show the correct solution, don't short-cut the computation At STA. 51+33 of a proposed road, the center height of the cross- sectional area is 1.4m in fill while the center height of the cross- sectional area at STA 51+93 2.8m in cut. The width of the proposed  road is 14m with a required side slope of 2H:1V for both cut and fill. Determine the volume of cut and the volume for fill using the END-AREA Method. (All sections are level sections)

Q: The cross section at station 2+60 has a cut area of 9 ft² and a fill area of 4 ft² and the cross…

A: Chainage of first station = 2+60 = 260 ft Area of cut = 9 ft2        Area of fill = 4 ft2  Chainage…

Q: 7. From the following cross-section notes for a road grading work. -3.2 +1.2 +1.2 +2.8 X1 3.5 X2 The…

A:

Q: The grade elevation at station 31+89 is 426.70 ft. The grade along the route between station 31+89…

A:

Q: The figure below shows the vertical offset from the proposed finished road level to the Natural…

A:

Q: Situation VI: The profile of the ground surface along which the center line of the roadway is slopit…

A:

Q: Q2) Find side width and area of a cross-section for cut and fill section on surface hill with slope…

A:

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 20+8200…

A:

Q: St. No. A B с D E F G H A series levelling had been down along the centre line of the proposed road…

A:

Q: PROBLEM 2: From station 0 + 040 with center height of 1.2 m. fillI, the ground line makes a uniform…

A:

Q: Calculate the quantity of earthwork for the construction of an approach road? Length = 1Km Width of…

A: Width of formation = 10 mLength = 1km = 1000 mHeight of embankment = 60 cm = 0.6 mSide slope =…

Q: The center height of the (finished) road at the station 0+050 is 2.93 m fill; while at station 0+180…

A: To determine: a) Compute the value of slope of finished road b) Compute the Stationing of the point…

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 23+8500…

A: To Determine the cross sectional area at STA 23+8500.

Q: Describe the conveyance-slope method of extrapolation of a rating curve with the help of a diagram.

A: Extrapolation of rating curve becomes necessary as range of gauging used does not cover entire range…

Q: Determine the volume using End-Area Method. Determine the volume using Prismoidal Method.

A: The area of 3 level cross section is determine by following equation,                  A =…

Q: The center height of the road at station 5+280 is 4.50 m cut while at a station 5+400 is 2.40 m…

A:

Q: A series levelling had been down along the centre line of the proposed road the distance between…

A:

Q: Describe about the Basis of slope stability analysis by method of slices.

A: Slope stability analysis is a method of determining the stability of earth and rock-fill dams,…

Q: What is the Richardson/Businger Gradient Number?

A: Richardson/Businger Gradient Number is:

Q: rigure Q3 shows the cross section of an existing road in a flat rural area. a) Briefly explain the…

A:

Q: Calculate the area between the sidewalk/proposed surface and the existing surface shown by the…

A:

Q: A series levelling had been down along the centre line of the proposed road the distance between…

A: St.No BS IS FS HI RL Remarks Elevation After Completion Cut/ Fill     A…

Q: H.W: - A profile of a road where grade elevation starts with (25.00 m) at stat. (12+00) and an…

A: Given data, Station 12+00 13+50 14+00 16+00 Ground elevation (m) 29.20 28.00 25.80 27.40…

Q: +3 13.5 a 5+-020 +4.5 17.25 of the road is 12 m and the slide slope is 2.5:1 te the volume using end…

A:

Q: The ground line slopes uniformly at -5.5% from station 40 + 310, which has a center height of 4.50 m…

A:

Q: certain grade. At station 5+100 the ished roadway slopes upward produ ation 5+550. The stationing of…

A:

Q: Determine the cross sectional area for a 9m wide roadway at Sta 12+198 using the given cross section…

A:

Q: From station 95 + 220 with center height of 4.50 m cut, the ground line makes a uniform slope of -6%…

A:

Q: As shown in the figure below, a horizontal alignment consists of two tangent lines smoothened by a…

A: Given:Station PC is at 20+30.00Station PT  is at 24+00.00Super elevation = 210 ft

Q: Calculate the amount of earthwork for the cut and fill section between (42+00) and (42+40) stations,…

A:

Q: Prepare a Grade Sheet for top-of-curb cut and fill only using the following information. Centreline…

A: Road width-12m curb face-16 cmGradient to bottom of curb-2.2%Centereline elevation- 107.560 m

Q: The areas in cut of two irregular sections 65 meters apart are 36m2 and 72m2 respectively. Base…

A:

Q: Question 2. Below shown is the profile for a road construction at a station. This is a fill section.…

A: Find: Fill section area

Q: At STA. 51+33 of a proposed road, the center height of the crosssectional area is 1.4m in fill…

A: Sta 1 = 51+33 Sta 2 = 51+93 Side slope is 2H:1V h1 = 1.4m (fill) at station 1 h2 = 2.8 m (cut) at…

Q: 2. A road section to be laid out passes through a hilly terrain illustrated below. The section in…

A:

Q: The figure below shows the vertical offset from the proposed finished road level to the Natural…

A:

Q: Problem 1 Given: A = 9.584 acre, C = 0.2 for heavily wooded area and I= 3.3 in/hr.   Design a…

A: Step 1:Step 2:Step 3:Step 4:

Volumes

Volume usually is the dimensional quantity that involves the evaluation of any three-dimensional figure enfolded inside a closed space. The SI unit (International System of Units) of volume is m3 and the dimensional unit of volume is [L3]. For estimation of the volume of any figure, various formulae are used. Another application of volume includes the reference in the sound levels, the higher the sound intensity, the louder the sound heard, and hence, the larger the volume. The SI unit of sound volume is decibels (dB).