The cross-section notes shown below are for a ground excavation for a 10m wide roadway. STA 23+4000 8.87 505 8.09 3.16 6 4 3 3.95 Determine the cross sectional area at STA 23+4000. Round your answer to 3 decimal places. Add your answer

The cross-section notes shown below are for a ground excavation for a 10m wide roadway. STA 23+4000 8.87 505 8.09 3.16 6 4 3 3.95 Determine the cross sectional area at STA 23+4000. Round your answer to 3 decimal places. Add your answer

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Draw the cross section of a 4 lane divided national highway with with unpaved shoulder on a plain…

A: Draw the cross section of a 4 lane divided national highway with with unpaved shoulder on a plain…

Q: Consider the following data for a proposed highway project: At station 10+500, the cross-sectional…

A: This is the standard procedure to followed during the survey for highway construction. for better…

Q: 1. A lot is divided into 10 squares of 10 m. on its side and the elevation at each corner is given…

A: NOTE - : Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Compute the volume between the two stations using prismoidal formula. Compute the volume between the…

Q: add the data for crown slope, tangent runout, and lane width: V = 80KM/H , lane width = 4m R =…

A: Question is based on the pavement design . Speed of vehicle, lane width , radius of curvature and…

Q: During the rough grading phase of construction, you discovered a 12-inch water pipe crossing the…

Q: The figure below shows the vertical offset from the proposed finished road level to the Natural…

Q: Situation VI: The profile of the ground surface along which the center line of the roadway is slopit…

Q: The cross-section notes shown below are for a ground excavation for a 9m wide roadway. STA 16+600…

Q: show the correct solution, don't short-cut the computation At STA. 51+33 of a proposed road, the…

Q: Question 7, The elevation at Station 4+13.88 is 351.07 feet. The grade at station 6+27.08 is 355.89…

A: The difference in Stationing of the two stations is to be found. Then using the definition of…

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 20+8200…

Q: Describe about the generalized method for slice analysis of noncircular slip surfaces advanced by…

A: The Janbu’s generalized method deals with slope stability or stability of the structure. It is very…

Q: which will be excavated for a roadway having a ba of ten meters: Station Station 116 154 10+ 10+ 3.0…

Q: A roadway section is 2000 ft long (20 stations). The cut and fill volumes are to be computed between…

A: Excavation and excavation are also called excavation and embankment. In this process, the excavator…

Q: 2. What is the most economical design slope angle for a very long uniform slope cutting H=10 m in a…

A: Consider the given data H=10 mφ'=25oru=0.4c'YH=140 =0.025Cost=$2 /m3Reparing…

Q: The cut and fill areas for the cross-sections at five stations along the centerline of a highway…

A: The given data is shown below:

Q: St. No. A B с D E F G H A series levelling had been down along the centre line of the proposed road…

Q: .Determine coefficient of bending for the three sections. (Cb1, Cb2 and Cb3) 7.Design based on…

A: Solution

Q: The cross-section notes shown below are for a ground excavation for a 8m wide roadway. STA 23+500…

Q: A 120mx120m lot is divided into 9 equal sections. Find the volume (m3) to be excavated if the ground…

A: The following sketch shows the figure of the sections and corner points.

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 23+8500…

A: To Determine the cross sectional area at STA 23+8500.

Q: 39. Calculate the total fill volume (yd³) for the segment from 22+00 to 23+00

A: Answer we are given Area of fill at STA 22+00 = 6 ft2 Area of fill at STA 23+00 = 4 ft2 shrinkage…

Q: A lot is divided into 20m horizontally (A-B-C-D), and 30m vertically (I-II-III). The ground…

A: Civil surveying is critical to the success of many construction projects, including residential and…

Q: can you please explain how you determine flw adjustment for lane width=1.9? how did you get 1.9…

A: Reference : HCM Highway Capacity Manual 2000 All tables are referred from HCM 2000 Note : We are not…

Q: Calculate the amount of earthwork for the cut and fill section between (42+00) and (42+40) stations,…

Q: b) The following road grading plan has a 5% slope going downward to the south, a 3" tangential…

A: FINDdraw 64' and 65' contours

Q: The given data of a proposed Manila-Cavite Coastal Road is tabulated below. The tree ha istance is…

A: The given data is: Hall distance=50 m Cost of borrow=420 php/m3 Cost of excavation=350 php/m3 Cost…

Q: 5.0M 5.0M 5.0OM5.0M 5.0M_5.0M__5.0M_| 5.0M5.0M 5.OM 5.0M5.0M 1. Find the area of the cross-section…

A: Given offsets measured of field and it is asked to find the area using : 1. Offsets from a straight…

Q: A series levelling had been down along the centre line of the proposed road the distance between…

A: Leveling is defined as the process of calculating the reduced level of a point either on earth or…

Q: The given data of a proposed road is tabulated below. The free haul distance is 50m and the cost of…

A: The volume of the overhauled material is measured by multiplying the overhaul distance by the cubic…

Q: For a flow of 1500 liters of water per second through a circular channel of 2 m diameter flowing…

Q: A confined space. A trench can't be classified as a O True False

A: The confined space are those which have limited and restricted means of exit and entry. For…

Q: The following are section notes of a five-level section Station 1+ 125 ? 12.0 -5.3,- -4.0'-8.80 10.0…

Q: From the following cross-s end-area method, the roa slope for both cut and fill i 5.04

Q: A-1.10% grade meets a +0.60% grade at station 36+00 and elevation 800.00 ft. The +0.60 grade then…

A: The station of the intersection of grades -1.10% & +0.60% = 36+00The elevation of the…

Q: Q2: - A factory is to be built on a ground having following elevation and the area bounded by each…

Q: Q5. As a civil engineer, you have been assign to prepare earthwork cost estimation for a proposed…

A: Mass haul diagram A mass haul diagram properly include Haul: The transportation of your project's…

Q: You have been instructed to join two existing roads by an even grade from point X to Y. Point X is a…

A: Given data:

Q: Field measurements were taken along a proposed roadway alignment. The cross sections at the start of…

A: Answer (37) We are given Area of cut at STA 21+70 = 9 ft2 Area of cut at STA 22+00 = 9 ft2…

Concept explainers

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.

Question

The cross-section notes shown below are for a ground excavation for a 10m wide roadway.
STA 23+4000
8.87 505 8.09
3.16 6 4 3 3.95
Determine the cross sectional area at STA 23+4000.
Round your answer to 3 decimal places.
Add your answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Measuring sitework, excavation and piling

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

7 please give the correct ans and the solution
solve the question and please show complete solution.
I will rate your answer immediately
St. No. A B al C D E F G H A series levelling had been down along the centre line of the proposed road the distance between each two points (100m). If the elevation of the points A, E and H after completing the project should be 31m, 30m, and 31.5m respectively and these three points connected with straight lines having uniform gradient. Calculate the depth of .cut and fill for the points C and G BS 1.25 1.78 1.91 IS 2.18 1.86 1.61 1.43 FS 1.93 1.27 2.7 Remark B.M-30.09 -0.57m, 0.48m -1.63m, -1.45m 0.54m, -1.37m -1.96m, -0.88m -1.73m, -1.92m -0.97m, -0.48m
The cross-section notes shown below are for a ground excavation for a 9m wide roadway. STA 22+400 6.89 0 7.54 6.85 7.45 6.74 Determine the cross sectional area at STA 22+400. Round your answer to 3 decimal places.
The ground line slopes uniformly at -5.5% from station 40 + 310, which has a center height of 4.50 m cut, to station 40 + 390, which has a center height of 2.60 m fill. Assuming both sections to be level sections with side slopes 1.5:1 for fill and 2:1 for cut. Will the volume between these sections be borrowed or wasted if the roadway for fill is 10 m and for cut is 9 m? Show your centerline profile.
Please show detailed solution. Thank youu
Consider the three level sections shown in Table 1. If the width of the road, b=12 m, calculate the slope of the side slopes of the sections. If the combined volume of the given sections has been calculated using the Average End Area method and is given as 250494 m3, correct this volume using the prismoidal volume correction formula.
5
Calculate Ve, Cp and Vp for the following notes. The base in fill is 20 ft and the base in cut is 30 ft.
A 7000 meters long and 8 meters wide road is to be constructed in a remote region. Cut and fill are necessary where there is a poor subgrade soil. Four bulldozers excavated the poor subgrade soils. The dimensions of the excavated trench were 0.8 m deep by 10 meter wide and 3.5 kilometers long. The road will have 100 mm aggregate base and 50 mm of asphalt thickness. A bulldozer displaced 115 m3\day, at a rate of 100 cedis per day. A laterite soil will be used in the fill operation. The fill operation will need a grader, a vibratory roller and a water truck for 20 days each at a cost of 130 cedis, 138 cedis and 68 cedis respectively. Daily labor rates for this excavation operation is a foreman, 30 cedis, five laborers, 15 cedis each. Truck driver, 21 Cedis and grade checker, 26 Cedis. Daily labor rates for the fill operations are the same as the excavation rates. One forman, ten laborers and a truck driver will be employed for the fill operations. Grading and asphalt laying will…
Determine the cross sectional area for a 9m wide roadway at Sta 12+198 using the given cross section notes in the image: