The voltage, current and power factor at the sending end of a single-phase transmission line are 2400 V, 30 A and 0.75 lagging. The entire load is concentrated at the line end, 7 miles from the source end. The resistance and reactance of each conductor per mile are 1.1 Ω and 0.8 Ω respectively. Find the voltage at the load end.

The voltage, current and power factor at the sending end of a single-phase transmission line are 2400 V, 30 A and 0.75 lagging. The entire load is concentrated at the line end, 7 miles from the source end. The resistance and reactance of each conductor per mile are 1.1 Ω and 0.8 Ω respectively. Find the voltage at the load end.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.9MCQ

See similar textbooks

Similar questions

Q2: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. The capacitance in µF/km without effect -1 of ground is إجابتك The capacitance in µF/km with effect of -2 ground is
Determine the inductance per km per phase of a single circuit 460 KV line using two bundle conductors per phase as shown in the figure. The diameter of each conductor is 5 cm. 40cm 6.5m 6.5m 13m
In Transmission Line, the DC and AC Resistance will always be equal. Select one: True False
A 5 km long, 3-phase 34.5 kV line has a horizontal configuration of 4 ft. spacing. The conductor is 336.4 ACSR with GMR of 0.0244. What is the inductance of the line? * A. 7.63 mH B. 4.76 mH C. 5.33 mH D. 6.49 mH
Over string of three phase transmission line has a four insulators and Ce=D0.12 C. If the voltage between the steal pin of the first insulator and the metal cap of the third insulator is 33 kv. 1- Find the voltage distribution over the insulator. What will be the string efficiency 2- Ifthe sting is supplied by a guard ring and this lead to add one air capacitance of value 0.2 C. What will be the new distribution over the insulators and what will be the new string efficiency.
The energy loss due to dielectric losses of a 15 kV cable is given as 1MWh. The capacity value of the parallel equivalent circuit of the solid insulator of this cable is 3.5 nF and the mains frequency is 50 Hz. If so, find the ohmic resistance value of the parallel equivalent circuit of this cable insulator.
A current is measured at the neutral ground of a star load, of equal impedances in all three phases. Which of the following conditions is NOT possible?A) The currents in the three phases are equal in magnitude and angle.B)One phase of the supply conductors was left in open circuit.C) The line-to-neutral voltages in the load are equal in magnitude and with 120° phase shifts between them.D) None of the above
Considering line losses electricity will be conducted 120 km far away with an aliminumcable. X=35m/Qmm? j=1,1 A/mm? coso=0.97 b) At what value should the voltage be in order to conduct with % 5 losses? Choose the most suitable one below. O a. 262,5 kv O b. 219 kV O C. 135 kV O d. 122,4 kV O e. 144,3 kV O f. 120,3 kV
The resistance and reactance of the single-phase 60Hz transmission line conductors are 7.6 ohm and 6.6 ohm respectively. The transmission line delivers 20MW at a power factor of 0.66 lagging to the load with 54kV receiving end voltage. Determine the following a) The inductance of the transmission line in mH b) Sending end power factor c) Percentage voltage regulation d) Percentage Efficiency
The following single-phase loads are connected to a 415V three-phase supply. Z, = (25 - j15)0, Z, = (45+ j10)2 and Z, = (5+ j30)2. Answer questions 37 and 38. -. What is the current in amperes in the red phase? A. 6.65233.69 D. 5.60233.69 B. 8.23/30.96 C. 14.23430.96 Find the magnitude of the current in the neutral conductor in amperes. A. 18.16 с. 21.33 B. 14.23 D. 12.54 E. 15.68 . A three-phase supply energizes three resistive single-phase loads which draw the following currents: 1, =84, 1, = 6A and I, = 24. What is the magnitude of the neutral current? A. 8 В. 16 С. 5.29 D. 12.49 E. 5.61
Solve for the voltage drop in the lines: For Phase A, B and C.
A 13.2 kV, 3 miles transmission line is composed of 336,400 Cmil, 26/7 (Linnet) acsr has GMR of 0.0244 ft and a resistance of 0.306 ohm per mile. The conductors are spaced horizontally 3 ft apart. What is the series impedance? A. 0.918+j 1.385 B0.918+j 1.835 C. 0.918+j 1.538 D. 0.918+j 1.358