The vehicle in the shown figures moves from point 1 to point 2 as follows:V1 =103 m/sV2 = 36 m/s%3DTake:L = 158 mB = 27 °Mass of the Vehicle = 1746 kg%3DDetermine the power needed to perform this movement from point 1 to point 2 with the above conditions.Neglect air and friction effects.2g = 9.81 m/s² 2g = 9.81 m/s2

Given that, Velocity at section 1, V1=103 m/sec,Velocity at section 2, V2=36 m/sec,Lenght between…

The vehicle in the shown figures moves from point 1 to point 2 as follows: V1 = 103 m/s V2 = = 36 m/s Take: L = 158 m B = 27° Mass of the Vehicle = 1746 kg Determine the power needed to perform this movement from point 1 to point 2 with the above conditions. Neglect air and friction effects.

The vehicle in the shown figures moves from point 1 to point 2 as follows: V1 = 103 m/s V2 = = 36 m/s Take: L = 158 m B = 27° Mass of the Vehicle = 1746 kg Determine the power needed to perform this movement from point 1 to point 2 with the above conditions. Neglect air and friction effects.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The crane shown in the figure is lifting a 186-kg crate upward with an acceleration of 4.21 m/s². The cable from the crate passes over a solid cylindrical pulley at the top of the boom. The pulley has a mass of 195 kg. The cable is then wound onto a hollow cylindrical drum that is mounted on the deck of the crane. The mass of the drum is 136 kg, and its radius (the same as that of the pulley) is 0.198 m. The engine applies a counterclockwise torque to the drum in order to wind up the cable. What is the magnitude of this torque? Ignore the mass of the cable. Pulley- Drum Boom Number I Units N-m
A crate of 69 kg simply stands on the moving cart with constant acceleration a. The height from the center of gravity to the cart, L, is 1.4 m, and the angle = 13°. What is the maximum acceleration a (in m/s²) the cart can have without sliding on the cart? The coefficient of static friction between the crate and the cart is μl g = 0.51. Please pay attention: the numbers may change since they are randomized. Your answer must include 3 places after the decimal point. Take g = 9.81 m/s². 0.5 m 0.5 m L Your Answer: Answer G
4. An airplane weighing 5500 kg is in a steady level flight with a speed of 225 m/s. The pilot initiates a steady pull-up maneuver with a radius of curvature of 775 m. The location of center of gravity (CG), center of pressure on wing (CP) and point of action (T) of tail force are marked in the figure. Use g = 9.81 m/s³. Neglect drag on the tail and assume that tail force is vertical. Assuming the engine thrust and drag to be equal, opposite and collinear, the tail force kN (round off to one decimal place). 20 cm CG
In a modified version of the cart and bucket, the angle of the slope is alpha = 34.9∘ and the bucket weighs 295 N. The cart moves up the incline and the bucket moves downward, both at constant speed. The cable has negligible mass, and there is no friction. What is the weight of the cart?What is the tension in the cable?
O 5 kg 2m The figure above shows a block rotating in a vertical circle at the end of a string. At P, the string pulls down on the block with a force of 20 N (b) Calculate the speed of the block at point P.
PROBLEM 4.0 Find the value of Friand Fr2 and the acceleration of each body. P₁ FT2 A 200 N FTI B 300 N P₂
A cart is moving in a track which is shown in the bellow picture(both friction and rotation is not acting on this cart) v = 0 50 m 50 m 40 m 20 m (1)Draw an energy diagram as the cart moves on the track (kinetic energy, potential energy, and the total energy lines are required) (2)Label the points where the cart is in stable equilibrium, unstable equilibrium, and any turning points (3)Find the Maximum and Minimum speed.
This question is similar to the question above but read and calculate carefully. The situation has changed and the numbers have changed. Bonita Cart Bonita is again pulling a cart to the right. The cart used to be tied to a wall but now the rope has broken so the cart rolls over the horizontal floor without friction. Assume that the only forces on the cart are tension forces (including the force from Bonita), normal forces, and gravity with g = 9.81 m/s?. Bonita's shoes do not slide over the floor. Bonita has a mass of 52 kg. The cart has a mass of 45 kg. The mass of the rope is small enough to be ignored. Bonita is pulling the cart with a constant force of 283 newtons. Calculate the magnitude of the force that the cart exerts on Bonita. Note that the magnitude of a force is a positive quantity.
A helicopter with a mass of 10,000 kg takes off straight up at t=0. The thrust of the engine is defined given as a function of time: FT= 95 0.18t- (kN). Where t is in units of seconds. How fast is it rising and what is its elevation at t=4s?
A crate of 67 kg simply stands on the moving cart with constant acceleration a. The height from the center of gravity to the cart, L, is 1.2 m, and the angle = 12°. What is the maximum acceleration a (in m/s²) the cart can have without tipping over on the cart? The coefficient of static friction between the crate and the cart is μg = 0.55. Please pay attention: the numbers may change since they are randomized. Your answer must include 3 places after the decimal point. Take g = 9.81 m/s². 0.5 m 0.5 m L Your Answer: ● 0 Answer G
An elevator weighing 2,000 lb attain an upward velocity of 16 ft/sec in 4 seconds with uniform acceleration. What is the tension in the supporting cables?
Kindly answer correctly. Please show the necessary steps. Thanks in advance