Answered: The followings are fuel-cost curves for…

The followings are fuel-cost curves for two generating units of a power plant while Pp=550 MW: C, = 0.0194P, + 78.5Pe + 3000 100W S Pa S 400w () Cz = 0.05784Pz + 95.64Pz + 1000 50MW S Pez s 200W

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A wind turbine has the following data: Downstream wind velocity = 12 m/s Upstream wind velocity =34…

A: wind efficiencyη =PoutPIn×100Rotor power output is 0.5MWbut output power is also given…

Q: An energy meter revolves 190 revolutions of disc for a unit of energy. Find the number of…

A: Need to find the number of revolution for the given load conditions then find error

Q: 100 kW belt driven shunt generator running at 300 rpm on 220V bus-bar, continues to run as a motor…

A: Calculate induced emf in armature in both cases and take the ratio of two induced emfs to find speed…

Q: Question: Calculate the Solar Energy potential (GWh) that can be generated on Annual Basis if…

A: Given estimated generation= 2GWh/MWp

Q: Determine the value of Zpase for the circuits +10 V Rc 4 kN 10 kN HE RL 11 kN hie = 200 R2 2.2 kN…

Q: 000 kW steam power station uses coal of calorific value 15,000 kcal per kg. If the coal consump-…

A: Electricity generation=65,000 kW Calorific Value=15,000 kcal Coal consumption per kWh=0.5 kg Load…

Q: The friction and windage loss are 105 W. Determine the followings related to the motor at its rated…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subpart for…

Q: Generation capacity of Plant A = 300MW, Fuel efficiency = 45%, Capital cost =28 Million per year,…

A: Given: Generation capacity of Plant A = 300MW, Fuel efficiency = 45%, Capital cost = 28 Million per…

Q: 1. A pump driven by 240V motor lifts 1000 ft / min against a head of 50 m of water. The efficiency…

A: Given pump driven by motor Voltage v=240 vMotor lifts 1000 ft3/minHead h=50 mThe efficiency of the…

Q: A coal fired Power plant with 30,000 kw rated capacity costs P 15,000 per kw installed. Annual…

Q: 2b What speed would result if the pump rpm is increased to produce a pumping head of 120 ft,…

Q: Question 2 A Two units each of 200 MW in a thermal power plant are operating all the time throughout…

A: In this question , we will find annual fuel cost saving for econoMic distribution of load..

Q: A hydro-plant and a steam plant are to supply a constant load of 95 MW for 1 week (168 h). The unit…

A: Given load is 95 MW for a week (168 hrs)So total energy=95×168 MWh =15,960…

Q: 9. A 1500 W heating element at an initial temperature of 15°C is connected to a supply voltage of…

Q: QS// The power generauon equipment of a power station cust Rs 15.75.000 und hus a useful life of 25…

A: Consider the formula for the sinking fund method. q=P-Sr1+rn-1 Here, P is the initial amount, S is…

Q: The capital investment in an energy conservation project is 15,00,000/- and its useful life is 25…

Q: Current Turn Sec. ratio ratio res 100.5 2005 3005 4005 500.5 6005 8005 900.5 10005 12005 "Ohms at…

A: Referring to the general excitation curves for the current transformer according to the IEEE…

Q: o+15 V ER >22 kN R3 R5 15 kn R 5 kn 5 kn Cc2 Cc3 Q1 Q2 S10 k R2 3.3 kn R4 1 kN CB1 2.5 kn CB2 1 kN…

Q: A small machine shop, with 30 hp of connected load, purchases electricity at the following monthly…

A: The given data from the question is depicted below: a) The 2800 kWh/month consumption, Monthly bill…

Q: An electric clothes dryer draws 15A at 220V. If the clothesput into the dryer have a mass of 7.0kg…

A: Given that V=220 voltI=15 AVaporized water=7-4=3 kgLv= 2.26 x 106 J/kg calculate the required…

Q: sidering an asynchronous machine in service S1, calculate the ste a: P = 56 kW, efficiency 98.6%,…

A: Given data: Pn=56 KWη=98.6%Rth=0.180C/Wθamb=400Ctauth=24000s

Q: A food processing plant consumed 450,000 kW of electric energy annually and pays an average of P2.00…

A: Here we discuss about the economics of the power generation.

Q: machines. Differe nt 1.A plant Can produce washing and dryer Parts for each product are manufactured…

A: According to the question we have to find how many washing and dryer machines should produced to…

Q: The daily energy usage of a residential house for different loads used is as listed below: Type of…

A: i) load are given as

Q: The efficiency of a dc generator is 84%, if all losses amount to 1200W, calculate the BHp (in Hp).

A: GivenEfficiency=84%Total losses=1200 W

Q: Given the circuit below, determine the magnitude of the current through the 20-volt source. bo 10…

Q: How to convert 22 W of power into the units of dBm

A: In this case, 22 W of power is to be converted into its equivalent power in dBm.

Q: he transmit power of a mobile phone is 0.8 W. The phone transmits digital data at 9600 bps.…

A: The power transmitted by the mobile phone is 0.8 W. The phone transmits digital data at 9600 bps.…

Q: The following data is available for a steam power station: Maximum demand = 25,000 kW; Load factor =…

Q: The summation of all expenditures to produce a kw-hr power source? (A K-hr power source B Production…

A: In this question we need to choose a correct option

Q: 9. 100V 2000 500 1500 2000 500 Solve for the current supplied by the battery as shown.

Q: 6. An industrial undertaking has a connected load of 100 kW. The maximum demand is 80 kW. On an…

A: given maximum demand of 80 kw and connected load of 100 kw and given that on average it has…

Q: A student is measuring the speed of a moving cart using the carbonated tape and he got the…

A: Given figure, x=9.5 cm=0.095 mf=50 Hz

Q: A diesel-electric power plant is operated by an industrial firm to supply its daily power…

A: Diesel-electric power plant A diesel power station is a generating station that uses a diesel…

Q: Determine the thermal efficiency of a thermal power station and it fuel bill per annum for the…

A: Maximum demand = 30000KW Load factor = 50% Fuel consumption = 0.75kg/unit Boiler efficiency = 80%…

Q: Question 4 (a) An industrial unit has an electricity demand profile for a given day as shown in…

Q: Type your question here A consumer requires one million units per year and his annual load factor is…

Q: The specific fuel consumption by a thermal power station is 0.75kg/Kwh. The units generated for a…

A: In this question we need to find a fuel consumption per day by station

Q: A hydro-electric generating plant is supplied from a reservoir of capacity 20000000m' with a head of…

Q: Using THEVENIN'S OR NORTON'S THEOREM, determine the value of VTH (in volts). 40 40 SA 24V use two…

Q: An energy meter measure the amount of power consumed by the load with respect to time. It is…

A: In this question , we will find percentage error in energy meter..

Q: TII 8.) 4 – 3 kW, 230 V and 3 – 8.5 kW, 230 V clothes dryers are to be placed in a building, the…

Q: 6. A car accelerates from 5 km./h. to 41 km./h. in 10 sec. . Express this acceleration in : i)km./h.…

A: Car accelerate from 5km/h to 41km/h in 10 second Find the accelerate ? Accelerate= change in speed…

Q: A power station of 4 MW has an overall efficiency of 0.35 and a fuel calorific value of 7500…

A: Given data: Power plant capacity = 4 MW Load factor = 0.8 Plant capacity factor = 0.7 efficiency =…

Q: In an undisturbed airstream inside a wind tunnel, the pressure is 101325 Pa, density is 1.225 kg/m^3…

Q: A 100 MW combined-cycle plant with a heat rate of 7700 Btu/kWh operates with a 75% capacity factor.…

A: Note: As per the policy we can solve only 3 sub-parts of a question, please re-upload the remaining…

Q: Which of the following sources need expensive machines for large scale production of electricity? O…

A: Coal is main source for large amount of electricity

Q: A hydro electric station of 4 kw has a water dischage of 62000 (cubic meter/ kw) for 5 hours. If the…

A: The power of the hydroelectric station is given by the expression as shown below: P=1000×η×Q×g×Hη=…

Q: Which of the following is considered as a disadvantage of Hydro Power? OA High initial investment…

A: We need to select disadvantage of hydro power plant.

Q: TTPS Output Calculation A thermal station has the following data: Max. demand = 40,000 kW; Load…

A: (i) The boiler and the turbine efficiency of the thermal station are known. The thermal efficiency…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

The followings are fuel-cost curves for two generating units of a power plant while Pp=550 MW:
C, = 0.0194P, + 78.5Pe + 3000
100W S Pa S 400w
()
Cz = 0.05784Pz + 95.64Pz + 1000
50MW S Pez s 200W

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

step down chopper has Vs = 230 V and R = 10 0. For a duty cycle of 0.4, the power taken by the chopper is 2097 Watts. Find the chopper efficiency. Take the voltage drop across the chopper switch as 2 V. a) 98 % b) 89.96 % c) 99.14 % d) 96.54 %
The answer fir this question is 2.817% for the ripple factor how i can get it ?
Two loads connected in parallel take a total of 2.4 kW with a lag fp of 0.8, from a line at 120 V rms and 60 Hz. of the loads absorbs 1.5kW with lagged fp of 0.707. Deter- mine: a) the fp of the second charge, b) the element in parallel required to correct the fp of the two charges and convert it to behind 0.9.
The power factor of the circuit shown in figure 2 is. a. 0.866 lagging b. 0.5 lagging c. 0.707 lagging d. 1
1. If the rms voltage drop across a 15 kn resistor is 16 V, the peak current through the resistor is A. 15 MA B. 1.5 MA C. 10 mA D. 1 mA
... 0.25 A 120 V 60 Hz RL 1 k2 470 µF When the circuit is working normally, it has an rms secondary voltage of 12.49 volts. Considering the ripple voltage, what is thnimum dc load voltage?
Solve for 20 V rms supply. Thank you.
The concentration ratio of parabolic trough power plant is typically O a. from 30 to 40 O b. more than 1500 O c. less than 10 O d. from 10 to 20
Determine the rms current I as shown in figure 2. Source voltage is already in RMS value(Answer must be in polar formand should be in 4 decimal places).
If there is reactive power associated with a circuit element we can say a) That said element is purely resistive. b) That said element has a unitary power factor c) That said element has associated electric or magnetic fields d) None of the above
The RMS value of current, if the value of armature current is 14 A, a = 51 degrees, and B = 160 degrees is Ia a+T B+T a O 10.89 O 2.91 O 5.16 O 82.46
53. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The current through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the apparent power. a. 4,399.4874 b. 8,063.3393 c. 9,180.6139 d. 19,196.9845