Three identical coils, each of resistor 2ohm and inductive reactance 6.28 ohm are connected in delta to a Supply voltage of 100V, 100 Hz, 3-phase supply, then the line current is . Select one: O a. 10.25A O b. 46.56A O c. 15.17A O d. None of these

Three identical coils, each of resistor 2ohm and inductive reactance 6.28 ohm are connected in delta to a Supply voltage of 100V, 100 Hz, 3-phase supply, then the line current is . Select one: O a. 10.25A O b. 46.56A O c. 15.17A O d. None of these

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: Three Impedances each of (8 - j22)N are connected in mesh across a three-phase 400V ac supply.…

A: According the given equation, we can make the circuit diagram shown below

Q: A single phase circuit with a given load 3 ohm resistance and inductive reactance of 4 ohms as…

A: The question is about active power, reactive power and apparent power, power factor.

Q: One needs a 100 kVAr A-connected TCR for a three-phase distribution system of 2.4 kVu, and 60 Hz.…

Q: A 4MVA, 13.3kV, 60Hz, 3-phase, wye-connected alternator has an effective resistance of 5.2 ohm per…

Q: Problem: Sketch the dotted equivalent circuit for the coupled coils shown in figure and find the…

A: SOLUTION !!

Q: Q.1) A single phase load consisting of 5 2 in series with an inductance of 0.02297 H is operated in…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 1. What is the main direct cause of reactive power in AC system? A. Resistance of transmission lines…

Q: What is the main direct cause of reactive power in AC system? A. Resistance of transmission lines B.…

A: The explanation is as follows.

Q: 3. A three-phase 60 Hz Wye connected, 2,000-kVA, 2,300-V alternator give a short circuit-test…

A: The solution is given below

Q: Q.6 (a) Explain in detail the four-quadrant operation of chopper and how it is differed from dual…

A: Operation of four quadrant chopper four quadrant chopper consists of four semiconductor switches and…

Q: d. What are the line currents (laa, IbB, lec)? e. What real, reactive and apparent power does the…

Q: It is desired to correct the 2,400-kVa 0.65 lagging power factor load in a plant to unit

A: The complex power in an AC system is defined as the product of rms value of applied voltage and…

Q: R = 2 kN E = 282 sen (100at) 40 L =- H r = 2 kN 10 C =- µF

Q: A generating station is to supply four regions of load whose peak loads are 10 MW, 5 MW, 8 MW and 7…

A: Given that, Peak loads are 10 MW, 5 MW, 8 MW, and 7 MW diversity factor=2 average annual load factor…

Q: A 5000 kVA, 6600 V , 3 - phase , star connected alternator has a resistance of 0.75 ohm per phase.…

A: Given: A 5000 kVA, 6600 V, 3-phase, star connected alternator has Ra=0.075 Ω/phase Current, I=500 A…

Q: e star connected, 1500 kVA, 13 kV alternator has an armature res ous reactance of 8.0 ohms. When…

Q: A step-down chopper, with voltage source 20V. If the duty cycle is 50 frequency is 0.1Hz, Find…

Q: A 6.6 kV, 6 MVA, Y-connected, 3φ alternator has an effective ac resistance of 0.436Ω between…

Q: A single phase circuit with a given load 5 ohm resistance and capacitive reactance of 2 ohms as…

Q: 2. calculate the n at 25% , 50% , 75% , 100% and 125% full load condition for u.p.f and 0.8 p.f lag…

Q: A generating station has a maximum demand of 20MW,a load factor of 60%, a plant capacity factor of…

Q: If a 50 ohm quarter-wave impedance converter is used to match a 60 ohm transmission line to an…

Q: Q3: For the following figure, select the generator rating as base to find the voltage at the…

Q: n impedance coil has a resistance 0 A from 220V, 60 Hz mains. What i e condenser connected in…

Q: HW In the chopper circuit shown, E = 220U, L = 1.5mH R = 0.5 and it is operating with T=3ms and Ton…

A: Given data, The supply voltage (E)= 220V The given inductance(L) = 1.5mH The value of resistance (R)…

Q: Reactive Power Compensation Regulation, capacitive reactive power should not exceed what percent of…

A: Reactive Power Compensation Since the major load in power systems is an inductive load that…

Q: A 1500KVA, 8KV, three-phase wye-connected alternator has an effective resistance of 0.502 and a…

Q: Q5/ Two 300KVA, 1000V, 50HZ alternators operating in parallel to supply a load of 500KW at UPF. 60%…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Two 15-kVA, 400-V, 3-ph alternators in parallel supply a total load of 25 kVA at 0.8 p.f. lagging.…

Q: A 50 Hz, 11KV, 3-ph, alternator with earthed neutral has a reactance of 5 Ω\ ph and is connected to…

Q: A 3-phase wye-connected alternator rated at 1600 kVA, 13.5 kV. The effective armature resistance and…

Q: A TRIAC phase control circuit has a load resistance of 71 and is powered by an AC source of 163…

Q: Problem 2 The circuit diagram of a certain load is presented below. Determine the following: a. The…

A: The circuit diagram of a certain load is presented below. Determine the following: a. The power…

Q: From the circuit below, determine secondary winding voltage Vsec if the primary winding voltage Vpri…

Q: A motor load consists of a resistance of 6 Ohms in series with an inductance of 12 mH. Assume…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Q2) A generating station has a maximum demand of 30 MW, a loac and plant use factor of 0.8.…

A: According to question:

Q: 8 One phase of a 3-phase alternator consists of twelve coils in series. Each coil has an rm.s.…

A: Given data, Total number of coils = 12 RMS voltage in one coil = 10 V Successive phase difference =…

Q: pasic requirement psed one wind; ave winding o: ar (h) or (o)

A: The DC motor convert an electrical energy into mechanical energy. The following Dc motor are used in…

Q: e reactive power output of a mited by load angle True

A: In this question , we have to explain that which quantity limits reactive power output of an…

Q: A 3 phase mesh-connected AC generator has a power angle of 15.4 degrees and synchronous impedance of…

A: The solution is given below

Q: non-sinusoidal quasi-square wave voltage v(t) is applied to a nonlinear load, resulting in a…

Q: Generate a conclusion on this following statements: Determine and analyze the voltage regulation…

A: GIVEN: resistive load inductive load capacitive load DETERMINE: the…

Q: 3. A coaxial cable with a = 3 mm and b=6 mm has perfect conductors (no ohmic losses) and the region…

A: Zo = 60 / √(€r). × ln [ a/b] a= Inner Diameter Coaxial Cable b = outer Diameter Coaxial Cable…

Q: A straight-line law connects terminal voltage and load of a 3-phase star connected alternator…

A: It is given that: cosϕ=0.8 laggingVt=3500 VPfl=2280kWVfl=3300VRL=8ohmXL=6ohm

Q: A THREE-PHASE FACTORY WITHIN AN INDUSTRIAL COMPLEX CONSUMES 80 KW, AT A POWER FACTOR OF 0.80 BACK…

Q: ) A single-phase full-wave AC voltage controller consists of two SCRs connected in invers-parallel.…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Question

Three identical coils, each of resistor
2ohm and inductive reactance 6.28 ohm
are connected in delta to a Supply
voltage of 100V, 100 Hz, 3-phase supply,
then the line current is.
Select one:
O a. 10.25A
O b. 46.56A
O c. 15.17A
O d. None of these

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of158 volts, 50 Hz supplies the combination. Determine the following:a. Circulating currentb. Voltage across the resistorc. Voltage across the capacitord. Real power supplied by the source
Section [Section Upload answer sheets Find the following parameters of an ac voltage given by the equation v-100sin370t.Find RMS value,form factor, peak factor, average value and frequency. E Submission
Q2/3-phase.E.W.C. R using center tap transformer supplies highly inductive load, find: 1. The average load voltage with and without FWD and discusses these cases. 2-lf firing angle equal to 45°, the supply voltage is240v, transformer ratio is (2/1). Calculate the DC current& voltage of this case. 3- Draw all waveforms diagram. 4- what are the difference between the type of connection (Delta or Star).
Consider a 3-phase, 50 HZ, 11 KV distribution system. Each of conductors is suspended by an insulator string having two identical porcelain insulators. The self-capacitance of the insulator is 5 times the shunt capacitance between link and ground. Find the voltages across two insulators.
1-Choose the correct statement for pure resistor connected across single phase AC supply. a. Current and Voltage are in phase b. Current leads the supply voltage by 90° c. None of these d. Current lags the supply voltage by 90° 2-Identify the current through the inductor in a RL transient circuit connected across DC voltage, when the switch is kept open. a. 0 b. Infinity c. V/R d. 1
An RLC series circuit connected to a 110 – volt and 50 – cycle AC source, contains the following series resistances and reactances: R1 = 10 ohm, R2 = 15, R3 = 5 ohms, XL1 = 20 ohms, XL2 = 25 ohms, XC = 40 ohms. Find the following: a.) EQUIVALENT REACTANCE b.) TOTAL IMPEDANCE c.) VOLTAGE DROP ACROSS THE CAPACITOR d.) TOTAL INDUCTANCE IN MILLIHENRY e.) TOTAL CURRENT f.) REACTIVE POWER g.) REAL POWER DRAW THE PHASOR DIAGRAM IF POSSIBLE AND ROUND OFF TO FOUR DECIMAL PLACES
The section bus-bars A and B are linked by a bus-bar reactor rated at 6000 kVA with 12% reactance. On bus-bar-A, there are two generators each of 10 MVA with 8% reactance and on bus-bar-B, two generators each of 6000 kVA with 10% reactance. Find the steady MVA fed into a dead short circuit all phases on B with bus-bar reactor in the circuit.
Which of the following statements is/are true? (A In purely inductive circuit, the current leads voltage. (B) In purely resistive circuit, the current lags voltage. C In purely resistive circuit, the current is in phase with voltage. D In purely capacitive circuit, the voltage lags current.
A 500 MVA synchronous machine has H, = 5.6 MJ/MVA and a 1200 MVA machine has H₂ = 2.0 MJ/MVA. The two machines operate in parallel in a power station. What is the equivalent. H constant for the two, relative to a 100 MVA base?
6.5% ans ex A so kvA. 2o00/20 V, So He single-phase transformar has impedance drof of8% and resistance drop of 4%. Caleulate. The Requlation of the Thams former at full- Load o8 P.s Legging. also find The Power factor at which Voltage requlation will Be Zero. Sols 0.5 leading. s alculate The % Noltege Requlation af atransformar in w hich the Percantage resistance drof is 1% and Percentage dre is 6% when The Power fador is 0.8 lagging ) > unity aMS 38 % ans 1 % (シ→ 0.8 leading . amS - 2.2%
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator
Choose the supply voltage for a step down chopper circuit which drives the resistive load 4.80 with average load current 32.4A for a duty cycle of 0.4. O a. 2624.400 O b. 777.600 O c. 48.000 O d. 388.800