The reading of the current that would be observed on a moving coil ammeter when the current in the circuit shown in the below figure is measured is equal to (useny 6 IT -6 3.54 A 4.24 A None of the above lindowr

The reading of the current that would be observed on a moving coil ammeter when the current in the circuit shown in the below figure is measured is equal to (useny 6 IT -6 3.54 A 4.24 A None of the above lindowr

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Find the current that flows through the filament of a 400 watts flat iron connected to a 220 Volt…

Q: 18. A circuit is composed of a resistance of 22 ohms, an inductance of 0.11 henry and a capacitance…

A: given here a parallel RLC circuit with R= 22 ohms and L= 0.11henry and C= 12 micro farads voltage…

Q: The current flowing through Aluminum is called Radiation Conduction Convection None of these A…

A: Choose the correct option The current flowing through aluminum is called?

Q: A 5.3 V zener is rated at 1.5 watt. The maximum zener current is equal to Select one: О а. 2.83А. O…

Q: A coil takes a current of 4 A when 24 V d.c. are applied and for the same power on a 50-Hz a.c.…

A: PART (a): For a Coil, Z=R+jXL Where, R= Resistance of the coil, XL=Inductive reactance of the coil.…

Q: The reading of the current that would be observed on a moving iron ammeter when the current in the…

A: Moving iron meter measure the rms value of the signal applied to the meter. Given signal is sine…

Q: 70. A circuit supplies a continuous load of 38 amperes and is protected by a 50-amperecircuit…

A: While calculating the conductor size for a continuous load, take 125% of overloading conditions…

Q: Question 4: The Transformer A current transformer is used to provide a range of values of 5A, 1A and…

A: Given, Np=4Ip=5 A, 1 A, 0.5 AIsf=120 mA

Q: Circuit II A series circuit composed of 100 ohms resistor and a 20 microfarad capacitor connected…

Q: A 60Hz voltage source of 35 V is applied to a circuit with a 257 ohm resistor, a 0 H inductance…

Q: The current of an auto recloser of a 11 kV primary distribution system is 20A. What will be the…

A: It is usually preferable for electricity flow via the lines to be uninterrupted for an extended…

Q: Two (2) 115-V incandescent lamps A and B are connected in series across a 230-V source. If lamp A is…

A: Given two bulbs connected in series Bulb-1 Vrated=115 v Prated=75 w Bulb-2 Vrated=115 v Prated=50 w…

Q: The KVL equation in an electric circuit consists of_ a. Both EMF and voltage drops in the circuits…

A: KVL equation

Q: H.W. 1.2: Determine the current flowing at the instant of switching a 60 watt lamp on a 230 V…

A: The solution can be achieved as follows.

Q: 2) 122 L= 5MH lle 6A 32v

Q: 3. A 0-20A range ammeter is to be used to measure a current of 1500A with the help of a suitable…

A: Given Range of the Ammeter is 0-20 AThe ammeter measured current of 1500 AThe primary winding turns…

Q: 13 20 4 V if 14 12 15 2 V=

Q: Which of the following will obey ohm's law? а. Temperature is constant

A: Ohm's Law states that the current flowing in a circuit is directly proportional to the applied…

Q: A Certain winding made up of copper has a resistance of 100 2 at room temperature. If resistance…

Q: The reading of the current that would be observed on a moving iron ammeter when the current in the…

A: In this question we wil find moving into meter output when current passing through it...

Q: H.W. 1.2: Determine the current flowing at the instant of switching a 60 watt lamp on a 230 V…

A: The solution can be achieved as follows.

Q: which of the following diagrams below show the corewct current directions at a junction in an…

A: Kirchhoff's Current Law: Kirchoff's current law states that algebraic sum of currents entering and…

Q: Determine the current through the 4 Q resistor in following circuit. 義22 2A SA

A: Using source transformation reduces the voltage source and current source into equivalant single…

Q: 12 volt source with an internal resistance of 1.2 ohms is connected across a wire-wound resistor.…

A: According to maximum power transfer theorem, to transfer maximum power variable load resistor must…

Q: An arc lamp takes 9.6A at 55V. It is operatedfrom a 120V supply. Find the value of the stabilising…

A: Given Supply voltage =Vs=120 V Arc lamp current IL=9.6 A Drop across lamp is VL =55 V

Q: The reading of the current that would be observed on a moving iron ammeter when the current in he…

Q: Three coils each having resistance of 25 n are connected in star across 415 V, 50 Hz supply. Then…

Q: What is the current in this circuit? 221UF 300 44.2uF 50V /0° 60HZ

Q: Three coils each having resistance of 17 Q are connected in star across 415 V, 50 Hz supply. Then…

A: The power consumed in a 3 phase circuit is P=3Vl2R=3Il2.R Vl = 440 volt R=17 ohm

Q: Calculate the unknown currents in the following circuit 0.5A 242 a 4A4 82 40V 2A

Q: Three coils each having resistance of 14 N are connected in star across 407 V, 50 Hz supply. Then…

A: Given, Line voltage, VL= 407 V so, phase voltage, Vph= 234.98 V Resistance, R= 14 ohm

Q: When a coil with an internal resistance is connected to a 160 volt DC source, the current becomes 20…

A: GivenCoil with internal resistance is connected at AB terminalsWhen V1= 160 v DC source applied the…

Q: 5. A coil takes a current of 4 A when 24 V d.c. are applied and for the same power on a 50-Hz a.c.…

Q: Deter mine the turns ratio o that maximum power ir delirered o the 7ee rerirtor. 202 722 Vrms

A: In this question we will find turn ratio for maximum power transfer... According to maximum power…

Q: 4.41 Determine the equ a 32 20

Q: A moving iron ammeter has the following data Control spring constant = 7 x 10 º N. m/rad. Current, I…

A: Given: k=7×10-6 N.m/radI=5 AL=7+4θ-0.8θ2 μH

Q: Three coils each having resistance of 12 Q are connected in star across 436 V, 50 Hz supply. Then…

Q: Determine the resistance of a coil connected to a 150 V supply when a current of (a) 75mA (b)…

A: Here i have derived the answer using ohms law.

Q: Two coils A and B are connected in series across 200 V, 50 – Hz AC supply. The power input to the…

A: Given two coils A and B are connected in series across the 200 v,50 Hz AC supply Power input to the…

Q: Question 3. Write KVL around the circuit in Figure below. Solve for IB.

A: KVL, states that “in any closed loop network, the total voltage around the loop is equal to the sum…

Q: Given a coil with 60 turns and is carrying 2.5A. What is the mmf? wwww Aww

A: This question belongs to electrical machine . When current flows through a coil then mmf ( magneto…

Q: Q Two voltmeter of (0-300 V) range are connected in parallel to a A.C. circuit. One voltmeter is…

A: In this answer let us discuss the types of voltmeters and the values they read when connected across…

Q: Three coils each having resistance of 14 2 are connected in star across 407 V, 50 Hz supply. Then…

Q: Three coils each having resistance of 28 Q are connected in star across 434 V, 50 Hz supply. Then…

A: Need to find power

Q: Si IR Vo +12 Vo 1.8 V Ip 680 N

Q: 3. The value of Vin the circuit shown in the given figure is 3 V ЗА (a) 1 V (b) 2 V (d) 4 Y CH

A: According to the question we have to find the value of the V.

Q: 6. A coil consists of 2000 turns of copper wire having a cross-sectional area of 0.8 mm^2. The mean…

Q: A generator supplies power to a factory through cables of total resistance 20 ohms. The potential…

Q: Two (2) 115-V incandescent lamps A and B are connected in series across 230-V source. If lamp a is…

A: Given

Q: The current of an auto recloser of a 11 kV primary distribution system is 20A. What will be the…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

The reading of the current that would be observed on a moving coil ammeter when the current in
the circuit shown in the below figure is measured is equal to
cuseny
6
IT
-6
3.54 A
4.24 A
None of the above
Vindowr

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What will be the value of magnetic field intensity of a 4 meter long coil, when the coil has 220 turns and carrying a current of 0.4 A.
What is the effect on induced voltage of adding more turns of wire to a coil
A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158 volts, 50 Hz supplies the combination. Determine the following: a. Circulating current b. Voltage across the resistor c. Voltage across the capacitor
Determine the loop currents Ia, I,, and Ic. 100 Ic 100 100 100 100 Ib 55V 100 V la
Choose the correct answers The coil winding in PMMC meter is -1 small heavy large fine
Could some please provide an explanation for VL why 15 and 1.33
How many turns are on a coil if a current of 1350mA produces a magnetic flux of 1.5mWb in a magnetic circuit having a reluctance of 160 kA-turns/Wb
Which of the following would have a greater amount of inductance if connected to an AC power source? a) a coil wound around a wooden core b) a coil wound around a iron core c) they would both be the same d) neither would have any inductance
A snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current of the Thyristor (5 µA) and frequency (50 Hz). Find the rate of voltage changing with time and snubber circuit power losses?
Consider the following statements :A clamper circuit 1. adds or subtracts a dc voltage to a waveform 2. does not change the waveform 3. amplifies the waveform Which are correct? * O 1,2 O 1,3 O 1, 2, 3 O 2,3
There is 50 mA of current through a coil with 250 turns. The flux is 150 µWb. What is the mmf? What is the reluctance of the circuit? A. Fm = 1.25 At - R=4.3x10-3 At/Wb B. Fm = 2.25 At - R=8.3x10-3 At/Wb C. Fm = 1.25 At - R=8.3x10-3 At/Wb D. Fm = 1.25 At - R=8.3x10-2 At/Wb
For the series RL circuit shown in the figure below, answer the following questions and justify your answer.If the current is kept constant, does the coil have inductance?If the current is kept constant, does the coil affect the current value?Can the reverse emf ever be greater than the battery emf?