Three-phase System Data: 30 Source Zine 30 Load Source: Ean = 12020° v; Epn = 120 – 120° v; Een = 1204120° v (grounded neutral) Zan = Zpn = Zen = 0.1 + j1.5 N Line Impedance: Zine a = Zine b = Zine c = 1 + j2 N; Load Impedance: Zab = 40 + j30 N; Zpc = 40 – j30 N; Zca = 50 + j0 N Types of Faults to be Considered, assuming worst case scenario (Z, = 0): SLGF (line a grounded), LLF (lines a & b connected), 1LO (line a open) FIND: please answer in 4 decimal places Under Unbalanced Condition With Faults: a. Load Line Currents (Ia, Ib,I); b. Load Line Voltages (Vab, Vpc, Vca);

Three-phase System Data: 30 Source Zine 30 Load Source: Ean = 12020° v; Epn = 120 – 120° v; Een = 1204120° v (grounded neutral) Zan = Zpn = Zen = 0.1 + j1.5 N Line Impedance: Zine a = Zine b = Zine c = 1 + j2 N; Load Impedance: Zab = 40 + j30 N; Zpc = 40 – j30 N; Zca = 50 + j0 N Types of Faults to be Considered, assuming worst case scenario (Z, = 0): SLGF (line a grounded), LLF (lines a & b connected), 1LO (line a open) FIND: please answer in 4 decimal places Under Unbalanced Condition With Faults: a. Load Line Currents (Ia, Ib,I); b. Load Line Voltages (Vab, Vpc, Vca);

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q1) For the circuit shown below, Vab = 240415°, Zy = (12 + j15) N, the phase %3D sequence is positive. Calculate: a) The load phase voltage (VAN). b) The load line current (Ia). c) The source phase current (Iab). A Zy Vca N Iab Zy Zy I, b. B
please i need handwritting step by step
From the circuit below, determine secondary winding voltage Vsec if the primary winding voltage Vpri = 120Vrms? Np:Ns 6:1 Vp 120 Vac 60 Hz out R = 200 ) O Ovrms O 720Vrms 120Vrms O 20Vrms wi m
Shown are two buses connected via a transmission line. Connected to Bus 1 is a generator(modelled as a voltage source V1), and to Bus 2 is a generator( with Voltage V2) and a load. The line impedance Z = R + jX is not known. Three-phase load is forecasted as 100MW + 60MVar. Generator at Bus 2 is scheduled to deliver 40MW and its excitation is adjusted for the machine to deliver 55 MVar. Voltage at Bus 1 is 241 KV angle 10 deg, while voltage at bus is 230 kV; use V2 as the reference for all angles. 1. What is the current (RMS) in amperes drawn by the load connected to Bus 2? 2. How much real power (in MW) is delivered by the generator connected to Bus 1? 3. What is the total real power loss along the line, in percent of the load? 4. What is the X/R Ratio of the line impedance?
If a load is symmetric with 50 ohm of series impedance and 13 ohms of mutual impedance, what are the sequence impedances? a. z11 = z22 = 63 ohm, z33 = 89 ohm, else 0 b. z11 = z22 = 33 ohm, Z00 = 76 ohm, else 0 c. z11 = z22 = 50 ohm, Z00 =89 ohm, else 0
I need the answer as soon as possible
consider the following diagram of impedances in per unit of a common base a) get the YBUS admittance array and the ZBuz impedance array 213-j2 pu zt2-j0.15 zg2-j1.85 791-j0.9 211-0.1 1 212-j0.5pu 223-j0.5pu Va 1 p.u. Jv1-1p.u. 22-10 pu
1 PROBLEM 20020° V rms, Vbn 1. A balanced three-phase Y-Y system has the phase voltages of Van 200/120° V rms, and Ven = 2002(-120°) Vrms. The load impedance per phase is Z₁ = 50 - j100 n. a Van Vcn n Vbn Ia Ib Ic B Zu (b) Determine the line currents Īa, Ip and Īc. (c) Determine the total average power delivered to the three loads. N C = ZL (a) The balanced three-phase circuit has a negative phase sequence. Circle your choice. (1) True (ii) False
Q2
For the bridge circuits shown in the figure bellow, derive expressions to calculate the unknown impedances. Be Detector wwlle
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020º, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.3322-120° A (C) 0.9962-120º A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
In the figure, bus 1 is the reference bus, V1 = 1.06 p.u and the angle is 0.. A load with active power= 100 MW and reactive power = 50 Mvar is connected to bus 2. The line impedance is z12 = 0.12 + j0.16 p.u on a base of 100 MVA. Start with an initial estimate of |V2|0) = 1.0 p.u and 820) = 0•. Find |V2| () (one iteration). 100 MW 212 = 0.12 + j0.16 ++ 50 Mvar Vị = 1.0/0° О а. |V2| (1) = 0.4 p.u. Ob. |V2| (1) = 0.5 p.u. Oc. |V2| (1) = 0.7 p.u. d. (1) = 0.8 p.u. е. |V2| (1) = 0.6 p.u.