Q2) the following table represents the field data for topographic surveying by the radiationmethod using theodolite and tape:Theodolite ObservedRod reading (m)V.C.R.Horizontalanglestationstationsubtended bysubstance barUML.74°46'32"2.061.551.03B0 -00°30'00"b-2mIf Azimuth AB= 202° 24'11", XA=302m, YA-302m .Compute Distance AC and XB,YB?

Answered: Q2) the following table represents the…

Q2) the following table represents the fleld data for topographie surveying by the radiation method using theodolite and tape: Theodolite Observed Y.C.R. Rod reading (m) Herirental

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A pre-engineering baseline was run down a very steep hill (see Rather than measure horizontally…

A: Vertical angle = -21o26' Height of range pole from the ground, h = 4.88 ft Slope distance between…

Q: The horizontal distance between two points, A and B is [400+(0.18*10)]m, and these are established…

Q: To find the elevation of the top of a chimney, the following observations were made from two…

A: I hope this is helpful

Q: A theodolite was set up at station A and the stafl reading on a B.M. of elevation 380.355 was…

A: We need to calculate Reduced Level (R. L) of station P

Q: PROBLEM 2: A traverse line AB is being measured by theodolite and subtense bar. At station A, the…

A: Given Height of instrument at A = 1.48 m Horizontal angle set up at station B = 42'18''

Q: Problem 2. The following observations were taken during a tacheometric survey using the stadia lines…

A: Given- The observation obtained from tacheometric survey using stadia lines of a theodolite.…

Q: definition of a datum in seismic reflection Choose one: a. a level equal to the mean-sea level b.…

A: ANS : ALL OF THE OPTIONS ARE TRUE Mean Sea Level (MSL), a standard global datum for measuring…

Q: Describe about the Passive sampling?

A: Passive sampling:

Q: Traverse adjustment applicable on the condition that angular accuracy is higher than linear accuracy…

A: Given- Traverse adjustment applicable on the condition that angular accuracy is higher than linear…

Q: If the rod reading taken at 1 is 2.735 m, the elevation of 2 is 225.395 m, the difference in…

Q: langulation): Two stations B and C were observed from a theodolite set up at station A and following…

Q: H.W 03: In field work, point B observed from point A by using theodolite and recorded the following…

Q: finite element method (FEM) at CB? a. -75.94 b. -55.94 c. -65.84 d. -72.27 finite element method…

A: Answer The fixed end moments of the beam are shown in the below image

Q: Expalin the Sampling with a Piston Sampler ?

A: Sampling: It is defined as the process in which soil is collected for testing to evaluate various…

Q: Method of repetition v

Q: The horizontal distance between two points, A and B is 420m, and these are established along the…

Q: ween two points, A and B is [400+(1.79*10)]m, and these are established along the same direction…

A: Given:- A and B is [400+(1.79*10)]m To find:- The subtended angle read on a subtense bar held at A…

Q: 5/69 Determine the depth h of the square cutout in the uniform hemisphere for which the z-coordinate…

A: Hemispherical surface with square cut of depth h. General case for centroid of volume Z =…

Q: 3. What is the difference between a theodolite and a total station? 4. Describe how a very precise…

Q: Explain the Embedment Correction Factor Chart by Janbu et al. (1956; from Christian and Carrier…

A: Embedment Correction Factor Chart by Janbu is used in soil foundation to determine the various…

Q: Briefly describe the principles on which seismic refraction studies for subsurface explorations are…

A: Seismic Refraction Studies:

Q: Problem 2. The following observations were taken during a tacheometric survey using the stadia lines…

Q: The top of a tower signal at B, 2,000 m from A away was sighted through a transit with recorded…

Q: In order to transfer reduced level across a canyon, a reciprocal leveling campaign was conducted.…

Q: Reflection on Clash detection by Navisworks

Q: Q3: Detine three of the followWing theodolite errors and classity them into the proper error type:…

A: 1) Non adjustment of plate level When the plate is levelled and centered, if the vertical axis is…

Q: A) The table below represents field measurements of horizontal angle using theodolite: Theodolite…

A: Theodolite Station Observed Station Telescope H.C.R Mean Bearing B A D 21o 36'…

Q: 2. CASE C2 LENGTH (m) 541.55 S85°58'E Unknown S03-05 W 902.13 S52°50'W Unknown N12°42'W 650.25…

Q: A theodolite was set up at P and the angle of elevation to the top of a mobile tower ST was 30°. The…

A: Given that :-Angle of elevation to the top of a mobile tower ST = Staff reading held at a station of…

Q: what is the answer to b. i & ii? The slope distance between twostations A and B measured…

A: To what precision the slope angle be measured:if the relative precision of the reduced horizontal…

Q: 15. Using a theodolite, a subtended angle of 22'40" was read on a 2-m subtense bar. What is the…

A: Given- Subtended angle=22'40"Length of the subtense bar=2 m

Q: A theodolite was set up at a station P. The angle of depression to vane 2 m above the foot of a…

A: Given- R.L of P=433.05 m, Staff reading at P=2.905 m, Distance between stations = 20 m, It is needed…

Q: Table Q2(b) shows booking of a two-peg test. i). Calculate the reduced levels of point B ii).…

Q: Problem 2. The following observations were taken during a tacheometric survey using the stadia lines…

Q: Note: Assume any suitable values for missing data. WCB of Line AB = X*5 (X is one ) Q. The following…

A: To Determine :- Complete the gales traverse table as follows: Apply all necessary corrections for…

Q: Briefly explain the method of leveling the instrument Theodolite?

Q: -What is differential leveling? -What is Backsite and foresight?

A: It has been asked in the question to determine the differential levelling and back sight and fore…

Concept explainers

State Plane Coordinate Systems

The state plane coordinate system (SPCS or SPS) is a collection of 124 coordinate systems or geographic zones prepared for particular regions of the U.S. Every state consists of one or more than one state plane zone, the boundaries of which generally follow the county lines. Inside the U.S., there are 110 zones in total, 10 more zones in Alaska, 5 in Hawaii, and 1 for Puerto Rico and US Virgin islands. The system is extensively used for geospatial and geographic data assembling by the state and local governments.

Question

Q2) the following table represents the field data for topographic surveying by the radiation
method using theodolite and tape:
Theodolite Observed
Rod reading (m)
V.C.R.
Horizontal
angle
station
station
subtended by
substance bar
U
M
L.
74°46'32"
2.06
1.55
1.03
B
0 -00°30'00"
b-2m
If Azimuth AB= 202° 24'11", XA=302m, YA-302m .Compute Distance AC and XB,YB?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Answer

VIEW

Step 2:

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

b) Seismic refraction survey is widely used as one of geophysical tool to investigate the ground condition. Sketch and explain the mechanism of the seismic refraction method on how the wave travels in different ground materials for the estimation of the thickness of i. the earth's formation.
topic: Tacheometry Please draw a diagram based on this Problem. (a) diagram of the problem (b) diagram with the computed unknown variables
If the rod reading taken at 1 is 2.735 m, the elevation of 2 is 225.395 m, the difference in elevation between stations 1 and 2 is 25.650m and the difference in elevation between the instrument station and station 2 is 33.642m, determine the following: a. Height of the instrument. b. Horizontal distance between stations 1and 2.
Q#2: An open traverse survey using theodolite has been carried out and following deflection angles were observed: Stations Observed Deflection Angles α Designation of Deflection Angle A 280 25’ 00’ (L) B 680 03’ 30’’ (L) C 1200 34’ 00’’ (L) D 580 30’ 00’’ (R) E 1080 13’ 30’’ (L) F 160 50’ 00’’ (R) G 1100 00’ 30’’ (L) Compute error of closure in above deflection angles. Find out the adjusted deflection angles using computed error in part (a).
Problem1) Determine the depth to bedrock for a site. _______meters2) Determine the velocity of the overburden _______meter/second and3) Determine the velocity of the bedrock _________meter/second.4) Critical distance from the source point __________metersGeophone 1 is 20 meters from the shot point and each geophone is 20meters from the next one.Geophone First Arrival time (seconds)1 0.0152 0.0313 0.0464 0.0625 0.0776 0.0897 0.0948 0.0999 0.10510 0.11011 0.11512 0.121
Define Bidirectional Reflectance Distribution Function and its relation to Lambertian reflectance..
definition of a datum in seismic reflection Choose one: a. a level equal to the mean-sea level b. all of the options are true c. a level were time is zero d. datum is the surface level of the earth
Subject - Surveying
I need the answer as soon as possible
6) The top(T) of a radio transmission tower was sighted from two small hill tops A and B which were in line with T. the angle of elevation from A to the top of tower was 38°21' and that from B to the top of tower was 21°18'. The angle of elevation from B to a target 3 m above the ground level at A was 14°56', The heights of the theodolite at A and B were 1.80 m and 1.50 m respectively. The horizontal distance between A and B was 150m and the reduced level of B was 121.50m. Calculate the RL of the top of the tower and the horizontal distance from A to the tower.
Engr. Brimrock is conducting a tacheometric survey and wants to know the elevation of station B. The upper and lower stadia readings on the rod held at station B were observed as 3.27 and 1.47, respectively, with the use of theodolite having a stadia interval factor of 99.99. The height of the instrument above station A is 1.37 m and the rod reading is taken at 1.51 m. The vertical angle observed is - 12° 9' and the elevation at station A is 114.09 m above sea level. Determine the elevation at station B above sea level in meters.
Three points on the ground were established such that point C is the point where the theodolite was set. A subtense bar were sighted at point A to be 00°18' and at point B is 00°19'30". If the horizontal angle was read between points A and B to be 38°45', find the distance AB. ps. please i need answer ASAP?