The pressure of a gas results from O gas particles colliding with each other. O gas particles colliding with the container walls. the sum of the volumes of the particles being larger than the container volume. The temperature of a gas is a measure of the volumes of the gas particles. the amount of space between gas particles. the kinetic energy of the gas particles. the number of gas particles.

The pressure of a gas results from O gas particles colliding with each other. O gas particles colliding with the container walls. the sum of the volumes of the particles being larger than the container volume. The temperature of a gas is a measure of the volumes of the gas particles. the amount of space between gas particles. the kinetic energy of the gas particles. the number of gas particles.

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter8: Properties Of Gases

Section8.8: The Behavior Of Real (non-ideal) Gases

Problem 8.13PSP

See similar textbooks

Similar questions

5.15 Gas pressure can be expressed in units of mm Hg, atm, torr, and kPa. Convert these pressure values. (a) 722 mm Hg to atm, (b) 1.25 atm to mm Hg, (c) 542 mm Hg to torr, (d) 745 mm Hg to kPa, (e) 708 kPa to atm
A gas effuses through an opening one-fifth as fast as helium gas effuses through the same opening. (a) Is the gas heavier than helium? (b) What is the molar mass of the gas?
A 3.00-L flask containing 2.0 mol of O2 and 1.0 mol of N2 is in a room that is at 22.0C. a How much (what fraction) of the total pressure in the flask is due to the N2? b The flask is cooled and the pressure drops. What happens, if anything, to the mole fraction of the O2 at the lower temperature? c L of liquid water is introduced into the flask containing both gases. The pressure is then measured about 45 minutes later. Would you expect the measured pressure to be higher or lower? d Given the information in this problem and the conditions in part c, would it be possible to calculate the pressure in the flask after the introduction of the water? If it is not possible with the given information, what further information would you need to accomplish this task?
39 A sample containing only NO2 and SO2, has a total pressure of 120. torr. Measurements show that the partial pressure of NO2 is 43 torr. 1f the vessel has a volume of 800.0 mL and the temperature is 22.0°C, how many moles of each gas are present?
38 For a gas sample whose total pressure is 740 torr, what are the partial pressures if the gas present consists of 1.3 mol of N2, 0.33 mol of O2, and 0.061 moI of Ar?
What is the temperature of an 11.2-L sample of carbon monoxide, CO, at 744 torr if it occupies 13.3 L at 55 C and 74-4 torr?
One method of analyzing amino acids is the van Slyke method. The characteristic amino groups (NH2) in protein material are allowed to react with nitrous acid. HNO2, to form N2 gas. From the volume of the gas, the amount of amino acid can be determined. A 0.0604-g sample of a biological sample containing glycine, CH2(NH2)COOH, was analyzed by the van Slyke method and yielded 3.70 mL of N2 collected over water at a pressure of 735 torr and 29 C. What was the percentage of glycine in the sample? CH2(NH2)CO2H+HNO2CH2(OH)CO2H+H2O+N2
Before small batteries were available, carbide lamps were used for bicycle lights. Acetylene gas. C2H2, and solid calcium hydroxide were formed by the reaction of calcium carbide, CaC2. with water. The ignition of the acetylene gas provided the light. Currently, the same lamps are used by some cavers, and calcium carbide is used to produce acetylene for carbide cannons. (a) Outline the steps necessary to answer the following question: What volume of C2H2 at 1.005 atm and 12.2 C is formed by the reaction of 15.48 g of CaC2 with water? (b) Answer the question.