The rms current in a 33.0-N resistor connected to an AC source is 2.80 A. (a) What is the rms voltage across this resistor? V (b) What is the peak voltage of the AC source? V (c) What is the average power dissipated by the resistor? W

Q: Consider an electric motor that requires a 120 V rms power source and a current of 1.5 A rms. If the…

A: Given an electric motor that requires a, Source voltage, Vrms=120 V Current, Irms=1.5 A The…

Q: An alternator is supplying a load of 300 kW at a p.f. of 0.6 lagging. If the p.f. is raised to…

A: Given, An alternator is supplying a load of, P1 = 300 kW At power factor, cosϕ1=0.6 lagging Raised…

Q: Determine the average power that is being supplied or absorbed at each element. R, +, R$2052 100°…

A: In an AC circuit, the average power is only consumed by resistor in the AC circuit and the average…

Q: An AC generator causes 50 Hz current in a circuit containing a 290 Ω resistor, 4.89 µF capacitor,…

A:

Q: what is the average power absorbed by the load ZL in watts? Assume source is in rms.

A: The solution can be achieved as follows.

Q: Given the AC signal: v= 200 Sin (377t-30) a) What is the RMS voltage? b) What is the period of this…

A: Given: AC signal v=200sin377t-30°

Q: Compute the rms value of the voltage waveform shown in Fig. v(t) (V) 4 ил. 2 4 6 8 t(s)

A: By using the concept of signal and systems we need to calculate the value of RMS voltage of the…

Q: Example: Find the rms value for the current waveform shown below: 2 1 1 3 4 t(sec)

A: First we will find out the current equation then we will find out RMS value by RMS formula.

Q: The voltage and current at the terminals of a network are v = 15+400 cos 500t+100 sin 1500t V, i =…

A:

Q: 3. A series RC circuit with R=4kQ and C=0.40uF is connected to an AC voltage sour v(t)=100sin200t.…

A: In this question,  Find the rms current, phase difference between current and voltage.  Power…

Q: Two units are con cted in parallel, are energized by an AC source. If the components are 10 and 14…

A:

Q: Find the resultant of the two out of phase current   If the component currents are 12 and 16 amp.,…

A:

Q: Find the average value, RMS value for the waveform shown in Fig. 4 2 3 4 6. Fig. 40om 1. 1,

A:

Q: 2. Find the RMS value of the voltage waveform and the average power absorbed by the 9 ohms resistor…

A: We need to find out RMS value and power absorbed by resistor .

Q: Given an AC source having a voltage v(t)=27sin(249t + 15°) V, find the period of the voltage…

A: Given sine wave equation is, Vt=27sin249t+15° V Consider the general form of the sine wave is,…

Q: An AC generator produces a sinusoidal waveform, given by the expression: (t) = -25 sin(150nt – 30°)…

A:

Q: A load absorbs 72044 W  at a lagging power factor of pf = 0.67. If the current flowing through the…

A: Given: Power, P=72044W power factor, pf=0.67 Current, Ix=0.100 A−rms

Q: CALCULATE THE RMS VALUE IN V OF THIS SIGNAL SHOWN BELOW: 4v = 4 V + 6 sen wt 6 V 4 V wt

A:

Q: The voltage between the ends of a load and the current through it are given by: v (t) = 20 + 60…

A:

Q: The voltage across three component in a series circuit when connected across an AC supply are 30 sin…

A: Brief description : Let us consider a sinusoidal signal  V(t) = Vm sin(wt + Φ) Volt  Vm : Peak Value…

Q: Find the power supplied by the power company. Determine how it changes if the power factor is…

A: Power factor is defined as the ratio of active power to apparent power. It gives an idea about how…

Q: Example 1: Find the instantaneous frequency of the following waveforms, following this equation (f…

A:

Q: 1. Determine the RMS values of voltage and current, and the total power absorbed by the circuit…

A: In this question, two signals are given in harmonic form.  We need to determine the rms value of…

Q: Given an AC source having a voltage v(t)=10sin(97t + 44°) V, find the frequency of the voltage…

A:

Q: Vpk wt 2n

A:

Q: Example 1: Find the instantaneous frequency of the following waveforms, following this equation…

A:

Q: Find the average power absorbed by a circuit component that has a voltage of v = 20.3…

A:

Q: Given an AC source having a voltage v(t)=28sin(305t + 30°) V, find the frequency of the voltage…

A: we need to find out frequency of the voltage waveform.

Q: 1. The single phase ac voltage source is v = 141.4cos(377t)V, the load can be modeled as a 16mH…

A: In the question, Voltage given v=141.1cos(377t)V   Resistance R=8 ohm inductance L= 16mH…

Q: The given data to be used for getting the RMS Values is 0, 5, 10, 30, 50,  70, 50, 30, 10, 5, 0, -5,…

A: In this answer we will find the RMS value using all the given values as explained below. The RMS…

Q: Example: Find the rms value for the voltage waveform given by v(t)=50+30 Sin 0.

A: Voltage wave form is given by  v(t)=50+30sinθ

Q: Compute the rms value of the waveform shown over half cycle Xm

A: RMS of AC is that value which when passes through a resistor of known value for a particular…

Q: c) Define RMS value and average value. Find the form factor and crest factor of the following wave…

A:

Q: Find the RMS value of the current waveform and the average power absorbed by the 9 ohms resistor if…

A: In this question we need to find a RMS value of the given waveform and average power.

Q: Find the rms value of the voltage waveform shown below. If the voltage is applied to a 9-Q resistor,…

A: In this question we will find average power absorbed by resistor...

Q: 13. If an AC signal has an average voltage of 18 V, what is the rms voltage? a. 19.9930 V b.…

A: Solve the problem

Q: 2. Find the RMS value of the voltage waveform and the average power absorbed by the 9 ohms resistor…

A: We will find out RMS value for given waveform and power for given resistor

Q: Find the RMS Voltage and Average Voltage based from the graph

A: It is given that:

Q: i(f) A Answers: 2.31 A, 10.67 W 0 1 2 3 4 5 6 t

A: The solution is given below

Q: Given an AC source having a voltage v(t)=11sin(328t + 44°) V, find the period of the voltage…

A:

Q: 1. Derive the formula for the RMS value for the following a) tespe 文 RSITY SAIN

A: The solution is given below

Q: 169sin 377t        a) What is the RMS value?        b) What is the Average value?

A: Given: Let V=169sin 377t

Q: system, what is the phase of the signal to be obtained from the output?

A:

Q: Example: Find the rms value for the current waveform shown below: 1 1 3 4 6 t(sec)

A: RMS Value of a signal:  It's that steady state equivalent of a time varying signal which would…

Q: current wave consists of two components 1. A DC current of 10A and 2. A sinusoidal AC current of…

A:

Q: Supply voltage has an average value of 20 V. Its RMS value is RMS value, Vrms = %3D

A: If the averages voltage 230V Then rms value?  Assume this is sinusoidal waveform.

Q: iln 01 2 3 4 5 6 7 8 9 10 Fig.2.

A:

Q: The average value of a sinusoidal current is 300A. What is it’s rms value? Group of answer choices…

A:

Q: Which of the following AC power parameters is the closest equivalent to the DC power drawn by the…

A: ac power parameters is closest equivalent to the dc power drawn by the circuit=?

Q: Vm = 10 V T = 2 ms V0 = 7.07 V 1) Find the frequency of the voltage in Hz. 2) What is the frequency…

A:

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.