Consider an air-standard Otto cycle that has a compression ratio of 8 and a heat addition of 1330 kJ/kg. If the pressure and temperature at thebeginning of the compression process are 0.1 MPa and 70 °C, determineMatch each item to a choice:Qthe maximum pressure for the cycle,the net work output, in kJ/kg,the maximum temperature for the cyclethe mean effective pressure,

Answered: Image /qna-images/answer/6f4b88c7-20d7-4271-ba6d-120953f726f3.jpg

Answered: the maximum pressure for the cycle, the…

the maximum pressure for the cycle, the net work output, in kJ/kg, the maximum temperature for the cycle the mean effective pressure,

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1- Draw a simple sketch, then show its processes on the (T-s) diagram for each ideal cycle listed in the table below. Cycle Туре Steam Condition Closed FWH Direct Contact Turbine inlet Reheat Outlet Condenser Drain Drain FWH Cascaded Pumped Backward Forward A Reheat 100 bar, 60 bar, 410 C° 0.07 bar 410 C° Regenerative 60 bar, 0.07 bar 20 bar 410 C° 10 bar C Regenerative 60 bar, 0.07 bar 20 bar 10 bar 410 C° D Reheat- 100 bar, 25 bar, 410 C° 0.07 bar 12 bar 0.5 bar Regenerative 410 C° 2 bar
4. Define the requirements for a process to be considered isentropic. Please select all answers that apply: a) Flows through the turbine and pump occur adiabatically and without irreversibility. b) Isentropic processes are frictionless processes only. c) Isentropic processes are adiabatic processes only. d) Isentropic processes are constant pressure processes. e) Isentropic processes are constant temperature processes.
20.The following performance of gas turbine engine: compressor inlet temperature, 525°R; compressor isentropic discharge temperature, 673°R; actual compressor discharge temperature, 693°R; turbine inlet temperature, 1505°R; turbine isentropic discharge temperature, 1185°R; and turbine actual discharge temperature, 1218°R. For these conditions calculate the turbine isentropic efficiency.A. 83.24% B. 89.68% C. 87.24% D. 92.68%
multiple choice
Discuss the importance of thermodynamics knowledge in the design and analysis of conventional power plants
I need the answer quickly
PART II: Gas turbine Introduction o Compressor (process 1 - 2) Work input, WC Increase pressure, pressure ratio p Wc = Win = mcp(T₂ - T₁) o Combustion of fuel (process 2 - 3) Heat addition, Qcc Increase temperature Qcc = Qin = m cp (T3 - T₂) o Expansion (process 3-4) High-energy fluid Useful Energy, WT WT = Wout = m Cp (T3 - T4) (1) Fuel Compressor Fresh air (2) Combustion chamber 3 Turbine Exhaust gases 4 w. net
A Rankine Engine-Generator unit receives 27,000 kg/hr of steam at 1.2 MPa and 150°C and exhausts to a condenser temperature of 22 C. Brake steam rate is 4.74 kg/kW-hr, mechanical efficiency is 90 % and generator efficiency is 94 %. Determine: a) ideal cycle thermal efficiency, b) indicated engine efficiency, c) generator output (kW), d)the condition of turbine actual exhaust
As shown in the figure, an air conditioner operating at steady state maintains a dwelling at 70°F on a day when the outside temperature is 103.5°F. The rate of heat transfer into the dwelling through the walls and roof is 30,000 Btu/h and the net power input to the air conditioner compressor is 3.45 hp. Step 1 B Inside, 70° F Determine the coefficient of performance for the air conditioner. = Evaporator i 30,000 Btu/h Determine the coefficient of performance of the air conditioner. Determine the power input required, in hp, and the coefficient of performance for a reversible air conditioner providing the same cooling effect while operating between the same cold and hot temperatures. Refrigerant loop Compressor Outside Q + Condenser
Refrigerant 22 is the working fluid in a Carnot refrigeration cycle operating at steady state. The refrigerant enters the condenser as saturated vapor at 36°C and exits as saturated liquid. The evaporator operates at -30°C. Determine, in kJ per kg of refrigerant flowing, the net work in the cycle. A 20.37 B 36.47 18.37 24.37
a. Sketch the process on a P-V diagram b. Determine the rate of heat transfer from Boiler ( Qcv/m 1-2, in KJ/kg) c. Determine the rate of heat transfer from condenser ( Qcv/m 3-4, in KJ/Kg) d. Using the Clausius inequality to determine if the cycle is internally reversible, irreversible, or impossible. e. Determine the thermal efficiency of power cycle f. Determine the maximum thermal efficiency of power cycle ( Carnot Efficiency) g. Due to part (e & g) this cycle is___________ ? - internally reversible -internally irreversible -impossible