The frame shown has 2 members, ABD and CD, is pinned at A, C and D and is loaded with two distributed loads as shown with, w₁ = 6.5 lb/ft, and w₂ = 9.4lb/ft, and has dimension, a = 15 ft, b = 41 ft, c = 33ft g. What is the internal normal force at E? h. What is the internal shear force at E? i. What is the internal moment at E? a b W₁ E A D W₂

Topic/s: Force System of a Force, Moment of a Force, Moment of a Force-Scalar Formulation,Moment of a Force-Vector Formulation, and Principle of Moment.   Reminder: Kindly show the complete step-by-step solution. Please make sure that your handwriting is understandable and the picture of the solution is clear. I will rate you with “like/upvote” after.   Thank you.

I need answers to questions 4, 5, and 6 pertaining to the print provided. Note: A tutor keeps putting 1 question into 3 parts and wasted so many of my questions. Never had a issue before until now, please allow a different tutor to answer because I was told I am allowed 3 of these questions.

mmetri Each part has a constant thickness with values indicated. 2.0 mm 1.5 mm 3.0 mm 2.0 mm A shear force, S₂ is applied. This results in shear flow, shown with red arrows, which has the following values: • Shear flow in part 13, just before point 3 - 38 N/mm Shear flow in part 23, just before point 3 = 44 N/mm Shear flow in part 43, just before point 3- 44 N/mm What is the shear stress in part 35, just below point 3? Express your answer in MPa, to 2 decimal places but without the units included. You have a 3% margin of error.

The final answer must be correct otherwise leave . Don't provide wrong answer ,It will be downvoted.

1. What are the properties of natural gas? 2. Outline the difference between non associate and associated gas i need clear ans and solve very very fast in 20 min and thank you | DYBALA

Topic/s: Force System of a Force, Moment of a Force, Moment of a Force-Scalar Formulation,Moment of a Force-Vector Formulation, and Principle of Moment.   Reminder: Kindly show the complete step-by-step solution. Please make sure that your handwriting is understandable and the picture of the solution is clear. I will rate you with “like/upvote” after.   Thank you.

Please walk me to find the answer and please include the magnitude of the force.

Tire manufacturers recommend that you check your tire pressure monthly to avoid unnecessary tire wear and enhance safety. This is best done when the tires are cold meaning; the car has not been driven for at least 2 hours. Since you leave for work before the sun comes up you decide to inflate your tires to the recommended pressure right after you get home from work in the afternoon when the tires are still warm. What would you find if you rechecked your tire pressure after the tires have cooled down? A.Tire pressure has decreased because there is a decrease in kinetic energy of themolecules resulting in more collisions with the inside walls of the tire thusincreasing the pressure inside the tire. B.Tire pressure has increased because there is a decrease in kinetic energy of the molecules resulting in fewer collisions with the inside walls of the tire thus decreasing the pressure inside the tire. C.Tire pressure has increased because there is an increase in kinetic energy of the…

Solidworks