The saturated NC clay is 8 meters deep. The moisture content is 40% and the specific gravity is 2.5. If we know that loading increased the effective stress in the middle of the layer by 270 kpa, then answer the following questions. (cc = 0.2, Cs = 0.05) 1. Calculate the settlement after the consolidation. 2. Calculate the void ratio after consolidation. 3. Calculate the volume compressibility coefficient in terms of Kpa

The saturated NC clay is 8 meters deep. The moisture content is 40% and the specific gravity is 2.5. If we know that loading increased the effective stress in the middle of the layer by 270 kpa, then answer the following questions. (cc = 0.2, Cs = 0.05) 1. Calculate the settlement after the consolidation. 2. Calculate the void ratio after consolidation. 3. Calculate the volume compressibility coefficient in terms of Kpa

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter10: Shear Strength Of Soil

Section: Chapter Questions

Problem 10.20P

See similar textbooks

Similar questions

2- An undisturbed clay has a preconsolidation pressure of 200 lb/ft. A laboratory consolidation tests yield the following data: o' (lb/ft') e 0.92 3,130 6,270 0.77 a) Determine the void ratio that corresponds to a pressure of 5,800 (Ib/ft). b) Determine the coefficient of volume compressibility for the pressure range stated. c) If C, = 1 x 10* in?/sec, determine hydraulic conductivity, k in in/sec corresponding to the average void ratio within the pressure range.
Refer to the soil profile shown in figure below. A laboratory consolidation test on the clay gave the results: o'c = 100 kPa Cc = 0.4 Cs = 0.2Cc If the average effective stress on the clay layer increases by 60 kN/m², what would be the total consolidation settlement in cm. Dry sand; e = 0.55 G,= 2.66: Sand G₂ = 2.66 e = 0.48. Clay w 34.78% G₂ = 2.74 Rock 1.5 m. 5 m Water table;
The water content of a sample of saturated soil at a mean effective stress of 10 kPa is 85%. The sample was isotropically consolidated with a mean effective stress of 150 kPa. At the end of the consolidation, the water content was 50%. The sample was then isotropically unloaded to a mean effective stress of 100 kPa, and the water content increased by 1%. Given: Gs = 2.7, o'cs = 25°. a) Calculate and K. 10 b) Determine the failure stresses (p'f and gf) under CU test and CD test for the conditions.
Find the C, and the "apparent" OCR for a superficial clay stratum that is 4m thick. The water is at the surface. A sample of the clay has a water content of 27.9%, and a specific gravity of 2.65. An oedometer test showed the following results: Voids Ratio 0.736 0.733 0.73 0.675 0.638 0.6 Vertical Effective Stress 15 28 60 230 480 930
A saturated clay specimen is subjected to a pressure of 240 kN/m2. After the lapse of a time, it is determined that the pore pressure in the specimen is 72 kN/m2. What is the degree of consolidation? Show free body diagram. a.75% b.60% c.70% d.65%
The layer is subjected to a uniform vertical stress increase of 100 kPa. The singly-drained clay layer has a coefficient of consolidation of 20 ft2 /yr. Determine the value of the excess pore pressure at point A 2 years after the application of the load. Also given is the chart giving the local degree of consolidation. a)4.4 kPa b)44 kPa c)88 kPa d)96 kPa
A given saturated clay is known to have effective strength parameters of c' = 10 kPa and = 28°. A sample of this clay was brought to failure quickly so that no dissipation of the pore water pressures %3D could occur. At failure it was known that o KPa, o = 10 KPa and = 20 kPa. %3D (a) Estimate the values of o, and oz at failure (b) Use the Mohr circle to illustrate the effective stress and total failure stress.
1. The pressure versus void ratio data determined from a consolidation test on an undisturbed clay specimen are as follows: Applied Pressure (kPa) 20 40 80 160 320 640 1280 320 80 20 0 Void Ratio 0.953 0.948 0.938 0.920 0.878 0.789 0.691 0.719 0.754 0.791 0.890 (a) Plot this pressure versus void ratio data on a semi-logarithmic graph. (b) Determine the equations for the virgin compression curve and for the rebound curve for unloading starting at 1,280 kPa. (c) What are the corresponding compression and recompression indices for this soil? (d) Estimate the stress to which this clay has been preconsolidated. (After A. Casagrande.)
Refer to Figure 11.41. Given that B =1 m, L = 3 m, and Q = 110 kN, the soil characteristics given in the figure are Cs = 1/5 Cc, Ꝺ’c= 40 kN/m2. Field monitoring indicated that the foundation settlement was 19 mm during the first 12 months. a. Estimate the average stress increase in the clay layer due to the applied load. b. Estimate the primary consolidation settlement. c. What is the degree of consolidation after 12 months? d. Estimate the coefficient of consolidation for the pressure range. e. Estimate the settlement in 24 months. Answer must be: A. 6.33 B. 32.82 C. 57.89 D. 0.0013 E. 25.66
The coefficient of permeability of sand at a void ratio of 0.80 is 0.47 mm/s. Estimate the coefficient of permeability of this sand at a void ratio of 0.50.
In a normally consolidated clay specimen, the following data are given from the laboratory consolidation test. e₁ = 1.10 σ= 65.0 kN/m² €₂ = 0.85 o₂ = 240.0 kN/m² a. Find the compression index C. b. What will be the void ratio when the next pressure incre- ment raises the pressure to 460.0 kN/m²?
A 75 mm diameter clay specimen was consolidated in an oedometer under 200 kPa. At the end of consolidation, the void ratio is 0.863 and the specimen thickness is 18.51 mm. When the stress increment of 200 was added to the current vertical stress of 200 kPa, the specimen consolidated to a thickness of 17.56 mm. Assuming that the clay was normally consolidated under the vertical stress of 200 kPa, find the a) coefficient of volume compressibility in (MPa)^-1 and rounded to the 3rd decimal place.b) and the compression index of the clay rounded to the 2nd decimal place.