The purchased and installation costs of 2m3 glass-lined tank was $2000O in the year 2005. For a size range from 1- 4m3. What is the capital investment for a tank with a capacity of 3 m3 in the year 2019? take the CEPCI at 2019 as 729.7 Chemical Engineering Plant Cost Index (averaged over year) 600 Year CEPCI 2011 585.7 500 2010 550.8 2009 521.9 2008 575.4 2007 525.4 400- 2006 499.6 2005 468.2 2004 444.2 2003 402.0 2002 395.6 2001 394.3 2000 394.1 1999 390.6 1998 389.5 200 1997 386.5 300 1996 381.7 1995 381.1 100 b50 1960 1970 1980 1990 2000 2010 2020 Year Cost Index

Q: Define the term, “measurement uncertainty”. Among the instruments below above, which ones  have the ...

A: Every matter in the universe is measured in some quantities and also has some units. Measurement is ...

Q: A cylinder contains 0.35 m3 of air at 50 °C and 276 kN/m2 absolute. The air is compressed to 0.071 m...

A:

Q: The square-planar complex [Pt(en)Cl2] only forms in oneof two possible geometric isomers. Which isom...

A: Isomerism is the phenomenon where the compounds have the same chemical formula but different structu...

Q: The cost of raw materials falls within The nonmanufacturing fixed capital cost The working capital c...

A:

Q: Calculate Z and V for sulfur hexafluoride at 75 °C and 15 bar by the followingequations:a) Truncated...

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you. ...

Q: Express the following measured values using absolute error using appropriate significant figures: a....

A: The absolute error is defined as the difference between the actual value and the measured value.

Q: The following results are obtained for a first order reaction |k(min-1) | 0.0258 313.0 T(K) 0.0618 3...

A:

Q: a. Determine the volume in (cm3) occupied by 35 g of o-xylene at 20 C.

A:

Q: I need this Answer at half time Quickly. Please

A: Given: For Oxygen-nitrogen gas mixture; Total pressure P = 1 atm = 1.01325×105 Pa Distance z = 0.2 c...

Q: The temperature of a mole of perfed gas is Increased from 300 to 500 k. What is the change in entrop...

A: Given data: Initial temperature=300K Final temperature=500K We need to calculate the change in entro...

Q: Discuss detail account on soft ionization techniques?

A: Soft ionization techniques are a type of mass spectroscopy in which there is a low energy involvemen...

Q: Cooling water available at 10°C is used to condense steam at 30°C in the condenser of a power plant ...

A: Condensers are used to condense steam, which works on the principle of a Heat exchanger. There many ...

Q: The amount of calcium in physiologic fluids can be determined by a complexometric titration with EDT...

A: Given data: 0.100mL sample of blood serum is made by adding 2 drops of NaOH and titrated with 0.0011...

Q: 5. For small slope of the equilibrium curve. a) XAL- XẠi = XAG-X*A b) YAG- YAi = YAG - y*A c) YAG-YA...

A: Correct choice out of the given options is asked.

Q: Presence of the re-boiler unit in both methods of condensate stabilization by distillation?reasons

A: The condensate stabilization is performed to reduce the vapor pressure of condensate and to ensure s...

Q: Q4- Determine the degrees of freedom available in the design of a simple heat exchanger. Take the ex...

A:

Q: With a PC, find the wet bulb temperature and the specific enthalpy of air with an absolute humidity ...

A: Given that, Absolute humidity = 0.015 kg water vaporkg dry air Dry bulb temperature = 39oC It is req...

Q: A feed mixture containing 50 mole % Hexane and 50 mole % Octane is fed into a pipe still through a p...

A: Feed contain 50 mol% Hexane (A) and 50 mol % Octane (B) Fraction of feed converted to vapor is 0.6  

Q: Prepare three different saturation rate curve graphs, one each for competitive, non-competitive, and...

A: Competitive and non competitive inhibition:  The competitive inhibitor binds to the active site and ...

Q: 3. Determine the concentrations (in mole fraction) of all species in the exhaust from the complete c...

A: Basis:- 1 mole of propane  The combustion reaction of propane is  C3H8 + 5 O2 → 3 CO2 + 4 H2O + Heat...

Q: Given RH 27.5%, wet bulb temperature 100 degrees F. Calculate what is the dry bulb temperature, dew ...

A:

Q: Write a simplified introduction in: a) TDS,TS and TSS in water. b) Chloride in water. c) PH of water...

A: a) TDS (total Dissolved Solids): It is the means of measuring total organic and inorganic content pr...

Q: What does LeChatelier’s principle predict about the effect of a temperature increase for an endother...

A: The predictions using LeChatelier are to be made.

Q: Calculate the internal energy and enthalpy changes that occur when air is changed from an initial st...

A: As it is mentioned that PVT is constantP1V1T1=P2V2T2As P1=10Atm=10.1325Atm= 1013.25 KPa T1=277K and ...

Q: 4. How many pound moles of NaNO, are there in 100 lb?

A: Given: 100 Pounds (lb) of NaNO3. Required: Pound moles of NaNO3 =?  

Q: (Assume all gases are perfect unless stated otherwise. Unless otherwise stated, thermochemical data ...

A: Given: The gas is Xenon of weight = 131 g vessel volume = 1 dm3 = 10-3 m3 T = 25 oC = 298 k Required...

Q: Find the dynamic response of a first-order lag system with time constant 1, = 0.5 and static gain, K...

A: Given: first order system Time constant ζ=0.5 static gain Kp=1

Q: 20. An acetone-air mixture containing 0.015 mole fraction of acetone has the mole fraction reduced t...

A: Given that, The mole fraction of acetone in the inlet acetone-air gas mixture y1 = 0.015 The mole fr...

Q: The following results are obtained for a first order reaction k( min-1) 0.0258 T(K) 0.0618 0.1080 0....

A: The graphical expression for the Arrhenius equation is given by: lnk = -Ea/RT + lnA comparing it wit...

Q: Determine the reaction order and the coefficient using the following data obtained from a batch reac...

A:

Q: Some data for the kinetic energy of ejected electrons as a function of the wavelength of the inciden...

A:

Q: Given RH 27.5%, wet bulb temperature 100 degrees F. Calculate what is the dry bulb temperature, dew ...

A:

Q: H.W2: The cylinder/piston setup of contains 0.5 kg of ammonia at -20°C with a quality of 25%. The am...

A: Given data: We have a cylinder/piston setup contains 0.5kg of ammonia at -20oC with a quality of 25%...

Q: Consider a gas mixture of nitrogen (N2) and methane (CH4) of total mass 80g. 14% of the total mass i...

A: Given, Total mass of the gas mixture, m = 80 g Mass % of nitrogen is 14%.   Calculate the mass of ni...

Q: 4. Two production unit in a plant designated number 1 and 2 is constructed to produce products 1 and...

A: Let the products be P1 and P2 As given, the mass compositions are P1= 40%A and 60%B                 ...

Q: Immiscible Liquid-Liquid Extraction: A feed of 13,500 kg/hr consists of 8.0 wt% acetic acid in water...

A: GIven:Feed, F=13500 kghrWt% of acetic acid in water=8%Wt% of acetic acid in raffinate=1%

Q: Task 4: You are asked to explore the operating principles and efficiencies of hydraulic machines. Yo...

A: a) To find : Input power required for a pump  Given Data:  height to pump water (Z 2 -Z1 )= 40 m  Vo...

Q: Find the pH scale of the solution of acid H2SO4 of concentration 1.5 x 103 M. Use Ka= 1.2 x 10-2   H...

A: pH is the negative logarithm of hydrogen ion concentration. It is used for the determination of the ...

Q: In a vessel at 10 ºC, 1.00 M A and 1.00 M B were added. The reaction that occurs is represented by t...

A: Write the reaction as follows: Ag+Bg ↔ 2Cg   Given, equilibrium constant, Kc = 2.50×10-6 Initial con...

Q: A fuel oil is burned with 65% excess air, and the combustion characteristics of the fuel oil are sim...

A: It is mentioned that combustion characteristics of fuel oil are same as dodecane.  The combustion re...

Q: Crude petroleum oil is generally considered to be formed from animal and vegetable debris accumulati...

A:

Q: If co = 100mg/l and k = 0.10hr-1. What is the concentration 6 hours later? (first-order)

A: For first-order reaction some point  The reaction rate is linearly dependent on the concentration o...

Q: 10 kg of R-134a at 320 kPa fills a rigid container whose volume is 14L. The container is now heated ...

A: NOTE: For the plot of the process(with separation lines) please provide the saturation data. R-134a ...

Q: Questions and answers about the sedimentation experiment

A: Removing impurities from the liquids can be done in two ways: they are filtration and sedimentation....

Q: As a process engineer in the industrial gas company, You are provided with a gas mixture of 60% meth...

A: The volume percentage of methane in the gas mixture, VM% = 60% The volume percentage of ethylene in ...

Q: Calculate the thermal effect (Qreac) of the reaction: C6H12O6(9)→ 2CO2(8) + 2C2H5OH1) , using the av...

A: The standard enthalpy of the combustion (∆Hcomb∘) is calculated based on the difference in the stand...

Q: Based on the measurement uncertainty of the below instruments, which instruments would yield  the lo...

A: Measurement uncertainty is the error created by the quantity when measured. It is a method used to c...

Q: Q711 11 - MW steam power plant of overall efficiency of 32% is operating using coal (33 MJ / kg) as ...

A:

Q: The initial amount of the radioactive material, V, in a rock is determined to be 6.78 mg. Only 1.46 ...

A:

Q: Q1: What is the electrode potential on the SCE scale when this electrode potential was measured to b...

A: SCE stands for saturated calomel electrode.It is used as reference electrode. In this electrode reac...