This problem expands Compaction-05: A Modified Proctor compaction test is performed on a clayey gravel road base. The solids have a specific gravity of 2.65. The compaction data yielded the following binomial values for ya/yw versus w %: w(%) 3.00 4.45 5.85 6.95 8.05 9.46 9.90 1.94 2.01 2.06 2.09 2.08 2.06 2.05

This problem expands Compaction-05: A Modified Proctor compaction test is performed on a clayey gravel road base. The solids have a specific gravity of 2.65. The compaction data yielded the following binomial values for ya/yw versus w %: w(%) 3.00 4.45 5.85 6.95 8.05 9.46 9.90 1.94 2.01 2.06 2.09 2.08 2.06 2.05

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

-tile with dimensions of ( 30x30x3) cm, if the surface absorption of tiles is (0.35gm / cm2), , the weight of wet sample equal (6.65 kg), the weight of dry sample equal to
A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The environmental temperature around the tank varies from -25°C to 30°C. The tank's exterior surfaces (total = 125 m²) have four different levels of insulation as indicated in the table. Surface Component Area, Effective RSI, 2 2 m². °C/W m² Surface A 60.0 Surface B 30.0 Surface C 30.0 Surface D 5.0 Say that just one surface can be selected to have its insulation upgraded such that its effective RSI would be doubled. Which should be selected to achieve the greatest reduction in heat loss? 10.0 15.0 4.0 0.5
Mc = 3050g Ms = 800g Mss = 820g Mws = 3450g Calculate the values of: Mw = Ms 1. Bulk (O.D.) Specific Gravity = (Mc+Mss-Mws) Mss 2. Bulk (SSD) Specific Gravity =- (Mc+Mss-Mws) Ms 3. Apparent Specific Gravity =. (Mc+Ms-Mws) Mss-Ms 4. Percent Absorption = x 100% Ms
The heat loss, in Btu/hr, for two different types of walls is given. Find in Btu/hrthe difference in the heat losses.
zone of aeration in soil profile represents ? a ) the zone below water table b) the zone of saturated water c) the zone of artesian water d) the zone above water table
Wet coal is dried in a continuous rotary dryer that operates at atmospheric pressure. The chips with a water content of 40 wt% and must leave with a moisture content of less than 15%. Hot air is fed to the dryer at a rate of 11.6 m (STP)/kg wet coal. HOT AIR MOIST AIR DRYER WET COAL DRIED COAL To monitor the performance of the dryer by sampling the exiting coal and determining their moisture content directly would be a cumbersome procedure and almost impossible to automate. Instead, wet- and dry-bulb thermometers are mounted in both the inlet and outlet air lines, and the moisture content of the exiting chips is determined by a material balance calculator. (STP: Standard Temperature and Pressure is 0*C and 101.325 kPa) (a) The hot air stream has an absolute humidity of 0.058 kg moisture/kg dry air and leaves with 0.087 kg moisture/kg dry air, calculate the mass of water in the exiting air per kilogram of wet coal fed. (b) Can the dryer reduce the wet coal moisture to 15%? If the answer…
Detail explainatory solution required
This is not an assignment. Please give me right solution according to the question
This is also known as the groundwater zone. Select the correct response: Capillary Fringe Soil water zone Saturated zone Aeration zone
5-18. The solubility product of calcium fluoride (CaF2) is 3.45 x 10-" at 25°C. Will a fluoride concentration of 1.0 mg/L be soluble in a water containing 200 mg/L of calcium?
A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The environmental temperature around the tank varies from -25°C to 30°C. The tank's exterior surfaces (total = 125 m²) have four different levels of insulation as indicated in the table. Surface Component Area, Effective RSI, 2 2 m². °C/W m² Surface A 60.0 Surface B 30.0 Surface C 30.0 Surface D 5.0 Say that just one surface can be selected to have its insulation upgraded such that its effective RSI would be doubled. Which should be selected to achieve the greatest reduction in heat loss? 10.0 15.0 4.0 0.5
3. 6.0" wide wooden fence posts are embedded in a concrete driveway a distance 12.125" apart. There is a 1/16" gap between the post and the concrete (see diagram). The posts are installed when the temperature is 12°C. Determine if the gap will close when the temperature increases to 32°C and if not how big the gap will be at that temperature. The thermal expansion coefficients of wood and concrete are awood =32 x 105 °C and aconcrete =13 x 106 °C. 1 inch3D2.54 cm. 6.0" 12.0" 0.0625"