-The magnitude of N2 (normal force on Surface-2) is _____N 2-The magnitude of F2 (friction force on Surface-2) is _____N. 3- Consider the FBD of the Wedge:   The direction of N2 (normal force on Surface-2) is _____degrees. Please need help. use that fig to respond to questions 1, 2, 3

Q: The value of surface tension is more at ______________________ .     50 oC     80 oF

A: So option (b) 80 oF is correct option.

Q: What is the kinetic friction force acting on the block?   μ_k*mg sinθ   μ_k*mg cosθ   μ_k*mg   zero…

A: When the two surfaces have relative motion with each other then it subjected to frictional force.…

Q: XII- ---- - are used to measuring and record the atmospheric pressure. a) Thermocouple with reader…

A: It is required to choose correct Answer

Q: What is the brake horsepower of the engine in item above if the mechanical efficiency is 80 %?

A: Given data: η=80% Need to determine the brake horsepower of the engine.

Q: which term defined as the sum of forces due to fluid pressure? a. buoyant force b.net force c.…

A: Pressure is the total outcome of summation of forces acting on surface.

Q: The coefficient of bend value is the energy loss due to bend in a pipe depends on the pipe diameter,…

A: The coefficient of bend value is the energy loss due to bend in a pipe depends on the pipe diameter,…

Q: 1. For the shown hydraulic jack the gage pressure indicates 140 kpa how much kilograms should be…

A:

Q: n outside diameter of 70 m and :

A: here outer dia (70m) is >>>> inner dia (50mm). so the polar moment of inertia almost…

Q: A hydraulic cylinder has a 750 mm diameter. How much force (kN) can be developed with 275 kPa oil…

A: Given    Pressure, P = 1275 kPa  Diameter, d = 750 mm                     = 0.75 m Find   Force…

Q: Given the hydraulic cylinder shown below, what is the (a) force out and (b) pressure in the line?…

A: Given data,  Force in , F1= 10 lbs  A1= 1 in2  A2=10 in2

Q: A lever with a mechanical advantage of 6 is attached to the pump piston of a hydraulic press. The…

A: Write the given data with suitable variables. MA=6Ai=1.2 in2Ao=18 in2Fi=30 lbsFo=180 lbssi=1 inso=8…

Q: Which one of the following is the unit of the ratio of dynamic viscosity to density? a. Poise b.…

A:

Q: Is-the following force conservative?-Why?¶| F = (-)6, - () 6 + (-) where a, b-and c are constants r…

A: If we want to know whether a force is conservative or non-conservative then we need to calculate the…

Q: Vertically 300lb/pulg2 and horizontally 150 lb/pulg2 I have only this data please answer.

A: Giver:- My=300 lb/pulg2 Mx=150 lb/pulg2   To find:- Resultant

Q: |s0o0 FiG. P 1-10 1-10. Resolve the 300-lb force acting on body OBC in Fig. P 1-10 into two…

A:

Q: Find the work W done by a force of 3 pounds acting in the direction 45° to the horizontal in moving…

A:

Q: Please need help. Clear explanation or answer. Use the picture to answer 1,2,3,4, 1- The direction…

A:

Q: ..Which of the following is the surface velocity of a pulley 18 inches in diameter mounted on a…

A:

Q: A lever with a mechanical advantage of 6 is attached to the pump piston of a hydraulic press. The…

A: GivenMechanical advantage of lever A=6as we know that mechanicl advantage=output forceinput force…

Q: The given figure is a representation of a piston inside a cylinder. What do you call parts A, B, C,…

A: given figure is a representation of a piston inside a cylinder. To name the parts A, B, C, D, &…

Q: What is the magnitude of the Right Reaction force in pounds?

A: GIVEN: F=1.5 kpis =1500 lbf TO FIND: The reaction on the right side. Rb

Q: Must the potential energy of a body of weight Win a gravitational field always be positive? Explalh.…

A: The potential energy of a body in a gravitational field is the energy possessed by virtue of its…

Q: Find the normal force on the pilot at A.

A: We are to determine the net forces acting on this body

Q: 3 kN 12 kN.m 3 kN / m 5 kN / m 7 3 m 3 m 2 m

A: given:

Q: Differential vacuum pressure between A and B equal to 10 kPa, and diameter for A&B equal to 150mm…

A: Given data: -  The differential vacuum pressure between A and B equal is PA -PB = 10 kPa. The…

Q: 4.) The pressure gage reading is 70 kPa. Find the weight (kN) of the piston. 1mø Piston 1 m Ol S…

A: The pressure exerted by the fluid at a point which is located at a depth of h from the surface is…

Q: List types of work done that exist in the system as shown in Figure 2, below and justify your…

A:

Q: mispherical dome covers an ice rink of diameter of 25 m. The c and the ice is -5 C. The diameter of…

A: View factor can't be more than one.  Yes, spherical dome covered with an ice rink. So, these are…

Q: Which of the following is the dimension of force? M L-1T-1 M0 L T-1 M L T-2 M L T-1

A:

Q: Pressures up to 2000 atm are measured with a dead-weight gauge. The piston diameter is 4 mm. What is…

A:

Q: torque (or moment) is defined as a force acting perpendicular to a moment arm about a moment center…

A: Given data T=360 lb.in

Q: where did u get 2088.54lb/ft^2 and 0.07488 lb/ft^3??

A:

Q: 1. When Tom is at x =1m, what is the tensile force in the wire in Newton? If the wire can hold only…

A:

Q: ROBLEM 2.3 Y Y 3 kips 425 lb 4. 2 3 3 X X X 12 Y 110 lb Y Y (а) (b) (c)

A: find the vertical and horizontal component of forces.

Q: Force F- (4i - 2j + 7k) kips acts at point C. A(0,7,7)ft C(7.0,0)t fB(8,8,0)n Resolve force F into…

A:

Q: A solid wood cylinder has a diameter of 2.0 ft and a height of 4.0 ft. The specific gravity of the…

A: Given data:D= 2 ft = 0.6096 mH = 4 ft = 1.2192 mSw = 0.6So = 0.85

Q: 2 = 2.3 ft, VA = 4.7 ft/s, aa = 2.7 ft/s2, and the a cceleration (in rad/s2) of rod ABC. Negative…

A: l1=1.1ftl2=2.3ftvA=4.7ft/saA=2.7ft/s2θ=25° To-Find:- Angular acceleration=?

Q: The rate of increase of pressure in a vertically downward direction is equal to the specific weight…

A:

Q: What are the differences between the Triangles of forces and polygon of forces?

A: Both triangle and polygon of forces are used for analysis of vectors.

Q: Q1: Answer by True or False. 1- The pressure diagram can be used to calculate the hydrostatic force…

A: We are suppose to solve only 3 subparts. Please post other question as a separate question.

Q: a gauge press 59.220 kPa. The maximum piston displacement can vary up to thirty centimeters. The cy…

A: To given thatGauge pressure=59.220 kpaMaximum piston displacement=30cm=0.3mCylinder diameter= 15cm=…

Q: The displacement of a piston in cubic inch with a cylinder bore of 7.62-cm and the stroke is 3-

A: Given:d=7.62 cml=3 in

Q: If the datum is located at the leading edge of the wing and the weighing point is at the landing…

A: given data; If the datum is located at the leading edge of the wing and the weighing point is at the…

Q: Which of the following is the dimension of viscosity? M L-1T-1 M L T-2 M0 L T-1 M L T-1

A: Viscosity : Viscosity is a measure of the degree momentum transport in a fluid perpendicular to flow…

Q: For surface submerged horizontally in a liquid, the centre of pressure and the distance of centre of…

A: For surface submerged horizontally in a liquid, the centre of pressure and the distance of centre of…

Q: the minimum force

A: Given; If the coefficient of the static friction for all surfaces is 0.4, Block R is tied to the…

Q: 11. What is the equivalent angle in degrees is Northeast? O 30 deg O 45 deg 60 deg 90 deg 12. The…

A:

Q: The value of surface tension is less at O 50 oC O 80 oC 103 OF 3000C O No correct answer

A: In this problem, it is asking about the surface tension of water.

Q: o animals were placed on both end of a hydraulic lift system as show below. A mouse with a mass of…

A: given:mass of the mouse m=9gd=10cmmass of the elephant M=4000Kg

Q: P. P2 P, 10 11 12 13 14 15 16 17 12'-0" TYP. Use the diagram shown above. Given P- 100 # Py- 400 Pg…

A: GIVEN DATA- A PLANE TRUSS GIVEN WE HAVE TO FIND FORCE IN MEMBER 2