The following readings were taken during a leveling process:1.05, 1.30, 1.42, 1.52, 0.75, 1.35, 1.34, 1.75, 1.30 and 1.45 m. Write how many number of instrument positions and number of stations, if the instrument is changed after 4th and 8th readings. O a. 2 and 11 b. 3 and 9 О с. З and 8 O d. 3 and 11

The following readings were taken during a leveling process:1.05, 1.30, 1.42, 1.52, 0.75, 1.35, 1.34, 1.75, 1.30 and 1.45 m. Write how many number of instrument positions and number of stations, if the instrument is changed after 4th and 8th readings. O a. 2 and 11 b. 3 and 9 О с. З and 8 O d. 3 and 11

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A, B and C are three known control stations and P is the position of a sounding vessel which is to be located. If AC = 6925.50m and AB = 6708.40m, angle BAC = 112°45'25", angle BPA = 25°32'40", angle APC = 45°35'50", determine the distance AP if A is nearer to P than B and C.
Construction Surveying
2. The following data were obtained by stadia observation; vertical angle, +12 deg 30 min; upper stadia hair reading and lower stadia hair readings, 4.5 and 3.25m, respectively. The rod reading was taken at 3.875m above the stadia point at A. and the height of the instrument above the instrument station B, is 1.620m. If the stadia interval factor is 99.5 and the instrument constant is0.381m, find a) the horizontal distance between the instrument station and the stadia point. b) The inclined distance from the center of the instrument to the rod reading c) The difference in elevation between the two ground point.
2/A- The following data were obtained by stadia observation: zenith angle = 81° 50', s = 2.50 ft. The stadia interval factor is known to be 0.75 and K = 1 ft. Calculate H and V. 02/B- The following table gives the Departure Latitud
HI PLEASE HELP CAN YOU HELP ME WRITE AN OBJECTIVE, INTRODUCTION AND CONCLUSION (ATTACHED PHOTO ARE THE DATA AND RESULTS). ITS ABOUT MEASUREMENT OF VERTICAL DISTANCES: DIFFERENTIAL LEVELING
If you can help me with part b id greatly appreciate it, answer is not 10.77,10.72, 12.08, or 0.05. Thanks, will rate if answered within next couple hours.
A transit with a stadia interval factor of 100 was set up at C with elevation of 500m. and the following stadia reading were observed at points A and B: POSITION OF VERTICAL HAIR READINGS AZIMUTH ROD ANGLE UPPER (a) MIDDLE (c) LOWER (b) ROD HELD AT A 25°36' -25°35' 1.43 m 0.175 m 0.920 m ROD HELD AT B 305°40' +18°28' 2.022 1.854 1.686 If the stadia constant is 0.30m. determine the following: a. Elevation at points A and B HI at C is 1.00 m b. The distance of line AB c. Grade from point A to point B
Q3 /B/ The following tacheometric observations were made on the point D from station A, which has a height of 1.50 m above and reduced level 56.77m Staff position Staff reading(m) Vertical angle reading D 3.240, 3.047, 2.853 88°38'53" Calculate: (i) the reduced level of points D and the horizontal length of AD.
Q.5 (a) The following forebearings and backbearings were observed in traversing with a compass. Line Forebaring PQ S 37°30'E QR S43°15'W RS N 73°00'W ST N 12°45'E TP N 60°00'E Calculate the interior angles and the correct them for observational errors. Backbearing N37°30'W N44°15'E S72°15'E S13°15'W S59°00'W