The reservoir area of the hydroelectric power station is spread over an area of 4000 square meters with a storage capacity of 8 million square meters. 'The net head of available water if the turbine is 70 m Assuming an efficiency of 0.87 and 0.93 for the water bottle and generator respectively, calculate the electrical conversion produced by the plnt. Esima the Jifference in water level if a 30 MW load is continuously combined with a generator for 6 hours.

The reservoir area of the hydroelectric power station is spread over an area of 4000 square meters with a storage capacity of 8 million square meters. 'The net head of available water if the turbine is 70 m Assuming an efficiency of 0.87 and 0.93 for the water bottle and generator respectively, calculate the electrical conversion produced by the plnt. Esima the Jifference in water level if a 30 MW load is continuously combined with a generator for 6 hours.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Similar questions

A generating station has a maximum demand of 20 MW, a load factor of 60%, a plant capacity factor of 48% and a plant use factor of 80% Find: 1)the daily energy produced (2) the reserve capacity of the plant. (3) The maximum energy that could be produced daily if the plant was ruinining all the time.(4).Maximum energy that could be produced daily if the plant was running fully loaded and according to an operating schedule.
5. Draw the daily load curve and load duration curve for a power station with any arbitrary loads you like. From the load curve, determine the following. i. Maximum demand ii. Average demand ii. Daily energy consumption
For a power station the yearly load duration curve is a straight line from 50,000 to 4000 kw. To meet the load three turbogenerators are installed. The capacity of two generators is 20,000 kw each and the 3rd is rated at 7,000 kw. a. Draw the annual load duration curve b. Determine the following the Energy generated per year, Load factor and Annual Capacity factor.
Draw the schematic arrangement of diesel power plant
2. a) Explain the terms load factor and diversity factor. b) Discuss the advantages of interconnected grid system. c) A generating station is to supply four regions of load whose peak loads are 10 MW, 5 MW, 8 MW and 7 MW. The diversity factor at the station is 1-5 and the average annual load factor is 60%. Calculate: (i) the maximum demand on the station, (ii) annual energy supplied by the station and (iii) suggest the installed capacity and the number of units.
Two 60MVA, alternators operate in parallel. The setting of the governor are such that the rise in speed from full load to no load is 2% in one machine and 3% in the other, the characteristics being straight lines in both cases. If each machine is fully loaded when the total load is 120MW, what will be the load on the first machine (with 2% speed regulation) when the total load is reduced to 80MW?
For a power station the yearly load duration curve is a straight line from 50,000 to 4000 kw. To meet the load three turbo-generators are installed. The capacity of two generators is 16,000 kw each and the 3rd is rated at 7,000 kw. Determine the following a) Load factor. b) Capacity factor. c) Maximum demand.
1-Alternators can be overloaded by 10 percentage for 10-15 minutes, this a. Steady state voltage stability will get affected b. may reduce the stability limit c. may disturb Nose point d. may lose Angular stability 2-Often, the network is referred as an infinite bus when a change in input mechanical power or in field excitation to the unit does not cause an appreciable change in a. system frequency or terminal voltage b. system frequency alone c. system frequency and terminal voltage d. Total production cost
As seen in the figure, three generators of 800 kW, 900 kW and 1000 kW are connected in parallel. It generators feed 380 kW load. Frequency-active power graphs of generators are shown as given. According to this; a. Calculate the operating frequency for the situation given in the question.b. Calculate the power transferred by the generators to the load.c. A three-phase asynchronous load of 800 kW and 600 kVA with a reverse power coefficient of 0.78 is installed in the system. engine is connected. The new operating frequency of the system and the active power of the alternators. calculate.d. Do you think the generators in this system are suitable for parallel connection as in the figure?
5. Two 75 MVA 3-phase alternator are connected in parallel. The speed load characteristic of the first generator is 2% from no-load to full load while that of the second alternator is 3% from no-load to full load. The machines are fully loaded when the load is 150 MVA. If the load is reduced to 80 MVA. Calculate the load carried by each machines?
Turbine operating efficiency is not influence to maintain the minimum cost of power generation True False
Load on a small power station is as under. Draw the load curve and calculate 1. Maximum demand 2. Units generated in a day 3. Average demand 4. Daily load factor.