…

A: According to the question, we have to find the value of Generation and measurement and generation…

Q: Shown here is a simplified representation of an electrical power plant and a house, with the source…

A: Power transmission : transmission of electricity from generating site to home is known as power…

Q: Using Ohm’s Law, what is the relationship of current, voltage, and resistance ? Explain and use…

Q: (b) A student sets up an electric circuit like the one shown in Figure Q2(b). i) Describe how a…

Q: In the figure, the ideal batteries have emfs ℰ1 = 25.0 V and ℰ2 = 0.500ℰ1, and the resistances are…

A: Given circuit is - Given values are -

Q: Q2: For the circuit in figure shown, determine the value ofR such that the maximum power delivered…

Q: The resistance of a resistor at 7 degrees Celsius is given as 42 ohms. Determine the resistance, in…

Q: Find the current IO and voltage V1 in the circuit shown below using the techniques of equivalent…

Q: B F E D

A: Given

Q: A

A: Ohms law: V=IR Where V=voltage across resistor I= current flowing through the resistor R=…

Q: a)Write the nodal equations and determine the potential values(voltages) of V1,V2 and V3 with…

Q: Discuss causes of insulation failures in high voltage engineering. High voltage engineering

A: according to the question we have to discuss about the cause of insulation failures in high voltage…

Q: Consider the series-aiding configuration of the ideal voltage sources shown below. A. V3 -2V V2 -2V…

A: In the circuit, Find the voltage VB in the series configuration. All voltage sources are ideal.…

Q: Find the impressed voltage at the source in the circuit shown, if current flowing through 5-ohm…

Q: The resistance of a wire is 5Ω at 50°C and 6Ω at 100°C. The resistance of the wire at 0°C will be?

Q: Derive the mathematics of a circuit A series of 5 units of insulators Extract V5 in detail

Q: Figure, the ideal batteries have emfs & = 150 V and & = 50 V and e1 he resistances are R, = 3.0 n…

Q: What is the equivalent resistance of these resistance combinations

Q: Since R1=9282.13ohm, R2=3403.87ohm and Ri=Infinite in the circuit given in the figure, write the…

A: We need to find equivalent resistance of given circuit .we know formula for equivalent resistance .

Q: 3. A metallic wire is stretched from original length of 3 m to 6 m. If the original cross-sectional…

Q: i. Consider, two resistors 4k2, and 8kN are connected across 30V DC supply. The voltage drop across…

Q: resistance and resistivity as level assignment Investigation resistance and resistivity wiht graph

A: Any practical electrical circuit has some resistance in the wires which carry the current. Also, the…

Q: In solving a network, what rule must you observe when writing KCL equations? Why?

A: Given: Rules for KCL equations is shown as:

Q: Which among the relationship given below is correct? a. AC resistance = DC resistance/1.6 O b. DC…

A: In this question Choose the correct option Which among the relationship given below is correct?

Q: Two conductors, one of copper and the other of iron, are connected in parallel and carry equal…

Q: 4- What is Ohm's law of applications? 5- What are non-ohmic resistance? Give two examples.

Q: Find the current in the 17 ohms resistor by using Wye/delta conversion. Provide a clear solution.

Q: A coil of aluminum wire has a resistance of 50 when its temperature is 0°C. Determine its resistance…

Q: Please help me with this, attached herewith is the formula how to compute the range of expected…

A: For 1st resistor- 1st Band=1st digit=green=5 2nd Band=2nd digit=blue=6 3rd…

Q: How to measure voltage across a resistor? A In series with the element B) In parallel with the…

Q: Find the conductance of a short circuit on 100 V, Which results in a short circuit current of 500 A.

A: Given, Voltage, V= 100 V Current, I= 500 A

Q: Find the open-circuit voltage and current i flowing in 6-ohm resistor.

Q: BASIC ELECTRICAL ENGINEERING - ELECTRIC CIRCUIT Draw a simple circuit diagram of circuit consisting…

Q: resistors? 5. Two equal resistors R and Ra are connected in parallel and to a 120-volt source. What…

A: From which end u r assuming potential will really matter

Q: Using the circuit below with R1 = 1 kQ, R2 = 10 kQ, and E = 9 volts, determine the theoretical…

A: To solve the above problem, we will use Ohm's law and Kirchhoff's law. Ohm's law states that current…

Q: The circuit shown in the figure below, determine the values of V1 and V2, all R is worth Ohms, and…

Q: What is the temperature coefficient of resistance, and what are its units?

Q: I- Q3: 1- How much resistance is required to limit the current to 1.5 mA if the potential drop…

A: 3) (1) To find the value of resistance that limits the current to 1.5 mA if the potential drop…

Q: Describe effect of internal resistance in both current and voltage sources with suitable diagram.

A: Voltage source provides us adequate amount of terminal voltage across the load. After that we can…

Q: Consider the circuits shown in the figure. The magnitude of the ratio of the currents, i.e.,…

A: Given circuits are -

Q: 1-Some copper wire has a resistance of 200 at 20°C. A current is passed through the wire and the…

A: Dear,as per company guidelines we can answer only one question at a time, kindly post other question…

Q: For the circuit find the power absorbed by 20 resistance by using Kirchhoff's laws. 2n

Q: Look at the images shown. Why can we measure resistance with a pencil drawn on a piece of paper?…

Q: With 100-V applied across each ten 50-ohm resistances in parallel, the current though each…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

100%

Three resistors of 10, 12 and X ohms, respectively are connected
in parallel across a constant current source of 8A. Determine "X"
if this resistor draws 2.13333333... A.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The diagram in the figure shows a simple circuit consisting of a battery and a load consisting of two resistors.The battery voltage is UB = 56 V and the value of the resistors is:R1 = 1800R2 = 5400a) The ammeters in the circuit show the following value:A1 shows valueA2 shows valueA3 shows valueb) In the load, the effect developsc) The total resistance of the load is
dhjdhjhdjdhjfhfjdbfejfheidadadisfdfodf,fdhjfhdfj The equivalent resistance of three resistors A, B and C connected in parallel is 1.5 ohms. If A is thrice of B and C is 1/4 of B. Find the equivalent resistance when the three of them are connected in series? dhsfhfeirwdiwudwiwui
Which of the following statements are correct for the circuit below? Thanks to the capacitors I – C1 and C2, the voltage gain of the circuit increases. II – Capacitors C1 and C2 are coupling capacitors and provide an isolation function between AC and DC voltages in the circuit. Thanks to the III – RE resistor, the voltage gain of the circuit increases. Thanks to the IV – RE resistor, the stability of the circuit increases. The V – C3 Capacitor is a bypass capacitor and prevents the loss of voltage gain. Capacitor VI – C3 is a coupling capacitor and has no effect on the voltage gain in the circuit. VII – As the value of the source internal resistance Rs increases, the voltage gain decreases. VIII – The voltage gain decreases as the value of any RL load to be added to the circuit increases
In the figure the current in resistance 6 is i = 1.43 A and the resistances are R₁ = R₂ = R3 = 1.68 2, R₂ = 15.1 Q2, R5 = 7.41 Q2, and R6 = 4.57 2. What is the emf of the ideal battery? E www R₁ O a. 25.7V O b. 52.3 V O C. 47.2 V O d. 21.4 V O e. 6.54 V R3 www R₂ www R₁ R₂ 16 R6
A dc generator and a battery are connected to a resistive load RL in the figure below. For each, determine the value of RL for maximum power transfer to RL. Next is to determine RL to 75% efficiency
shfdjkfdrhnacoioeniodinopidopdnieocmixoxwmipdf.ziudSALIDUDetu The equivalent resistance of three resistors A, B and C connected in parallel is 1.5 ohms. If A is thrice of B and C is 1/4 of B. Find the equivalent resistance when the three of them are connected in series? dhffrriru9ee
Please help me solve for the total resistance, total current, and individual voltage if: VT = 30 VR1 = 7 ohmsR2 = 10 ohmsR3 = 6 ohmsR4 = 4 ohmsR5 = 8 ohmsR6 = 9 ohmsR7 = 5 ohmsR8 = 12 ohmsR9 = 3 ohmsR10 = 8 ohms
Estimate voltage E2 when E1=90sin2400t V, R1=R2=20 ohms, L1= L2=3mH and M=0.15mH
A five-Ohm resistor is in series with a 0.001-Henry inductor and is supplied from a 10-V DC source. Solve for the current 2 milliseconds after the switch was turned on. a. 2.0000 Amperes b.1.9999 Amperes c.1.0001 Amperes d. 2.0001 Amperes
Coverage: Series and Parallel Combinations, and Ohm's Law Question: If simplified, the next figure shall be: - (a) A and the series of three resistors. - (b) A and the parallel of three resistors
A charger, a battery and a load are connected in parallel. The voltage across the charger is 12.5 volts and the battery has an emf of 12 volts and the internal resistance of 0.1 ohm. The load of 2 ohms resistor. Find the current through the charger.
An example of Simple Resistive Circuits is ,