The current shown in (Figure 1) is applied to a 400 nF capacitor. The initial voltage on the capacitor is zero. igure i (mA) Fordyr 10 20 30 40 50 60 70 50 0 50 < 1 of 1 > 1 (μs) Part A Find the charge on the capacitor att = 30 µs. Express your answer to three significant figures and include the appropriate units. q= Submit Previous Answers Request Answer Part B Value X Incorrect; Try Again; One attempt remaining V= Find the voltage on the capacitor at t = 50 µs. Express your answer to three significant figures and include the appropriate units. Part C Submit Value W = Units Request Answer Value Submit Request Answer ? Units How much energy is stored in the capacitor by this current? Express your answer to three significant figures and include the appropriate units. Units ? ?

Controlled variable is the output of a. Error Detector O b. Controller O c. Plant O d. None of the above

Elashing DC genretou solve in computer line

Draw communication block digram, and exlpain each element.

Categorize the level measurement sensors as point level measurement and continues level measurement.

Please answer the following question in detail.

Draw a diagram so that data is loaded parallel and then it is shifted from left to right instead of right to left. Be sure to mention where the data enters this register and where the data exits.

Please give the answer to this question correctly. Please give full solution with correct answer and make it very detailed.

Instruction [25-0] Jump address [31-0] Shift left 2 28 26 PC + 4 [31-28) Add ALU Add result Shift left 2/* RegDst Jump Branch MemRead MemtoReg ALUOP MemWrite ALUSrc RegWrite Instruction [31-26] Control Instruction (25-21] Read Read address register 1 Read PC Instruction [20-16] data 1 Read register 2 Instruction (31-0) Zero ALU ALU Address Read result Read Write register data 2 (1 M data Instruction memory Instruction [15-11]X Write data Registers Write Data data memory Instruction [15-0] 16 Sign- extend ALU control Instruction [5-0] Consider the above partially implemented MIPS datapath. Suppose that you are introducing a new instruction "LoadDirectAndJumpRelative $rt, ($rs), IMM" with RTL: REG[$rt] <-- {MEM[REG[$rs]], MEM[REG[$rs]+1], MEM[REG[$rs]+2], MEM[REG[$rs]+3]}; PC<-- PC + 4 + SiExt(IMM)<<2 Assuming that the appropriate control signals are available, what is the LEAST amount of additional multiplexer hardware needed to implement this instruction? This instruction cannot be…

HELP ME WITH THIS