The temperature affects biological purification in many ways. Large treatment plants are often outdoors, which can give varying temperatures in the pools. Reason about a municipal treatment plant and describe at least three effects of the temperature when you compare a summer month with a winter month.

The temperature affects biological purification in many ways. Large treatment plants are often outdoors, which can give varying temperatures in the pools. Reason about a municipal treatment plant and describe at least three effects of the temperature when you compare a summer month with a winter month.

Basic Clinical Laboratory Techniques 6E

6th Edition

ISBN:9781133893943

Author:ESTRIDGE

Publisher:ESTRIDGE

Chapter1: The Clinical Laboratory

Section1.8: Laboratory Math And Reagent Preparation

Problem 2.1CS

See similar textbooks

Similar questions

Which of the following can most likely increase the yield of recrystallized benzoic acid? CHOICES: A fluted filter paper was used during cold filtration. The receiving flask from hot filtration does not contain a small amount of solvent. Activated charcoal was not added to the solution. The solution was filtered immediately after hot filtration.
In sterilization, which among the supplies, instruments, glassware, etc. under the list of materials can be sterilized using either or both equipment below? List them down. For "autoclaving" For Dry heat oven Can be sterilized only sterilization with either Materials: 200-ml Erlenmeyer flask Stove 500-ml Erlenmeyer flask Autoclave 10-ml graduated cylinder Analytical balance 100-ml graduated cylinder pH meter Spatula Stirring rod 100-ml beaker Test tubes Distilled water Petri dish Stirring rod Alcohol lamp Glass dropper
You carry out a dilution adding 20 mL of solution A and 80 mL of water. This dilution can NOT be expressed as: 1 in 4 dilution. 1:4 dilution. 5 fold dilution. having a dilution factor of 5. 1 in 5 dilution.
What is the minimal concentration (MIC) for disinfectant number 1? Just write the corresponding number including the decimal as written. ug/mL. Disinfectant 1 2 3 4 concentration 0.1 ug/mL +++ ++++ ++ +++ 0.2 ug/mL ++ ++ + ++ 0.5 ug/mL + + 1.0 ug/mL 5.0 ug/mL subculture 1 2 3 4 0.1 ug/mL ++++ ++++ ++++ ++++ 0.2 ug/mL ++++ ++++ ++++ ++++ 0.5 ug/mL ++++ ++++ ++++ 1.0 ug/mL ++++ 5.0 ug/mL Submit response
Suspend 28.0 grams in the 1000 mL distilled water. Heat to boiling to dissolve the medium completely. Sterilize by autoclaving at 15 lbs pressure (1210C) for 15 minutes. Cool to 45-500C. If desired the medium can be enriched with 5-10% blood or other biological fluids. Mix well and pour into sterile Petri dishes. 1. Determine the amount of dehydrated medium needed to prepare 50 nutrient agar plates. Include amount for 2 additional plates as excess to compensate for compounding losses.
In pharmaceutical companies, Sterilization is an important step for quality assurance and approval of pharmaceutical products. Based on this concept, answer the following questions. What are the factors that affects the efficiency of the disinfectant
What are the main types of immobilization techniques used in biosensors? (with a deep explanation)
Explain the different categories that determine when equipment must be disinfected or sterilized. Identify a common cleaning and disinfectant solution. Describe the recommended application and purpose for each solution.
A water quality control board reports that water is unsafe for drinking if the proportion of nitrate concentration exceeds 21% ppm. Water specimens are taken from a well. ?o: ??:
Please explain why is 70% ethanol used as an effective disinfecting solution in labs? Why not 95% ethanol? Please include references.
discuss in detail the process of water purification.
The most efficient disinfectant chlorine, discuss why? ( subject: medical microbiology lab )