The following figure shows the shape and dimensions of a small dam. Assuming the water level is at top of the dam, find the total force on the face of the dam. NOTE: pg = 9800 45m 9n O 17,860.500N O 9,922.500N O None of these. O 89.302.500 N O 396.900 N

The following figure shows the shape and dimensions of a small dam. Assuming the water level is at top of the dam, find the total force on the face of the dam. NOTE: pg = 9800 45m 9n O 17,860.500N O 9,922.500N O None of these. O 89.302.500 N O 396.900 N

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter15: Fluid Mechanics

Section: Chapter Questions

Problem 13P: Review. The tank in Figure P15.13 is filled with water of depth d = 2.00 m. At the bottom of one...

See similar textbooks

Related questions

Q: A reservoir has a shape that is approximately rectangular. It is being held by a dam that is 525…

A: Given value--- breadth = 525 m. length = 12700 m. height = 84 m. We have to find--- What is the…

Q: The drawing shows a hydraulic chamber with a spring (spring constant = 1270 N/m) attached to the…

Q: Water is pumped up from the Colorado River to supply Grand Canyon Village, located on the rim of the…

A: Given River elevation = 515 m Village elevation = 2096 m Pipe line diameter = 18.0 cm

Q: In the hydraulic press used in a trash compactor, the radii of the input piston and the output…

A: Given,

Q: When is the flow considered Laminar? A B D Re = 4000 Re = 2000 Re 4000

A: Let's check each option one by one 1. Re = 4000 Incorrect option If Re = 4000 then the flow is…

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

A: r1 = 0.052 m r2 = 0.26 m

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

A: a) Apply the hydraulic principle and substitute the required values to determine the force F2.

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

Q: The dam is 500 m wide, and the water is 80.0 m deep at the dam. (a) What is the average pressure on…

Q: Water (density = 1 x 10 kg/m) flows at 15.6 m/s through apipe with radius 0.05 m. This same pipe…

A: Givendensity of water, ρ = 1×103 kgm3speed of water, v = 15.6 msradius of the pipe, r1 = 0.05…

Q: The drawing shows a hydraulic chamber with a spring (spring constant = 1370 N/m) attached to the…

Q: what depth, h (in meters), does the boat sink into the water? i.e. how far down does it sink, to…

A: Given data: The density of wooden raft is: ῤr = 401.4 kg/m3 The surface area of the wooden raft…

Q: The hydraulic lift's small piston with an area of 30 m^2 is subjected to a force of 100 N. To have…

A: Data provided: Area of small piston (A1) = 30 m2 Force on small piston (F1) = 100 N Force on large…

Q: Find the pressure in the water at the base of a dam if the water in the reservoir is 300 meters…

Q: What is the pressure at a depth of 110 m in the ocean? The density of seawater is 1. 03 x 10 kg/m.…

Q: A dam is used to hold back a river. The dam has a height H=12m and a width W=10m. Assume that the…

A: a) As given , density of water at 40C is 1000 kg/m3 Consider a small strip of dam length dy at a…

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

Q: The Deligne Dam on the Cayley River is built so that the wall facing the water is shaped like the…

Q: The hydraulic lift's small piston with an area of 30 m^2 is subjected to a force of 100 N. To have…

Q: A hydraulic cylinder lifts a car (F2) delivering a force of 15000 N. The diameter of the small…

Q: The figure to the right shows the shape and dimensions of a small dam. Assuming the water level is…

Q: The drawing shows a hydraulic chamber with a spring (spring constant = 1590 N/m) attached to the…

A: Given Area of smaller piston A1=15 cm2 Area of larger piston A2=65cm2 Spring constant K=1590N/m Mass…

Q: Find the pressure in atmospheres in the water at the base of a Dam if the water in the reservoir is…

A: Given data: Height of the reservoir h =20m 1 atm =1.1×105 N/m2

Q: A force of 295 N is applied to a hydraulic jack piston that is 0.026m in diameter. The second piston…

A: Given data: Force applied to first piston (F1) = 295 N Diameter of first piston (d1) = 0.026 m…

Q: a girl who weighs 55 kilograms uses an oil filled hydraulic to hold 4 men who weight 110 kilograms…

A: Given: weight of the girl (m) = 55Kg weight of a man = 110Kg No. of men = 4 Total weight of men (M)…

Q: The hydraulic lift's small piston with an area of 30 m^2 is subjected to a force of 100 N. To have…

Q: Find the force P that must be applied to a piston of area 11.60 cm2 to produce sufficient fluid…

A: Given : piston area (A) = 11.60 cm2weight of car = 10001 N fluid cross sectional area on the side…

Q: In a simple hydraulic system piston 1 has a cross section area of 0.000050 m2 , and piston 2 has a…

A: Given data: The cross-section area of the piston 1 is A1=0.000050 m2 The cross-section area of the…

Q: The following figure shows the shape and dimensions of a small dam. Assuming the water level is at…

A: Given Information:- Width of the dam is w=45 m. Height of the dam is h=9 m. Therefore area of the…

Q: A flat vertical metal gate in the face of a dam is shaped like the parabolic region between the…

A: Find the depth of the metal gate. y=4x24=4x2x=1 ft The area of the gate is, A=1 ft5 ft=5 ft2

Q: Hoover Dam on the Colorado River is the highest dam in the United States at 221 m, with an output of…

Q: The given figure shows the cross section of a dam and its reservoir. Choose the correct option(s)…

A: Pressure at a depth h is P = P' + dgh P' = atmospheric pressure d = density of the water So,…

Q: The Deligne Dam on the Cayley River is built so that the wall facing the water is shaped like the…

Q: A force of F1 = 397 N is applied to a hydraulic jack pump piston with a diameter of D1 = 0.0183 m.…

A: In this question we have to find the magnitude of the output force F2. Please give positive feedback…

Q: In a simple hydraulic system piston 1 has a cross section area of 0.000050 m2 , and piston 2 has a…

A: Given: The cross-section area of piston 1 is 0.00005 m2. The cross-section area of piston 2 is…

Q: A pump discharges 75 gallons per minute of water whose specific weight is 61.5 lb/ft^3 when gravity…

A: Flow rate (Q)= 75 gallons per minutes = 75×(0.134/60) ft3/s = 0.1675 ft3/s Radius of tank = 10/2…

Q: The Deligne Dam on the Cayley River is built so that the wall above the curve y = 0.8x and below the…

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

A: In this question we have to find the force exerted on the car and the distance d2. Please give…

Q: Hydraulic balance. An m = 60.0 [kg] box was placed on top of a 2.75 [m²] massless platform. Given…

Q: The drawing shows a hydraulic chamber with a spring (spring constant = 1150 N/m) attached to the…

Q: A force of F1 = 345 N is applied to a hydraulic jack pump piston with a diameter of D1 = 0.0168 m.…

Q: A hydraulic lift's first cylinder has a 4.5 cm-diameter while a second cylinder has a 17.8…

Q: The water level in a reservoir is maintained at a constant level. What is the exit velocity in an…

A: V = √(2gh)

Q: A company needs to pump coconut oil (den: 924 kg/m^3) from the import truck to its holding tank 22…

A: We know that

Q: A sump pump (used to drain water from the basement ofhouses built below the water table) is draining…

A: Given The flow rate of sump pump is q = 0.750 L/s = 0.750 x 10-3 m3/s. The output pressure of water…

Question

100%

Please answer the question seen in the picture below and choose the correct answer. thanks

The following figure shows the shape and dimensions of a small dam. Assuming the water level is at
top of the dam, find the total force on the face of the dam. NOTE: pg = 9800
45m
9n
O 17,860.500N
O 9,922.500N
O None of these.
O 89.302.500 N
O 396.900 N

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A sump pump (used to drain water from be basement of houses built below the water table) is draining a flooded basement at rate of 0.750 L/S, with an output pressure of 3.00105N/m2 . (a) The water enters a hose with a 3.00-cm inside diameter and rises 2.50 m above the pump. What is its pressure at this point? (b) The hose goes over the foundation wall, losing 0.500 m in height and widens to 4.00 cm in diameter. What is the pressure now? You may neglect frictional losses both parts of the problem.
Verigy that the SI of hpg is N/m2.
A large storage tank with an open top is filled to a height h0. The tank is punctured at a height h above the bottom of the tank (Fig. P15.39). Find an expression for how far from the tank the exiting stream lands. Figure P15.39
(a) How high will water rise in a glass capillary tube with a 0.500-mm radius? (b) How much gravitational potential energy does the water gain? (c) Discuss possible sources of this energy.
(a) What is the fluid speed in a fire hose with a 9.00-cm diameter carrying 80.0 L of water per second? (b) What is the flow rate in cubic meters per second? (c) Would your answers be different if salt water replaced the fresh water in the fire hose?
(a) What is the density of a woman who floats in freshwater with 4.00% of her volume above the surface? This could be measured by placing her in a tank with marks on the side to measure how much water she displaces when floating and when held under water (briefly). (b) What percent of her volume is above the surface when she floats in seawater?
Water emerges straight down from a faucet with a 1.80-cm diameter at a speed of 0.500 m/s. (Because of the construction of the faucet, there is no variation in speed across the stream.) (a) What is flow rate in cm3/s? (b) What is the diameter of the stream 0.200 m below the faucet? Neglect any effects due to surface tension.
The Huka Falls on the Waikato River is one of New Zealand's most visited natural tourist attractions. On average, the river has a flow rate of about 300,000 L/s. At be gorge, the river narrows to 20-m wide and averages 20-m deep. (a) What be average speed of the river in the gorge? (b) What is the average speed of the water in the river downstream of the falls when it widens to 60 m and its depth increases to an average of 40 m?
(a) Estimate the time it would take to a private swimming pool with a capacity of 80,000 L using a garden hose delivering 60 L/min. (b) How long would it take if you could divert a moderate size river, flowing at 5000 m3/s into pool?
Verify that the SI unit of hpg is N/m2.
Review. The tank in Figure P15.13 is filled with water of depth d = 2.00 m. At the bottom of one sidewall is a rectangular hatch of height h = 1.00 m and width w = 2.00 m that is hinged at the top of the hatch. (a) Determine the magnitude of the force the water exerts on the hatch. (b) Find the magnitude of the torque exerted by the water about the hinges.
What is the fluid speed a hose a 9.00-cm diameter 80.0 L of water per second? (b) What is the flow rate in cubic meters per second? (c) Would your answers be different if salt water replaced the fresh water in the fire hose?