The analysis of a flue gas from a fuel gas containing no nitrogen is 4.62% CO2, 3.08% CO, 8.91% O2, and 83.39% N2. Calculate the following: (a) Moles of dry air supplied per mole of dry flue gas (b) Percent excess air if, all the fuel is burned (c) The amount of net hydrogen burned per mole of dry flue gas

Q: Determine the energy and hydraulic grade lines for the following system 0.37 m 0.08-m diameter Free ...

A: Given d1=0.08m d2=0.05m h2=0.37m Find Energy grade line(EGL) and hydraulic grade line(HGL)

Q: Hydrofluoric acid, HF(aq), cannot be stored in glass bottles because compounds called silicates in t...

A: Given, moles of HF= 9 moles From the reaction, 4 moles of HF will produce 1 Mole of NaF moles of NaF...

Q: An experiment is conducted to determine the variation of the diffusion coefficient as a function of ...

A: Given that Temp (c ) D (m2/s ) 141 5.7 x 10-12 580 2.9 x 10-10  

Q: Two formulas for the heat capacity of CO are given here: C,(cal(mol-"C)] = 6.890 + 0.0014367("C) C,(...

A: Given that V Cp[cal/(mol·°C)]=6.890+0.001436T(°C)  

Q: A fuel containing 80% CH4 and 20% C2H6 is burned with dry air. Sixty percent of the carbon burned go...

A:

Q: The experimental Molecular Weight of benzene obtained in one of our class experiments is 77.9924. wh...

A:

Q: 4-20. A BTX unit, shown in Figure 4.20, is associated with a refinery that produces benzene, toluene...

A: Given that, The volumetric flow rate of stream 1 V1 = 10 m3h The concentration of benzene in stream ...

Q: For the following reaction, 126 grams of silver nitrate are allowed to react with 28.4 grams of copp...

A: Note: We are authorized to answer one question at a time, since you have not mentioned which questio...

Q: A dilute solution of acetic acid produced by fermentation and oxidation of natural carbohydrates is ...

A: following values are given in the question mass of acetic acid(m1)=47.5 g mass of water(m2)=65.8 g A...

Q: Hazard and Operability Analysis (HAZOP) is a structured and systematic technique for system examinat...

A: Introduction A HAZOP (Hazard And Operability Study) is a structured and systematic examination of a ...

Q: OSHA (Occupational Safety and Health Administration) has established limits for the storage of vario...

A: Given: The limit for the storage of acetaldehyde is (m1) 113.0 kg maximum and for ethanol is (m2) 17...

Q: The composition of Liquefied Petroleum Gas (LPG) is 0.5% ethane, 0.1 % acetylene, 16.4% propane, 2.1...

A: Given composition of LPG in mole fraction as, ethane=0.005,  acetylene=0.001 propane=0.164 ethylene=...

Q: Carbon is to be diffused into iron with an initial C concentration of 0.25 wt% at 763 °C. If the sur...

A: Given that Initial Concentration,Co = 0.25 Wt % surface  Concentration,Cs = 1.5 Wt % x = 0.9 mm t = ...

Q: It is desired to reduce the 2% CO, in 23 Ib/sec of a natural gas stream using absorption in aqueous ...

A: Absorption using diethylamine is used to reduce the CO2 concentration from the natural gas.  Natural...

Q: Nickel ion (Ni") and hydroxide (OH) are in equilibrium with solid Ni(OH)2 in a 1-Liter solution that...

A: Ni(OH)2↔ Ni +2 + 2 OH-1                     x mol/L   2x mol/lit At equilibrium ,     Ksp=(Ni+2) (OH...

Q: A gaseous stream with a molar flow of 299 mol / h contains 58% A and the rest of B. This stream join...

A: The ideal gas states that, PV=nRT. Here, P is the absolute pressure in atm, V is the volume in litre...

Q: For the following reaction, 0.335 moles of carbon (graphite) are mixed with 0.358 moles of oxygen ga...

A: 1-Given  Moles of carbon = 0.335 mole  Moles of oxygen = 0.358 mole  Chemical reaction is  Carbon ...

Q: An equimolar mixture of methane and ethane is burned with dry air. Because of a faulty jet, only 50%...

A: In a combustion process, the fuel containing organic material is oxidized. Depending on the atoms pr...

Q: For the following reaction, 118 grams of perchloric acid (HCIO4) are allowed to react with 32.3 gram...

A: Given the reaction To find 1) maximum amount of phosphoric acid that can be formed 2) formula for l...

Q: A combustion engine has been made to use a mixture of liquid hydrogen and liquid oxygen as a fuel wh...

A: Given data: Length of tube = 1 m  Diameter of tube = 0.8 m Flow rate of exhaust gas = 72 kg/s Conver...

Q: A flue gas is analyzed to contain (dry basis): 11.6% CO2, 6.8% O2, 0.5% CO and leaves the boiler at ...

A: Given information

Q: The most widely used low explosives are ___________and ___________.

A: The most widely used low explosives are to be mentioned.

Q: A gas mixture composing of 40% methane and 60% butane enters a ½-in ID pipe at 120°C and 1.2atm at a...

A: Given data: Composition of mixture is, Methane = 40 % Butane = 60 % Internal diameter of pipe = 1/2 ...

Q: ment 1 1. . For flowing water, what is the magnitude of the velocity gradient needed to produce a sS...

A: Given that  shear stress =  1N/m2 Viscosity, u = 1.12 x 10-3kg/ms We have to find velocity gradient ...

Q: Strawberries contain about 15 wt. % solids and 85 wt. % water. To make strawberry jam, crushed straw...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: If moist hydrogen containing 5% water by volume is burnt completely with 34% excess air, calculate t...

A:

Q: Assume the validity of the De Priester charts, make the following VLE calculations for ethane (1)/ ...

A: Given that ethane 1 propane 2 isobutene (3) isopentane (4) BUBL T, given x1 = 0.27, x2 = 0.33, x3 = ...

Q: A triple effect evaporator concentrates a sugar solution from 12% sugar to 60% sugar. Assuming that ...

A: Let F=1000kgh

Q: gas expands from an initial volume of 0.2 m to a final volume of steady flow process. During the pro...

A: Given V1=0.2 m3 V2=0.4 m3  Z=4 m Internal energy change=30 kJ Pressure varies with volume as P=5×1...

Q: A gas mixture composing of forty percent methane and sixty percent butane enters 1/2-in ID pipe at 1...

A: The gas mixture contains 40% methane and 60% butane. Let A be methane and B be butane. Molecular wei...

Q: QUESTION 1 The production of molten copper(1) sulfide is an important step in the making of copper. ...

A: Given: A furnace contains mCu2S = 200 t at temperature T = 1200oC Mass of copper scrap (i.e. solid c...

Q: An ideal gas is expanded adiabatically into a vacuum. Decide which of q, w, AU, and AH are positive,...

A: GIven that an ideal gas is expanded adiabatically into a vacuum we have to find the value of q,w and...

Q: 3. Using the truncated viral equation of state given below, nRT n°RTB(T) P =- V?

A:  

Q: Hydrogen gas is typically purified by diffusion through a palladium sheet. Compute the concentration...

A:

Q: Enthalpy is related to internal energy by

A: Given that  We have to find the relation between enthalpy (H)  and internal energy (U)    

Q: Q4. 1) The flow around a corner makes the edges of the expansion fan indicated by the angles as show...

A:

Q: You are tasked with designing a separator to remove HCl from a gas stream. The feed gas is comprised...

A: Given, the process is a separator in which HCl is separated from the feed stream. One of the streams...

Q: A vapor mixture analyzes 60% heptane, 28% octane and 12% benzene by volume. At 50°C, the mixture is ...

A: Given that, The mole fraction of heptane in vapor mixture y1 = 0.6 The mole fraction of octane in va...

Q: A truncated solid aluminium cone of circular cross section area, has a diameter given byD = ax3/2 Th...

A: Let us first take a small cross section of the cone across which we will perform our calculation. Gi...

Q: An equimolar mixture of methane and ethane is burned with dry air. Because of a faulty jet, only 50%...

A: Given that: Ethne and ,methane are in equimolar mixture. Supposed that, basis feed= 100 mol Ethane (...

Q: In the usual laboratory experiment, the tea extract is being washed with three separate portions of ...

A: One of the important techniques that is used in the separation of desired components from a solvent ...

Q: Wet wood chips are dried in a continuous rotary dryer that operates at atmospheric pressure. The chi...

A: Given data: Wet wood chips are dried in continuous rotary dryer at atmospheric pressure the chips en...

Q: Gas Absorption

A: Absorption involved with gas in the mixture is mostly done in vertical columns. This system follows ...

Q: Producer gas analyzing 25.3% CO, 13.2% H2, 0.4% CH4, 5.4% CO2, 0.5%O2, and 55.2% N2 is burned in exc...

A: Basis: 100 mol of producer gas (fuel) The number of moles of CO in the fuel nCO,f = 25.3 mol The num...

Q: A frictionless cylinder-piston device contains 150 L of oxygen at 100 KPa, 25°C. The oxygen is now c...

A: Disclaimer: Since you have posted a question with multiple sub-parts, we will solve first three sub-...

Q: a) Calculate the entering concentration (mol/ dm³) of B b) Calculate the concentration of A and C (m...

A: Given  that   elementary gas reaction 4A + 2B → 2C  isothermally in a PFR with no pressure drop. The...

Q: This section in a Safety Data Sheet contains information on the emergency contact information of the...

A:

Q: How much work must be input by the paddle wheel below to raise the piston 5 cm. The initial temperat...

A:

Q: A spherical tank of outer diameter Do = 1.5 m fabricated with t= 9.5 mm thick aluminum (kal = %3D 24...

A: Given that, Outer diameter Do = 1.5 m Outer radius ro = Do2 = 1.52 = 0.75 m Thickness t = 9.5 mm = 0...

Q: Air inside a chamber is heated from an initial volume and pressure

A: