an ammeter has a range of (0-5a) and an accuracy of ±1% of f. s. d. what is the measured value for the actual current reading of 3a?

Q: f galvanometer is 8 mm / µ A. If the internal re cer is 80 ohm then the deflection of galvanome n…

A: In this question P,Q,R,S given..V given..Current sensitivity and internal resistance of galvanometer…

Q: Q1. Figure below shows two systems that might be used to control the temperature of a room. Explain…

A: Thermistor : It is a type of sensor device that converts the temperature which is measured measured…

Q: -Apotential difference of 2Vismaintained across a 80 resistor fora period of 22s. What total charge…

A:

Q: riate tests if this system is

A: A linear time invariant system is called causal when,  x(t)=0 for t<0 otherwise non-causal.

Q: The ammeter reading is 3A. What is the value of R? What is the directon of the current in the meter?…

A: Given circuit diagram,

Q: Can you show where will the needlepoint in the multimeter be if the reading is at (diagram or…

A: Electrical devices are used for measuring electrical parameters. Current, voltage, resistance and…

Q: Question -07 A 0-10V PMMC meter reads 4V reading. Suddenly spring snaps at one place, then the meter…

A: When the spring snaps at one place , then the meter shows a reading of 0 V.

Q: calculates the intensity and the voltage drop for each resistance

A:

Q: Which of the following meters have a linear scale? a. Moving iron meter O b. Moving coil meter O c.…

A: Non linear scale is because of torque pruduction is due to square of current . Due to non linear…

Q: What is the total charge of 555 electrons?

A: In this case, the total charge of 555 electrons needs to be determined.

Q: The breakdown strength of air is about 1 000 000 V/m. Estimate the voltage difference required for a…

A:

Q: For measuring a voltage of 230V. a five year old digital voltmeter is used and it shows a reading of…

A: For Measureing a voltage of 230V Five year old DVM reading 232.5V Then it's means?

Q: When the switch in the circuut is closed the reading on the Ammeter is 2A and the readings on both…

A: The solution for given question is as follows.

Q: Part A What must the emf E in the figure (Figure 1) be in order for the current through the 7.00 2…

A: In this question we need to find a value of unknown voltage source so that current through 7 ohm…

Q: As the coil is moved up and down is there a difference in the way the ammeter reads? What causes…

A: In a magnetic field if we move coil up and down and it cut the magnetic field then we see some value…

Q: When the switch S is open in the circuit shown below, the reading on the ammeter A is 2.25A. 20 0…

A: (b) When the switch is open the equivalent resistance of the circuit, R=15+20=35Ω Then, the voltage…

Q: 1. What is the reading value of the voltmeter when the excitation circuit is оpen

A: The reading value of the voltmeter will be residual voltage.

Q: The value of a resistor R is to be determined using the ammeter-voltmeter setup shown in Figure…

A:

Q: Estimate thermal voltage for 30o C.

A: The thermal voltage (VT) is a very important quantity in semiconductor physics. It is dependent on…

Q: What is the voltage will produce 3A through a circuit that has 15ohms of resistance?

A: We need to tell about voltage .

Q: The hot resistance of an incandescent lamp is 10 ohms and the rated voltage is 50 V. Find the series…

A: The obstruction offered to the path of current is called resistance. The electrical element that…

Q: Determine the ac resistance at 25 mA.

A:

Q: A tungsten lamp filament has a temperature of 20.5 degrees Celsius and a resistance of 500 ohms when…

A:

Q: If the average of set of voltage reading is 55.3V. The precision for one of the reading 51.8 will be…

A: Given Data: Yn = 55.3 Xn = 51.8

Q: A current 0.25 A exits in a 60-ohm lamp. The potential difference is

A: Given data, Current is given I = 0.25 A Resistance is given R = 60 ohm.

Q: sketch a diagram showing the ohmeter face for a reading of 1.2 k resistance indicate the setting of…

A: The use of an ohmmeter is to measure the resistance between its leads. This resistance between its…

Q: If Np/Ns = 2, and the primary voltage is 120 V, what is the secondary voltage?

A: Given data  Turns ratio Np / Ns = 2 Primary voltage  Vp = 120 v Secondary voltage Vs = ?

Q: direct current of 12.5 A flows in a 25-ohm resistance. Determine the maximum value of an alternating…

A:

Q: 3. In the modified figure in this week’s slides, what is annual baseload in MWh?

A:

Q: Match the following It converts the Kinetic energy of Choose... wind to mechanical energy

A: As wind moves past the blades of a wind turbine, it moves or rotate the Blades. So, rotating…

Q: U8 A'S )Determine the current supplied by each Battery in the Grcuit

A: Given:-

Q: What is a clamp-on ammeter and what electrical principal does it operate

A: we need to answer What is a clamp-on ammeter and what electrical principal does it operate

Q: Identify the color code for each of the following resistance values: a ) 150 Ω+ 10 b) 720 kQ ± 5%

A: Given: a) 150Ω±10b) 720 kΩ±5%

Q: 15 V if the switch in the figure is closed the ammeter reading wi indicate

A:

Q: What is the word for meter measure

A:

Q: What is the total lumen quantity in a sphere that measures 2-meter radius and with a light source…

A:

Q: A tungsten lamp filament has a temperature of 20.5 degrees Celsius and a resistance of 500 ohms when…

A: This question belongs to circuit theory . It is based on the concept of relation between resistance…

Q: 33. On opening under load, as the distance between contacts increases, the Resistance of the arc…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: MILL. 2. Could the input and the output impedance of this circuit be measured using an ohmmeter?…

A: ANSWER NO we can not measure INPUT and OUTPUT impedance of the circuit…

Q: A complete electric breakdown may occur and arc may be established between the two electrodes kV/cm.…

A:

Q: A device that transfers energy from one electric circuit to another without change in frequency and…

A:

Q: Determine the approximate value of drain current (ID) of Figure 55. VDD 21M 910kQ 2.2kO 01 110kQ…

A: given here a FET circuit and asked to find the drain current ID .

Q: What current will flow in a 10 ohms resistor if the voltage wave increases linearly from 50 to 100…

A:

Q: A path for electrons to follow; the circuit may be open or closed, depending on the position of its…

A: In order to allow electricity to flow through the loop,  The loop must not include breaks. In other…

Q: 120 V source is applied across three equal resistances in series. How much is each IR drop?

A:

Q: Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the…

A: Given: C1=6 μFC2=10 μFC3=15 μFV=200 V

Q: What potential difference is required across an 8-0 resistor to cause 27.78 A to flow through it?

A: Given, The potential difference, V =? Resistance, R=8 Ω Current, I=27.78 A

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.