The Country Fields Retirement Community charges $6000/month for a single senior citizen to reside in an efficiency apartment with assisted living care The facility has operating expenses of 3000,000 per month. Staffing levels are dependent on the number of residents. Each senior who enters the community requires additional food, personal care, and support staff time. The estimated cost for each person $4000 per person per month. (a) How many senior citizen residents does the facil ity need to have in order to reach the breakeven point? (b) What is the company's annual profit or loss if they maintain an average residency level of 350 senior citizens? Contributed by Gillian Nicholls, Southeast Missouri State University

Hello Sir,Good Evening. I have a question in my homework realated geometry tolerance lesson. The following below is my question. Please advice thank you. "What is the difference between position tolerance and orientation tolerance?"

Generate isometric drawing from multiviews using drawing tools or free - hand. Use approximate proportionate dimensions. Use plane sheet to draw or sketch isometric drawing.

To which of the following geometric tolerance families does perpendicularly belong?     Form Tolerance.     Location tolerance.     Profile tolerance.     Orientation tolerance

Jensen Figure 6-71 Sketch 3 orthographic projections (i.e. top, front, right). Draw them on 10x10 cross section graph paper. - On each of the projections, label the inclined surface shown with its appropriate letter. - Identify if it is showing in first-angle projection or third-angle projection. b) a) K K Fig. 6-71 Sketching assignment 16.

1. What revision is this part on? 2. How many dimensions are expressed using the limit method? 3.  What is the surface texture in microinches is specified for the cylinder surface with a maximum material condition of 1.250"? Leave out the units, it is microinches, just type the number.  Thanks :)!

When do the actual dimensions occur?

! (asap)

a) Name two groups of standards in addition to national, industry-wide standards and where they are valid. b) Which three options exist for defining dimensional tolerances in a technical drawing?

hand written plz Answer the following questions using the information provided in this unit. Know and Understand 1. True or False? The primary purpose of section views is to help feature exterior detail without using hidden lines. For the next three terms, match the three types of lines to the three descriptions. Answers are used only once. 2. Cutting-plane line 3. Section line 4. Short break line A. Not exclusive to section views, but needed for broken- out sections. B. Drawn thick in a view adjacent to the section view. C. Drawn thin, and usually continuous, but sometimes dashed. 5. Of the following, which is not a type of section view featured in this unit? A. Full B. Half C. Quarter D. Offset 6. True or False? The preferred dividing line between the two halves of a half-section view is the visible line. 7. An object with a number of odd features, such as spokes or holes, often has a(n) section so the odd features can be rotated around the axis into a vertical cutting plane,…